Geology topics

Ryan Cain Cahalan

Publications and source records attributed to Ryan Cain Cahalan.

5 recordsLinked to original sources

USGS2026

Geothermal district energy systems coupled with seasonal underground thermal energy storage: A U.S. techno-economic screening by climate and geology

In the United States, cooling-dominated commercial building loads can cause geothermal heat pump-based district energy systems to accumulate a long-term subsurface thermal imbalance, motivating the incorporation of seasonal underground thermal energy storage. We developed a transferable workflow to evaluate geothermal district systems that pair ground heat exchangers with seasonal underground thermal energy storage. Using standardized hourly loads for seven commercial buildings and a uniform cost framework, we simulated ten U.S. cities with a physics-based ground heat exchanger model, subsurface storage simulations, and economic assessment to isolate the roles of climate and hydrogeology. In cooling-dominated cities, underground thermal energy storage supplied the majority of annual cooling, cutting electricity use and summer peaks substantially while achieving levelized costs comparable to or below conventional chiller-boiler plants. In cooler climates, the storage share shrunk, required borefield size and costs rose, and levelized cost of energy increased nearly linearly with declining underground thermal energy storage fraction, indicating storage fraction as the primary economic lever. Sensitivity analysis showed capital risk dominated by borefield drilling and surface heating, ventilation, and air-conditioning and piping, with underground thermal energy storage costs secondary. This workflow provides a transparent foundation for site-specific design and screening of next-generation geothermal district energy systems.

Arizona, Illinois, Maryland, Michigan, Mississippi↗

USGS2025

Reservoir thermal energy storage pre-assessment for the United States

Storing thermal energy underground for later use in electricity production or direct-use heating/cooling is a promising, viable, and economical green energy option. Reservoir thermal energy storage (RTES) is one such option, which stores energy in underutilized permeable strata with low ambient groundwater flow rates and more geochemically evolved (e.g. brackish/saline) waters relative to overlying principal aquifer systems. The U.S. Geological Survey has begun assessing RTES potential nationally by focusing on five generalized geologic regions (Basin and Range, Coastal Plain, Illinois Basin, Michigan Basin, Pacific Northwest) across the United States. Hydrogeologic reservoir models are developed for the following eight metropolitan area cities within those regions to evaluate RTES performance across different climates and subsurface conditions: Albuquerque, New Mexico; Charleston, South Carolina; Chicago and Decatur, Illinois; Lansing, Michigan; Memphis, Tennessee; Phoenix, Arizona; and Portland, Oregon. Evaluated metrics include estimated required well spacing, thermal storage capacity, and thermal recovery efficiency through time. Also considered for each reservoir are potential complicating factors, including reservoir depth, thermally driven free convection, and groundwater salinity. This work focuses on direct-use cooling because the need for cooling modern office buildings greatly exceeds that for heating in most parts of the country (Falta and others, 2016); however, the evaluated metrics are also relevant to heating and electricity applications. Results indicate that favorable RTES conditions exist in each region, with the Coastal Plain and Basin and Range being especially favorable for thermal storage capacity, while the Pacific Northwest and Michigan Basin excel at energy recovery for the evaluated cooling application. The results underscore the utility of developing maps of thermal storage capacity, subsurface temperature models, and volumetric estimates of thermal storage capacity to serve as key RTES resource classification standards. Overall, this pre-assessment provides a basic understanding of RTES potential in several cities and geologic regions throughout the country and will aid ongoing thermal energy storage assessment efforts.

Arizona, Illinois, Michigan, New Mexico, Oregon, S↗

USGS2024

Explosive 2018 eruptions at Kīlauea driven by a collapse-induced stomp-rocket mechanism

Explosive volcanic eruptions produce hazardous atmospheric plumes composed of tephra particles, hot gas and entrained air. Such eruptions are generally driven by magmatic fragmentation or steam expansion. However, an eruption mechanism outside this phreatic–magmatic spectrum was suggested by a sequence of 12 explosive eruptions in May 2018 at Kīlauea, Hawaii, that occurred during the early stages of caldera collapse and produced atmospheric plumes reaching 8 km above the vent. Here we use seismic inversions for reservoir pressure as a source condition for three-dimensional simulations of transient multiphase eruptive plume ascent through a conduit and stratified atmosphere. We compare the simulations with conduit ascent times inferred from seismic and infrasound data, and with plume heights from radar data. We find that the plumes are consistent with eruptions caused by a stomp-rocket mechanism involving the abrupt subsidence of reservoir roof rock that increased pressure in the underlying magma reservoir. In our model, the reservoir was overlain by a pocket of accumulated high-temperature magmatic gas and lithic debris, which were driven through a conduit approximately 600 m long to erupt particles at rates of around 3,000 m 3 s −1 . Our results reveal a distinct collapse-driven type of eruption and provide a framework for integrating diverse geophysical and atmospheric data with simulations to gain a better understanding of unsteady explosive eruptions.

