Robert Sickler | Search USGS

USGS2026

Distributed faulting of the northern West Napa Fault Zone in Napa Valley, California

Mapped surface ruptures from the 24 August 2014 M w 6.0 South Napa earthquake in the Napa Valley, California, show a 2‐km‐wide zone of distributed faulting in the southern and central West Napa fault zone (WNFZ). In the northern WNFZ at Hendry Winery (HW), however, the mapped 2014 surface ruptures encompass an ∼100‐m‐wide zone, implying significant narrowing of the near‐surface fault zone to the north. We present a tomographic shear‐wave velocity ( ⁠⁠ V S ) model and guided‐wave data that indicate the northern WNFZ is at least 400‐m wide, with multiple near‐surface fault traces. Our V S model shows that the 2014 surface ruptures are underlain by discrete low‐velocity zones (LVZs), and coincident guided‐wave data show that the LVZs carry fault‐zone guided waves. If nearby (<500 m) mapped faults to the east of HW are part of the WNFZ, the entire WNFZ is more than 1 km wide in the northern Napa Valley. WNFZ guided waves travel up to 38% slower than S body waves, and low‐strain guided‐wave shaking is up to five times stronger than the associated body‐wave shaking. Our data suggest that guided waves, traveling along distributed faults, may result in an increased shaking hazard over a 1‐km‐wide area of the northern Napa Valley during future significant earthquakes. In places, the 2014 surface ruptures were difficult to find one year after the earthquake, and paleoseismic trenching showed only weak evidence for faulting, which may not have been identified in trenches if the locations of the 2014 surface ruptures had not been previously mapped ( Prentice et al. , 2015 ). Guided‐wave and V S tomography data, however, show strong evidence for faulting beneath the 2014 surface ruptures and at locations to the east. Although paleoseismic trenching is the gold standard for identifying near‐surface faulting, methods such as peak ground velocities of guided waves may better identify immature near‐surface fault traces.

California↗

USGS2014

Global surface displacement data for assessing variability of displacement at a point on a fault

This report presents a global dataset of site-specific surface-displacement data on faults. We have compiled estimates of successive displacements attributed to individual earthquakes, mainly paleoearthquakes, at sites where two or more events have been documented, as a basis for analyzing inter-event variability in surface displacement on continental faults. An earlier version of this composite dataset was used in a recent study relating the variability of surface displacement at a point to the magnitude-frequency distribution of earthquakes on faults, and to hazard from fault rupture (Hecker and others, 2013). The purpose of this follow-on report is to provide potential data users with an updated comprehensive dataset, largely complete through 2010 for studies in English-language publications, as well as in some unpublished reports and abstract volumes.

Open-File Report↗

USGS2011

Seismic calibration shots conducted in 2009 in the Imperial Valley, southern California, for the Salton Seismic Imaging Project (SSIP)

Rupture of the southern section of the San Andreas Fault, from the Coachella Valley to the Mojave Desert, is believed to be the greatest natural hazard facing California in the near future. With an estimated magnitude between 7.2 and 8.1, such an event would result in violent shaking, loss of life, and disruption of lifelines (freeways, aqueducts, power, petroleum, and communication lines) that would bring much of southern California to a standstill. As part of the Nation's efforts to prevent a catastrophe of this magnitude, a number of projects are underway to increase our knowledge of Earth processes in the area and to mitigate the effects of such an event. One such project is the Salton Seismic Imaging Project (SSIP), which is a collaborative venture between the United States Geological Survey (USGS), California Institute of Technology (Caltech), and Virginia Polytechnic Institute and State University (Virginia Tech). This project will generate and record seismic waves that travel through the crust and upper mantle of the Salton Trough. With these data, we will construct seismic images of the subsurface, both reflection and tomographic images. These images will contribute to the earthquake-hazard assessment in southern California by helping to constrain fault locations, sedimentary basin thickness and geometry, and sedimentary seismic velocity distributions. Data acquisition is currently scheduled for winter and spring of 2011. The design and goals of SSIP resemble those of the Los Angeles Region Seismic Experiment (LARSE) of the 1990's. LARSE focused on examining the San Andreas Fault system and associated thrust-fault systems of the Transverse Ranges. LARSE was successful in constraining the geometry of the San Andreas Fault at depth and in relating this geometry to mid-crustal, flower-structure-like decollements in the Transverse Ranges that splay upward into the network of hazardous thrust faults that caused the 1971 M 6.7 San Fernando and 1987 M 5.9 Whittier Narrows earthquakes. The project also succeeded in determining the depths and seismic-velocity distributions of several sedimentary basins, including the Los Angeles Basin, San Fernando Valley, and Antelope Valley. These results advanced our ability to understand and assess earthquake hazards in the Los Angeles region. In order to facilitate permitting and planning for the data collection phase of SSIP, in June of 2009 we set off calibration shots and recorded the seismic data with a variety of instruments at varying distances. We also exposed sections of buried clay drainage pipe near the shot points to determine the effect of seismic energy on the pipes. Clay drainage pipes are used by the irrigation districts in both the Coachella and Imperial Valleys to prevent ponding and remove salts and irrigation water. This report chronicles the calibration project. We present new near-source velocity data that are used to test the regression curves that were determined for the LARSE project. These curves are used to create setback tables to determine explosive charge size and for placement of shot points. We also found that our shots did not damage the irrigation pipes and that the ODEX drilling system did well in the clay rich soils of the Imperial Valley.

California↗