Search USGS⌕ Search

Geology topics

R.J. Donahoe

Publications and source records attributed to R.J. Donahoe.

3 recordsLinked to original sources
USGS1989

Groundwater chemistry and water-rock interactions at Stripa

Groundwaters from near surface to a depth of 1232 m in the Stripa granite have been sampled and analyzed for major and trace constituents. The groundwater composition consists of two general types: a typical recharge water of Ca-HCO 3 type (<300 m depth) and a deeper Na-Ca-Cl type (>700 m depth) of high pH (8–10) that reaches a maximum of 1250 mg/L in total dissolved solids (TDS). Intermediate depths show mixtures of the two types that are highly fracture-dependent rather than depth-dependent. Any borehole can vary significantly and erratically in TDS for either a horizontal or vertical direction. The general transition from Ca-HCO 3 type to Na-Ca-Cl type correlates with the depth profile for hydraulic conductivity that drops from 10 −8 m/s to 10 −11 m/s or lower. Thermomechanical stress (from heater experiments) clearly shows an effect on the groundwater composition that could be caused by changing flow paths, leakage of fluid inclusions or both. Dissolution and precipitation of calcite, fluorite and barite, aluminosilicate hydrolysis, and addition of a saline source (possibly fluid inclusion leakage) play the major roles in defining the groundwater composition. The low permeability of the Stripa granite has produced a groundwater composition that appears intermediate between the dilute, shallow groundwaters typical of recharge in a crystalline rock terrain and the saline waters and brines typical of cratonic shield areas at depth.

Geochimica et Cosmochimica Acta↗
USGS1989

Fluid inclusions in the Stripa granite and their possible influence on the groundwater chemistry

Fluid inclusions in quartz and calcite of the Proterozoic Stripa granite, central Sweden, demonstrate that the rock and its fracture fillings have a complex evolutionary history. The majority of inclusions indicate formation during a hydrothermal stage following emplacement of the Stripa pluton. Total salinities of quartz inclusions range from 0–18 eq.wt% NaCl for unfractured rock and from 0–10 eq.wt% for fractured rock. Vein calcites contain up to 25 eq.wt% NaCl but the inclusion size is larger and the population density is lower. Homogenization temperatures are 100–150°C for unfractured rock and 100–250° for fractured rock. Pressure corrections, assuming immediate post-emplacement conditions of 2 kbar, give temperatures about 160°C higher. Measurements of fluid-inclusion population-densities in quartz range from about 10 8 inclusions/cm 3 in grain quartz to 10 9 inclusions/cm 3 in vein quartz. Residual porosity from inclusion densities has been estimated to be at least 1% which is two orders of magnitude greater than the flow porosity. Breakage and leaching of fluid inclusions is proposed as an hypothesis for the origin of major solutes (Na-Ca-Cl) in the groundwater. Evidence for the hypothesis is based on (1) mass balance—only a small fraction of the inclusions need to leak to account for salt concentrations in the groundwater, (2) chemical signatures— Br Cl "> BrCl ratios of fluid inclusion leachates (0.0101) match those ratios for the deep groundwaters (0.0107), (3) leakage mechanisms—micro-stresses from isostatic rebound or mining activities acting on irregular-shaped inclusions could cause breakage and provide connection with the flow porosity, and (4) experimental studies—water forced through low permeability granites leach significant quantities of salt. This hypothesis is consistent with the available data although alternate hypotheses cannot be excluded.

Geochimica et Cosmochimica Acta↗