Geology topics

S. Harmsen

Publications and source records attributed to S. Harmsen.

6 recordsLinked to original sources

USGS2010

Effects of 3D random correlated velocity perturbations on predicted ground motions

Three-dimensional, finite-difference simulations of a realistic finite-fault rupture on the southern Hayward fault are used to evaluate the effects of random, correlated velocity perturbations on predicted ground motions. Velocity perturbations are added to a three-dimensional (3D) regional seismic velocity model of the San Francisco Bay Area using a 3D von Karman random medium. Velocity correlation lengths of 5 and 10 km and standard deviations in the velocity of 5% and 10% are considered. The results show that significant deviations in predicted ground velocities are seen in the calculated frequency range (≤1 Hz) for standard deviations in velocity of 5% to 10%. These results have implications for the practical limits on the accuracy of scenario ground-motion calculations and on retrieval of source parameters using higher-frequency, strong-motion data.

Bulletin of the Seismological Society of America↗

USGS2006

Modeling and validation of a 3D velocity structure for the Santa Clara Valley, California, for seismic-wave simulations

A 3D seismic velocity and attenuation model is developed for Santa Clara Valley, California, and its surrounding uplands to predict ground motions from scenario earthquakes. The model is developed using a variety of geologic and geophysical data. Our starting point is a 3D geologic model developed primarily from geologic mapping and gravity and magnetic surveys. An initial velocity model is constructed by using seismic velocities from boreholes, reflection/refraction lines, and spatial autocorrelation microtremor surveys. This model is further refined and the seismic attenuation is estimated through waveform modeling of weak motions from small local events and strong-ground motion from the 1989 Loma Prieta earthquake. Waveforms are calculated to an upper frequency of 1 Hz using a parallelized finite-difference code that utilizes two regions with a factor of 3 difference in grid spacing to reduce memory requirements. Cenozoic basins trap and strongly amplify ground motions. This effect is particularly strong in the Evergreen Basin on the northeastern side of the Santa Clara Valley, where the steeply dipping Silver Creek fault forms the southwestern boundary of the basin. In comparison, the Cupertino Basin on the southwestern side of the valley has a more moderate response, which is attributed to a greater age and velocity of the Cenozoic fill. Surface waves play a major role in the ground motion of sedimentary basins, and they are seen to strongly develop along the western margins of the Santa Clara Valley for our simulation of the Loma Prieta earthquake.

California↗

USGS2004

Probabilistic seismic hazard analysis for Sumatra, Indonesia and across the Southern Malaysian Peninsula

The ground motion hazard for Sumatra and the Malaysian peninsula is calculated in a probabilistic framework, using procedures developed for the US National Seismic Hazard Maps. We constructed regional earthquake source models and used standard published and modified attenuation equations to calculate peak ground acceleration at 2% and 10% probability of exceedance in 50 years for rock site conditions. We developed or modified earthquake catalogs and declustered these catalogs to include only independent earthquakes. The resulting catalogs were used to define four source zones that characterize earthquakes in four tectonic environments: subduction zone interface earthquakes, subduction zone deep intraslab earthquakes, strike-slip transform earthquakes, and intraplate earthquakes. The recurrence rates and sizes of historical earthquakes on known faults and across zones were also determined from this modified catalog. In addition to the source zones, our seismic source model considers two major faults that are known historically to generate large earthquakes: the Sumatran subduction zone and the Sumatran transform fault. Several published studies were used to describe earthquakes along these faults during historical and pre-historical time, as well as to identify segmentation models of faults. Peak horizontal ground accelerations were calculated using ground motion prediction relations that were developed from seismic data obtained from the crustal interplate environment, crustal intraplate environment, along the subduction zone interface, and from deep intraslab earthquakes. Most of these relations, however, have not been developed for large distances that are needed for calculating the hazard across the Malaysian peninsula, and none were developed for earthquake ground motions generated in an interplate tectonic environment that are propagated into an intraplate tectonic environment. For the interplate and intraplate crustal earthquakes, we have applied ground-motion prediction relations that are consistent with California (interplate) and India (intraplate) strong motion data that we collected for distances beyond 200 km. For the subduction zone equations, we recognized that the published relationships at large distances were not consistent with global earthquake data that we collected and modified the relations to be compatible with the global subduction zone ground motions. In this analysis, we have used alternative source and attenuation models and weighted them to account for our uncertainty in which model is most appropriate for Sumatra or for the Malaysian peninsula. The resulting peak horizontal ground accelerations for 2% probability of exceedance in 50 years range from over 100% g to about 10% g across Sumatra and generally less than 20% g across most of the Malaysian peninsula. The ground motions at 10% probability of exceedance in 50 years are typically about 60% of the ground motions derived for a hazard level at 2% probability of exceedance in 50 years. The largest contributors to hazard are from the Sumatran faults.

