Geology topics

Samuel Johnstone

Publications and source records attributed to Samuel Johnstone.

22 records · Page 2Linked to original sources

USGS2018

Establishing chronologies for alluvial-fan sequences with analysis of high-resolution topographic data: San Luis Valley, Colorado, USA

On active alluvial fans, debris-flow deposits and frequent avulsions produce a rough topographic surface. As is the case in many initially rough landforms produced by catastrophic processes, the topography of alluvial fans is progressively smoothed, producing textural differences useful in establishing relative age criteria for fans. Here, we outline an approach for defining a quantitative, numerical chronology for the surfaces of alluvial fans from topographic analysis, although the method is generalizable to any arbitrary landform. Our chronology relies on predictions for the evolution of topography by purely diffusive modification. Specifically, by comparing the surface roughness of active and abandoned alluvial-fan surfaces measured from spectral transformations of topography, we can directly estimate a fan’s “morphologic age,” which is the product of the duration and efficiency of diffusive modification by surface processes. We tested the method on a suite of alluvial fans in the San Luis Valley, Colorado, USA, and evaluated the results against field observations and available geochronologic data. Estimated morphologic ages obey stratigraphic constraints and imply reasonable efficiencies of sediment transport. We highlight the fact that the oldest fan surfaces observed here, constrained to be older than 100 ka by U-series dating of pedogenic carbonates, have morphologic ages near the method’s saturation point. In addition, many fans have morphologies that are not entirely consistent with a purely diffusive modification from the initial fan morphology recorded on active fan surfaces, likely as a result of postdepositional modification by sediment transport driven by wind and overland flow. However, we remain optimistic that morphologic dating can provide useful insights into the history of alluvial-fan activity, in particular, because our method provides a means for both computing a morphologic age and assessing the validity of the assumptions required for that computation from analysis of topography alone.

California↗

USGS2018

Interpretation of low‐temperature thermochronometer ages from tilted normal fault blocks

Low‐temperature thermochronometry is widely used to measure the timing and rate of slip on normal faults. Rates are often derived from suites of footwall thermochronometer samples, but regression of age vs. structural depth fails to account for the trajectories of samples during fault slip. We demonstrate that in rotating fault blocks, regression of age‐depth data is susceptible to significant errors (>10%) in the identification of the initiation and rate of faulting. Advection of heat and topographic growth influence the thermal histories of exhumed particles, but for a range of geologically reasonable fault geometries and rates these effects produce Apatite (U‐Th)/He ages comparable to those derived from rotation through fixed isotherms. We apply the fixed‐isotherm model to published data from the Pine Forest Range and the East Range, Nevada, by incorporating field and thermochronologic constraints into a Markov chain Monte Carlo model. Modeled parameters for the Pine Forest Range are described by narrow ranges of geologically reasonable values. Compared to slip rates of 0.3‐0.8 km/Myr and an inititation of faulting ca. 11‐12 Ma derived from visual inspection, the model predicts an average slip rate of ~1.1 km/Myr and an onset of faulting ca. 9‐10 Ma. For the East Range fault block the model suggests faulting begain ~17 Ma with an extension rate of ~3 km/Myr and slowed to an extension rate of ~0.5 km/Myr at ~14 Ma. The absence of a preserved partial retention zone in the East Range sample set limits how well the model can predict fault block geometry.

Tectonics↗

USGS2018

Controls on submarine channel-modifying processes identified through morphometric scaling relationships

Submarine channels share morphological similarities with rivers, but observations from modern and ancient systems indicate they are formed under processes and controls unique to submarine settings. Morphologic characteristics of channels—e.g., width, depth, slope, and the relationships among them—can constrain interpretations of channel-forming processes. This work uses morphometric scaling relationships extracted from high-resolution seafloor bathymetry to infer connections between morphology and process in submarine channels. Analysis of 36 modern channels in five geographic regions shows that channel widths vary regionally (from <100 m to >10 km wide) but occupy the same range of aspect ratios (~10:1–100:1). This suggests an autogenic control on aspect ratio, perhaps resulting from feedback processes in levee growth and/or bank erosion, and allogenic (e.g., sediment supply, grain size) controls on channel width. Submarine channel aspect ratios tend to decrease with increasing dimensions, while the opposite relationship has been observed for fluvial channels, likely due to opposing relationships between flow discharge and channel distance. Additionally, observation of an apparent lag between channel thalweg and levee responses to gradient changes suggests that thalweg and levee deposition and erosion may be partially decoupled due to the vertical structure of turbidity currents, with thalweg evolution driven by the basal, higher-shear-stress portion of the flow and levee evolution by the dilute upper portion. The data presented here provide a basis for predicting channel metrics in exploration scenarios, in which data coverage may be sparse. This documentation of a diverse suite of channels also captures the range of scales and variability exhibited globally by submarine channel systems, providing context for local studies.

Geosphere↗

USGS2017

Sediment unmixing using detrital geochronology

Sediment mixing within sediment routing systems can exert a strong influence on the preservation of provenance signals that yield insight into the influence of environmental forcings (e.g., tectonism, climate) on the earth’s surface. Here we discuss two approaches to unmixing detrital geochronologic data in an effort to characterize complex changes in the sedimentary record. First we summarize ‘top-down’ mixing, which has been successfully employed in the past to characterize the different fractions of prescribed source distributions (‘parents’) that characterize a derived sample or set of samples (‘daughters’). Second we propose the use of ‘bottom-up’ methods, previously used primarily for grain size distributions, to model parent distributions and the abundances of these parents within a set of daughters. We demonstrate the utility of both top-down and bottom-up approaches to unmixing detrital geochronologic data within a well-constrained sediment routing system in central California. Use of a variety of goodness-of-fit metrics in top-down modeling reveals the importance of considering the range of allowable mixtures over any single best-fit mixture calculation. Bottom-up modeling of 12 daughter samples from beaches and submarine canyons yields modeled parent distributions that are remarkably similar to those expected from the geologic context of the sediment-routing system. In general, mixture modeling has potential to supplement more widely applied approaches in comparing detrital geochronologic data by casting differences between samples as differing proportions of geologically meaningful end-member provenance categories.

Earth and Planetary Science Letters↗