Hawaii↗

USGS2023

Dynamics of the December 2020 ash-poor plume formed by lava-water interaction at the summit of Kilauea Volcano, Hawaii

On 20 December 2020, after more than 2 years of quiescence at Kīlauea Volcano, Hawaiʻi, renewed volcanic activity in the summit crater caused boiling of the water lake over a period of ∼90 min. The resulting water-rich, electrified plume rose to 11–13 km above sea level, which is among the highest plumes on record for Kīlauea. Although conventional models would infer a high mass flux from explosive magma-water interaction, the plume was not associated with an infrasound signal indicative of “explosive” activity, nor did it produce a measurable ash-fall deposit. We use multisensor data to characterize lava-water interaction and plume generation during this opening phase of the 2020–21 eruption. Satellite, weather radar, and eyewitness observations revealed that the plume was rich in water vapor and hydrometeors but transported less ash than expected from its maximum height. Volcanic lightning flashes detected by ground-based cameras were confined to freezing altitudes of the upper cloud, suggesting that the ice formation drove the electrification of this plume. The low acoustic energy from lava-water interaction points to a weakly explosive style of hydrovolcanism. Heat transfer calculations show that the lava to water heat flux was sufficient to boil the lake within 90 min. Limited mixing of lava and water inhibited major steam explosions and fine fragmentation. Results from one-dimensional plume modeling suggest that the models may underpredict plume height due to overestimation of crosswind air-entrainment. Our findings shed light on an unusual style of volcanism in which weakly explosive lava-water interaction generated an outsized plume.

Hawaii↗

USGS2023

City-scale geothermal energy everywhere to support renewable resilience – A transcontinental cooperation

Cities have important and varying incentives to transform their energy sector to all-electric with low carbon emissions. However, they often encounter a number of impediments when attempting to implement such a change. For example, while urban areas have the highest energy demand-density, cities often lack the space for installing additional energy generation and/or long-duration energy storage systems. Cities also have existing environmental issues from energy sources (e.g., pollution from dust, waste heat or noise) that make residents sensitive to energy infrastructure development. Utilizing power from conventional sources, such as natural gas, biomass and hydropower, which usually are distanced from the urban areas, also make cities more vulnerable to supply disruptions. One promising de-carbonizing energy option for cities focuses on their heating and cooling needs, which constitutes around 1/3 of U.S. and 1/2 of European energy consumption (including industrial processes like drying, pasteurization, etc.; Jadun and others, 2017; EU Commission 2022). If heating and cooling loads can be met by geothermal direct-use technologies, then the need for new electric sources can be greatly lessened. Despite the proven efficacy of geothermal energy as a city/community-scale heating and cooling resource, it is currently only a niche resource in the heating and cooling sector, though has significant potential for future growth. Historically, emphasis has been placed on geothermal electricity generation potential that requires higher temperature (greater than 90 °C) resources at drillable depths, but potentially viable areas are geographically limited and typically well removed from urban centers. Key drivers for investments were represented by greater political interest in renewable electricity production, higher revenues and less effort in distributing the produced energy via grids. In contrast, low-temperature (less than 90 °C) geothermal resources can be used directly for heating and cooling almost everywhere and are cost-effective in urban/suburban settings. In addition, the increased prominence of renewable electricity sources, such as wind and solar onto city-scale electric grids, has led to new urgency around questions of energy storage. Underground thermal energy storage (UTES), wherein surplus or waste heat is stored underground for later use, could present a long-duration energy storage solution. From October 2022 through September 2024, a transcontinental consortium consisting of geological surveys, geoscience organizations, industry representatives and universities aims to develop an understanding of the global potential for city-scale geothermal, proposing guidelines to aid in promoting the economic utilization of low temperature geothermal resources. Efforts will focus on providing city managers and other decision makers with the information needed to evaluate and implement suitable city/community-scale geothermal technologies. Funded by the U.S. Geological Survey’s John Wesley Powell Center for Analysis and Synthesis, this interdisciplinary consortium will showcase tools, datasets, and scientific recommendations to accelerate the broader understanding and adoption of renewable energy systems that access geothermal resources. The collaborative research activities include standardization of nomenclatures, resource description and characterization strategies globally. The results from these activities will be combined with a preliminary climate-driven, city-based energy needs related analysis to perform energy supply/demand matching analysis. The identification of city-specific applications that would benefit from the geothermal technologies provides the basis to up-scale city-specific determinations to regional and national assessments of resource estimates. The city-scale geothermal energy research initiative will ultimately provide the synergies and management analysis that can address benefits, environmental impacts, regulatory frameworks, sustainability, and suitability in retrofitted buildings or new as well as existing heating networks.

Conference Paper↗