Tectonophysics↗

USGS2001

Geographic deaggregation of seismic hazard in the United States

The seismic hazard calculations for the 1996 national seismic hazard maps have been geographically deaggregated to assist in the understanding of the relative contributions of sources. These deaggregations are exhibited as maps with vertical bars whose heights are proportional to the contribution that each geographical cell makes to the ground-motion exceedance hazard. Bar colors correspond to average source magnitudes. We also extend the deaggregation analysis reported in Harmsen et al. (1999) to the western conterminous United States. In contrast to the central and eastern United States (CEUS); the influence of specific faults or characteristic events can be clearly identified. Geographic deaggregation for 0.2-sec and 1.0-sec pseudo spectral acceleration (SA) is performed for 10% probability of exceedance (PE) in 50 yr (475-yr mean return period) and 2% PE in 50 yr (2475-yr mean return period) for four western U.S. cities, Los Angeles, Salt Lake City, San Francisco, and Seattle, and for three central and eastern U.S. cities, Atlanta, Boston, and Saint Louis. In general, as the PE is lowered, the sources of hazard closer to the site dominate. Larger, more distant earthquakes contribute more significantly to hazard for 1.0-sec SA than for 0.2-sec SA. Additional maps of geographically deaggregated seismic hazard are available on the Internet for 120 cities in the conterminous United States (http://geohazards. cr.usgs.gov/eq/) for 1-sec SA and for 0.2-sec SA with a 2% PE in 50 yr. Examination of these maps of hazard contributions enables the investigator to determine the distance and azimuth to predominant sources, and their magnitudes. This information can be used to generate scenario earthquakes and corresponding time histories for seismic design and retrofit. Where fault density is lower than deaggregation cell dimensions, we can identify specific faults that contribute significantly to the seismic hazard at a given site. Detailed fault information enables investigators to include rupture information such as source directivity, radiation pattern, and basin-edge effects into their scenario earthquakes used in engineering analyses.

Bulletin of the Seismological Society of America↗

USGS1999

Calculation of broadband time histories of ground motion: Comparison of methods and validation using strong-ground motion from the 1994 Northridge earthquake

This article compares techniques for calculating broadband time histories of ground motion in the near field of a finite fault by comparing synthetics with the strong-motion data set for the 1994 Northridge earthquake. Based on this comparison, a preferred methodology is presented. Ground-motion-simulation techniques are divided into two general methods: kinematic- and composite-fault models. Green's functions of three types are evaluated: stochastic, empirical, and theoretical. A hybrid scheme is found to give the best fit to the Northridge data. Low frequencies (< 1 Hz) are calculated using a kinematic-fault model and a 3D finite-difference code to propagate energy through a realistic 3D velocity structure. High frequencies (> 1 Hz) are calculated using a composite-fault model with a fractal subevent size distribution and stochastic, bandlimited, white-noise Green's functions. At frequencies below 1 Hz, theoretical elastic-wave-propagation synthetics introduce proper seismic-phase arrivals of body waves and surface waves. The 3D velocity structure more accurately reproduces record durations for the deep sedimentary basin structures found in the Los Angeles region. At frequencies above 1 Hz, scattering effects become important and wave propagation is more accurately represented by stochastic Green's functions. A fractal subevent size distribution for the composite fault model ensures an ω −2 spectral shape over the entire frequency band considered (0.1-20 Hz).

California↗

USGS1993

Seismicity remotely triggered by the magnitude 7.3 Landers, California, earthquake

The magnitude 7.3 Landers earthquake of 28 June 1992 triggered a remarkably sudden and widespread increase in earthquake activity across much of the western United States. The triggered earthquakes, which occurred at distances up to 1250 kilometers (17 source dimensions) from the Landers mainshock, were confined to areas of persistent seismicity and strike-slip to normal faulting. Many of the triggered areas also are sites of geothermal and recent volcanic activity. Static stress changes calculated for elastic models of the earthquake appear to be too small to have caused the triggering. The most promising explanations involve nonlinear interactions between large dynamic strains accompanying seismic waves from the mainshock and crustal fluids (perhaps including crustal magma).

California↗