USGS2024
Introduction Lahars, or debris flows that originate from a volcano (Pierson and Scott, 1985; Pierson, 1995), are among the most destructive, far-reaching, and persistent hazards on stratovolcanoes. Lahars may be triggered by syneruptive rapid melting of snow and ice, lake breakouts, or heavy rains in conjunction with large eruptive columns. Alternatively, lahars can follow eruptions, when clastic deposits are mobilized by heavy rainfall or lake breakouts, occurring sporadically for years to decades after large eruptions. Some lahars can travel many tens of kilometers in river drainages stemming from volcanoes, as during the 1980 eruption of Mount St. Helens (Washington) (for example, Janda and others, 1981), recent eruptions of Redoubt Volcano (Alaska) (fig. H1; Dorava and Meyer, 1994; Waythomas and others, 2013), and the 1991 eruption of Mount Pinatubo (Philippines) (Major and others, 1996; Pierson and others, 1996). Large lahars are less likely in the absence of eruptive activity, but still possible. The Electron Mudflow at Mount Rainier (approximately A.D. 1500), Wash., is an example of a potential noneruptive lahar, likely initiated by a spontaneous collapse of weak rock, that reached the Puget Lowland after it flowed dozens of kilometers without a recognized eruptive trigger (Sisson and Vallance, 2009). The extreme hazard posed by lahars was demonstrated tragically by the 1985 Nevado del Ruiz (Colombia) catastrophe that claimed the lives of more than 20,000 people (Naranjo and others, 1986). The potential to provide warnings of minutes to hours in advance of lahar arrival in a populated area (for example, Voight, 1990) is a strong reason to provide special monitoring attention to the hazard. Populated river valleys are located downstream from many very high threat and high threat volcanoes, and these areas could be affected by lahars (for example, Hoblitt and others, 1998). The volume and mobility of lahars are two characteristics that can influence the extent of downstream effects (for example, George and others, 2022). The flows that reach the farthest downstream are mobile and voluminous. Additionally, entrainment of material as a lahar travels downstream may increase the volume, and a lahar that starts small may grow to a destructive size under certain conditions. Increasingly, stratovolcanoes host recreational enthusiasts who could be affected by relatively localized geologic hazards, such as rainfall-induced debris flows, glacial outburst floods, rockfalls, and avalanches. These types of events can be common on many volcanoes, occurring seasonally in the case of debris flows and several times per year in the case of avalanches and rockfalls (for example, Allstadt and others, 2018). Many very high threat stratovolcanoes, especially within the contiguous United States, have low eruption frequencies (less than once per century), such that monitoring networks could be used more often for detection and characterization of small surface flows than for identification of volcanic unrest. Such information can be used to validate avalanche forecasts, inform rescue efforts, or notify other agencies of potentially damaged infrastructure (for example, roads, powerlines, or trails). Note that although many of these smaller surface flows create seismic and infrasound waves, the signals are typically highly distorted by the complex volcanic topography and geology. In general, the smaller the flow, the weaker the geophysical signals that it generates, and thus a denser geophysical network is required to study smaller flows (for example, Allstadt and others, 2018). Lahar detection may not be an appropriate or necessary monitoring capability for all volcanoes. Some very high threat volcanoes, like Kīlauea and Mauna Loa, have no lahar hazards currently, and thus no detection, tracking, and characterization capabilities for lahars are needed. At other very high threat volcanoes, such as Pavlof Volcano, Alaska, lahars might be common but pose minimal threat because the volcano is so remote. Ideally, the local observatory would understand the combination of hazard and risk associated with surface flows and assign monitoring and detection capabilities appropriately. Several volcano monitoring techniques (for example, Real-Time Seismic Amplitude Measurement [RSAM], amplitude-based locations, and infrasound array processing) can be adapted to also detect, characterize, and track debris flows, lahars, and other surface flows, so instrumentation installed for detecting volcanic unrest and eruptions can have multiple purposes. The utility of instrumentation for the purpose of monitoring unrest and lahars further justifies the importance and utility of a dense network of monitoring stations, even if the volcano remains quiescent.
Scientific Investigations Report↗