Search USGS⌕ Search

Geology topics

R. L. Sutton

Publications and source records attributed to R. L. Sutton.

18 recordsLinked to original sources
USGS1977

The geological investigation of the Taurus-Littrow Valley: Apollo 17 landing site

Astronauts Cernan and Schmitt, of Apollo 17, landed in the Taurus-Littrow valley of the Moon on December 11, 1972. Their major objectives were: (1) to sample very ancient lunar material such as might be found in pre-Imbrian highlands as distant as possible from the Imbrium basin, and (2) to sample pyroclastic materials that had been interpreted as significantly younger than the mare basalts returned from previous Apollo landing sites. The crew worked approximately 22 hours on the lunar surface; they traversed about 30 km, collected nearly 120 kg of samples, took more than 2,200 photographs, and recorded many direct geologic observations. The lunar surface data, sample results, and geologic interpretation of orbital photographs are the bases for this geologic synthesis. The Taurus-Littrow massifs are interpreted as the upper part of thick faulted ejecta deposited on the rim of the transient cavity of the large southern Serenitatis basin, which was formed by a meteor impact about 3.9 to 4.0 b.y. ago. The target rocks, predominantly of the dunite-anorthosite-norite-troctolite suite or its metamorphosed equivalents, were fractured, sheared, crushed, and melted by the impact. The resulting mixture of crushed rock and melt was transported up and out of the transient cavity and deposited on and beyond its rim. Hot fragmental to partly molten ejecta and relatively cool cataclasite and relict target rocks were intermixed in a melange of lenses, pods, and veins. Crystallization of melts and thermal metamorphism of fine-grained fragmental debris produced breccia composed of lithic and mineral fragments in a fine-grained, coherent, crystalline matrix. Such breccia dominates the massif samples. Faults that bound the massifs were activated during formation of the basin, so that structural relief of several kilometers, due to high-angle faulting, was imposed on the ejecta almost as soon as it was deposited. Massive slumping, that produced thick wedges of colluvium on the lower massif slopes, probably occurred nearly contemporaneously with the faulting. Sculptured Hills material, perhaps largely cataclasite excavated from the southern Serenitatis basin by the same impact, was then deposited on and around the faulted ejecta of the massifs. Subfloor basalt, estimated to be about 1,400 m thick in the landing site, flooded the Taurus-Littrow graben prior to approximately 3.7 b. y. ago. The basalt is part of a more extensive unit that was broadly warped and cut by extensional faults before the accumulation in Mare Serenitatis of younger, less deformed basalts that overlap it. A thin volcanic ash unit, probably about 3.5 b. y. old, mantled the subfloor basalt and the nearby highlands. It, too, was subsequently overlapped by the younger basalts of Mare Serenitatis. In the time since deposition of the volcanic ash, continued bombardment by meteors and secondary projectiles has produced regolith, a mechanical mixture of debris derived mainly from the subfloor basalt, the volcanic ash, and the rocks of the nearby massifs and Sculptured Hills. The regolith, in combination with the underlying volcanic ash, forms an unconsolidated surficial deposit with an average thickness of about 14 m, sufficiently thick to permit abnormally rapid degradation of the smaller craters, especially those less than 200 m in diameter, so as to create a surface that seems less cratered than do other mare surfaces. Admixture of volcanic ash gives the surface a distinctive dark color, which, in combination with the less cratered appearance, led to the pre-mission interpretation of a young dark mantling unit. The uppermost part of the regolith in the landing area is basalt rich ejecta from the clustered craters of the valley floor. Most of the craters are interpreted as part of a secondary cluster formed by projectiles of ejecta from Tycho. When they struck the face of the South Massif, the projectiles mobilized fine-grained regolith material that was redeposited on the valley floor as the light mantle. Exposure ages suggest that the swarm of secondary projectiles struck the Taurus-Littrow area about 100 m.y. ago. The Lee-Lincoln fault scarp is part of an extensive system of wrinkle ridges and scarps that transect both mare and highlands rocks. The scarp cuts the crater Lara, but the major part of the displacement occurred before deposition of the light mantle. Minor post-light mantle displacement is shown by small extensional faults that cut its surface west of the Lee-Lincoln scarp.

Open-File Report↗
USGS1975

Structure and petrology of a cumulus norite boulder sampled by Apollo 17 in Taurus-Littrow Valley, the Moon

A glass-coated half-meter-size boulder was sampled by the Apollo 17 crew at station 8 near the foot of the Sculptured Hills. The rock proved to be a coarse-grained (0.5-cm) plagioclase-orthopyroxene cumulate, and the samples are the only true norites returned from the lunar surface. Photographs of the boulder showed it to contain at least nine structural surfaces and four glass veins. Orientation and inspection of three of the returned samples resulted in the identification of six surfaces and one vein. One of the structural surfaces visible in the boulder was identified as primary cumulus planar lamination, which was folded through an angle of at least 35° between two oriented samples, whereas fracture sets representing the other surfaces were coincident. The boulder is believed to be a sample of the deeper highlands or submare lunar crust, derived from a depth of 8 to 30 km and somewhat shock-metamorphosed during at least two excavation events. The chemical composition of the norites, when determined, should be of special interest in view of the large amount of literature concerning glass, cataclasite, hornfels, and "basalt" of noritic composition returned by other Apollo missions. However, the cumulus texture of the boulder precludes its being representative of any magmatic liquid composition, suggests that the lunar crust is heterogeneously layered, and that plagioclase sank, not floated, in magmatic liquids that formed the lunar crust. © 1975 Geological Society of America.

