Geology topics

S. Spottiswoode

Publications and source records attributed to S. Spottiswoode.

3 recordsLinked to original sources

USGS2012

Comparison of ground motion from tremors and explosions in deep gold mines

Seismic body waves, from tamped chemical explosions, two with yields of 50 and one of 150 kg, were compared with corresponding data from three mining-induced tremors with a view to testing methods of discriminating between the two types of events. Detonated at depths of about 2 km, all three explosions generated P waves for which the low-frequency spectral asymptotes agree well with corresponding results scaled down from nuclear shots at the Nevada Test Site. For the two smaller explosions, recorded underground at hypocentral distances ranging from 234 to 871 m, the P wave corner frequencies, defined by the intersections of the low- and high-frequency asymptotes, are also in fine agreement with scaled-down results from the Nevada Test Site; for the 150-kg explosion, which was recorded only at the surface, it appears that 2.39 km of upward propagation caused the corner frequency to be at least a factor of 4 lower than anticipated due to attenuation. All three explosions generated S waves that appear to be a consequence of deviatoric stress release in the immediate environs of the explosions. The three tremors analyzed here generated P and S waves whose spectra and source parameters agree well with standard earthquake source models. With regard to discrimination based on P wave spectra, we conclude that for events of fixed low-frequency spectral asymptotes, the explosions typically have higher corner frequencies than tremors or earthquakes, although counterexamples certainly exist. Interestingly, the 150-kg explosion was identified as such on the basis of P and S wave polarities that are incompatible with the normally expected double-couple source model; instead, these initial motions are consistent with an explosion in conjunction with normal faulting. The body wave spectra of this explosion and those of a nearby tremor, however, were indistinguishable.

Journal of Geophysical Research Solid Earth↗

USGS2009

Broadband records of earthquakes in deep gold mines and a comparison with results from SAFOD, California

For one week during September 2007, we deployed a temporary network of field recorders and accelerometers at four sites within two deep, seismically active mines. The ground-motion data, recorded at 200 samples/sec, are well suited to determining source and ground-motion parameters for the mining-induced earthquakes within and adjacent to our network. Four earthquakes with magnitudes close to 2 were recorded with high signal/noise at all four sites. Analysis of seismic moments and peak velocities, in conjunction with the results of laboratory stick-slip friction experiments, were used to estimate source processes that are key to understanding source physics and to assessing underground seismic hazard. The maximum displacements on the rupture surfaces can be estimated from the parameter , where is the peak ground velocity at a given recording site, and R is the hypocentral distance. For each earthquake, the maximum slip and seismic moment can be combined with results from laboratory friction experiments to estimate the maximum slip rate within the rupture zone. Analysis of the four M 2 earthquakes recorded during our deployment and one of special interest recorded by the in-mine seismic network in 2004 revealed maximum slips ranging from 4 to 27 mm and maximum slip rates from 1.1 to 6.3 m/sec. Applying the same analyses to an M 2.1 earthquake within a cluster of repeating earthquakes near the San Andreas Fault Observatory at Depth site, California, yielded similar results for maximum slip and slip rate, 14 mm and 4.0 m/sec.

Bulletin of the Seismological Society of America↗

USGS2009

A deployment of broadband seismic stations in two deep gold mines, South Africa

In-mine seismic networks throughout the TauTona and Mponeng gold mines provide precise locations and seismic source parameters of earthquakes. They also support small-scale experimental projects, including NELSAM (Natural Earthquake Laboratory in South African Mines), which is intended to record, at close hand, seismic rupture of a geologic fault that traverses the project region near the deepest part of TauTona. To resolve some questions regarding the in-mine and NELSAM networks, we deployed four portable broadband seismic stations at deep sites within TauTona and Mponeng for one week during September 2007 and recorded ground acceleration. Moderately large earthquakes within our temporary network were recorded with sufficiently high signal-to-noise that we were able to integrate the acceleration to ground velocity and displacement, from which moment tensors could be determined. We resolved the questions concerning the NELSAM and in-mine networks by using these moment tensors to calculate synthetic seismograms at various network recording sites for comparison with the ground motion recorded at the same locations. We also used the peak velocity of the S wave pulse, corrected for attenuation with distance, to estimate the maximum slip within the rupture zone of an earthquake. We then combined the maximum slip and seismic moment with results from laboratory friction experiments to estimate maximum slip rates within the same high-slip patches of the rupture zone. For the four largest earthquakes recorded within our network, all with magnitudes near 2, these inferred maximum slips range from 4 to 27 mm and the corresponding maximum slip rates range from 1 to 6 m/s. These results, in conjunction with information from previous ground motion studies, indicate that underground support should be capable of withstanding peak ground velocities of at least 5 m/s.

Mponeng gold mine, TauTona gold mine↗