Geological Society of America Bulletin↗
USGS1973

Preliminary geologic investigation of the landing site: Appendix A: lunar surface orientations of Apollo 17 rock samples

The lunar surface orientations of some of the Apollo 17 rock samples at the time of their collection (table 6-V) are shown in this appendix (figs. 6-65 to 6-87). These orientations were determined by correlating lunar photographs of samples before collection with shapes and shadow characteristics of the same samples in the LRL under oblique illumination with nearly collimated light. The light source in the laboratory simulates the Sun. It is important to emphasize that the orientations shown are those at the time of collection and do not necessarily apply to the entire history of the exposure of a rock on the lunar surface. Tumbling and turning of some rock fragments on the lunar surface has already been well documented.

Book chapter↗
USGS1973

Preliminary geologic investigation of the Apollo 17 landing site

The Apollo 17 lunar module (LM) landed on the flat floor of a deep valley that embays the mountainous highlands at the eastern rim of the Serenitatis basin. Serenitatis, the site of a pronounced mascon, is one of the major multi-ringed basins on the near side of the Moon. The Taurus-Littrow valley, which is radial to the Serenitatis basis, is interpreted as a deep graben formed by structural adjustment of lunar crustal material to the Serenitatis impact.

Book chapter↗
USGS1972

Geologic setting of the Apollo 15 samples

The samples and photographs returned from the Apollo 15 site show that Hadley Delta is largely underlain by breccias whose clasts are mainly fragments of coarse-grained feldspathic rocks and nonmare-type basalt. Conspicuous sets of lineaments, visible in surface and orbital photographs of Mount Hadley and Hadley Delta, may represent systematic layering or fracture sets. The mare surface, with regolith about 5 meters thick, is underlain by two major basalt types, at least one of which has extensive lateral continuity and is exposed in the upper wall of Hadley Rille. Gradual erosional recession of the edges and filing of the interior of the rille by talus have contributed to the present cross sectional profile.

Science↗
USGS1972

Preliminary geologic investigation of the Apollo 15 landing site

The Apollo 15 lunar module (LM) landed at longitude 03°39'20'' E, latitude 26°26'00'' N on the mare surface of Palus Putredinis on the eastern edge of the Imbrium Basin. The site is between the Apennine Mountain front and Hadley Rille. The objectives of the mission, in order of decreasing priority, were description and sampling of three major geologic features—the Apennine Front, Hadley Rille, and the mare.

Book chapter↗
USGS1972

Preliminary geologic investigation of the Apollo 16 landing site

The Apollo 16 landing site in the lunar central highlands encompassed terra plains and adjacent mountainous areas of hilly and furrowed terra. These morphologic units, representing important terrane types in the lunar highlands, had been interpreted as volcanic on most premission geologic maps. However, it became apparent during the mission that there are indeed few or no volcanic rocks or landforms at the site but rather that the area is underlain by a wide variety of impact-generated breccias.

Book chapter↗
USGS1971

Geologic setting of the Apollo 14 samples

The Apollo 14 lunar module landed in a region of the lunar highlands that is part of a widespread blanket of ejecta surrounding the Mare Imbrium basin. Samples were collected from the regolith developed on a nearly level plain, a ridge 100 meters high, and a blocky ejecta deposit around a young crater. Large boulders in the vicinity of the landing site are coherent fragmental rocks as are some of the returned samples.

Science↗
USGS1970

Lunar regolith at Tranquillity Base

The regolith at Tranquillity Base is a layer of fragmental debris that ranges in thickness from about 3 to 6 meters. The thickness of the regolith and the exposure histories of its constituent fragments can be related, by means of a relatively simple model, to the observed crater distribution.

Science↗
USGS1969

Geologic setting of the lunar samples returned by the Apollo 11 mission

The Apollo 11 LM landed approximately 20 km south-southwest of the crater Sabine D in the southwestern part of Mare Tranquillitatis ( fig. 3-1 ). The landing site is 41.5 km north-northeast of the western promontory of the Kant Plateau (ref. 3-1 ), which is the nearest highland region. The Surveyor 5 spacecraft is approximately 25 km north-northwest of the Apollo 11 landing site, and the impact crater formed by Ranger 8 is 68 km northeast of the landing site.

Book chapter↗