Search USGS⌕ Search

Geology topics

R. B. Finkelman

Publications and source records attributed to R. B. Finkelman.

66 records · Page 4Linked to original sources
USGS1984

Semi-quantitative ion microprobe mass analyses of mineral-rich particles from the upper freeport coal

An ion microprobe mass analyzer (IMMA) has been used to analyze semi-quantitatively mineral-rich coal particles from two separate facies of the Upper Freeport coal bed. Accuracy is estimated to be ∓ 20% for those elements making up more than 0.1 wt.% of the particles and ∓ 50% for elements making up less than 0.1 wt.%. Using IMMA data, we found statistically significant differences between the two samples for five (Fe, Ca, Mn, Li, Ce) of the 25 elements detected. For Li and Mn the differences between the mineral-rich particles within samples were similar to differences found between samples on a whole-coal basis. For Ca and Fe, the differences are attributed to different modes of occurrence, and for Ce, the differences are probably due to an irregular distribution of an inorganic phase. We conclude that the IMMA can be used to obtain semi-quantitative data that may provide insight into the distribution and mode of occurrence of some of the elements in coal.

International Journal of Coal Geology↗
USGS1984

MICROCHARACTERIZATION OF ARSENIC- AND SELENIUM-BEARING PYRITE IN UPPER FREEPORT COAL, INDIANA COUNTY, PENNSYLVANIA.

Optical and scanning electron microscope as well as electron and proton microprobe techniques have been used in a detailed investigation of the modes of occurrence of arsenic and selenium in pyrite in Upper Freeport coal from the Homer City area, Indiana County, Pennsylvania. Polished blocks were prepared from columnar samples of the coal bed to represent particular zones continuously from top to bottom. Initial selection of zones to be studied was based on chemical analysis of bench-channel samples. Microprobe data indicate that the highest concentrations of arsenic (as great as 1. 5 wt. %) are apparently in solid solution in pyrite within a limited stratigraphic interval of the coal bed. Smaller amounts of arsenic and selenium (concentrations up to approximately 0. 1 and 0. 2 wt. % respectively) were detected at isolated points within pyrite grains in various strata of the coal bed.

Scanning Electron Microscopy↗
USGS1982

Ferromagnetic and superparamagnetic contamination in pulverized coal

Although no significant major-element contamination is introduced by grinding coal in a steel pulverizer, abraded steel particles can conceivably affect the magnetic properties of pulverized coal. Magnetic and scanning-electron-microscope analyses of pulverized coal and coal fragments from the Herrin No. 6 seam in Illinois showed ferromagnetic and superparamagnetic contamination from the grinder. Significant changes in the magnetic properties of the coal were noted, indicating a total steel contamination of approximately 0.02 wt%. When coal samples were vibrated in the magnetic field of the vibrating-sample magnetometer, the superparamagnetic steel particles moved through the pulverized coal, and participated in the formation of multidomain clusters that in turn substantially affected the magnetization of the coal.

Illinois↗
USGS1982

Properties, origin and nomenclature of rodlets of the inertinite maceral group in coals of the central Appalachian basin, U.S.A.

Resin rodlets, sclerenchyma strands and woody splinters, which are collectively called rodlets, were studied by chemical, optical petrographic, and scanning-electron microscopic (SEM) techniques. A study was made of such rodlets from the bituminous coal beds of the central Appalachian basin (Pennsylvanian; Upper Carboniferous) of the United States. Comparisons were made with rodlets from coal beds of the Illinois basin, the Southern Anthracite Field of Pennsylvania, the St. Rose coal field of Nova Scotia, and European and other coal fields. In order to determine their physical and chemical properties, a detailed study was made of the rodlets from the Pomeroy coal bed (high volatile A bituminous coal; Monongahela Formation; Upper Pennsylvanian) of Kanawha County, West Virginia. The origin of the rodlets was determined by a comparative analysis of a medullosan (seed fern) stem from the Herrin (No. 6) coal bed (high volatile C bituminous coal; Carbondale Formation) from Washington County, Illinois. Rodlets are commonly concentrated in fusain or carbominerite layers or lenses in bituminous coal beds of the central Appalachian basin. Most of the rodlets examined in our study were probably derived from medullosan seed ferns. The three types of rodlets are distinguished on the basis of cellularity, morphology and fracture.

International Journal of Coal Geology↗
USGS1981

Concentration of some platinum-group metals in coal

New data on some platinum group metals in coal indicate that the concentration of Pt is generally less than about 5 ppb, that of Pd is generally less than 1 ppb, and that of Rh is generally less than 0.5 ppb. No conclusive evidence was obtained concerning the mode of occurrence of these elements in coal.

International Journal of Coal Geology↗
USGS1978

Identification and significance of accessory minerals from a bituminous coal

A scanning electron microscope (SEM) has been used to study the in situ accessory minerals in polished blocks and pellets of petrographically analysed samples of the Waynesburg coal (hvb). Individual grains from the low-temperature ash (LTA) of the same coal were also studied. The visual resolution of the SEM permitted the detection of submicron mineral grains, which could then be analysed by the attached energy-dispersive system. Emphasis was placed on the highly reflective grains in the carbominerite bands. Among the most abundant accessory minerals observed were rutile, zircon, and rare-earth-bearing minerals. Small (1–5 μm) particles of what may be authigenic iron-rich chromite and a nickel silicate form rims on quartz grains. The SEM also permits the observation of grain morphology and mineral intergrowths. These data are useful in determining authigenicity and diagenic alteration. Substances in density splits of LTA include authigenic, detrital, extraterrestrial magnetite, tourmaline, and evaporite (?) minerals, and a fluorine-bearing amphibole. This analytical approach allows the determination of specific sites for many of the trace elements in coals. In the Waynesburg coal, most of the chromium is in the iron-chromium rims, the fluorine is in the amphibole, and the rare-earth elements are in rare-earth-bearing minerals. The ability to relate trace-element data to specific minerals will aid in predicting the behaviour of elements in coal during combustion, liquefaction, gasification, weathering, and leaching processes. This ability also permits insight into the degree of mobility of these elements in coal and provides clues to sedimentological and diagenetic conditions.

Pennsylvania↗
USGS1976

Brannerite from the Penn Haven Junction uranium occurrence, Carbon County, Pennsylvania

Thorium-free brannerite has been identified in Upper Devonian uraniferous sandstone from Penn Haven Junction, Carbon County, Pa. The brannerite was located by a variation of the "Lexan" technique and is associated with galena, uraninite, and clausthalite. The angular thorium-free nature of the brannerite suggests that it formed by metamorphism of uranium-saturated leucoxene. As a result of the metamorphism some uranium may be in less soluble minerals than those found in the uranium deposits of the Western United States. For this reason, in-place leaching of the uranium may be impractical.

Pennsylvania↗
USGS1974

Naturally occurring vapor-liquid-solid (VLS) Whisker growth of germanium sulfide

The first naturally occurring terrestrial example of vapor-liquid-solid (VLS) growth has been observed in condensates from gases released by burning coal in culm banks. Scanning electron microscopy, X-ray diffraction, and energy dispersive analysis indicate that the crystals consist of elongated rods (≈ 100 μm) of germanium sulfide capped by bulbs depleted in germanium.

Journal of Crystal Growth↗
USGS1970

Lunar soil: Size distribution and mineralogical constituents

The lunar soil collected by Apollo 11 consists primarily of submillimeter material and is finer in grain size than soil previously recorded photographically by Surveyor experiments. The main constituents are fine-grained to glassy rocks of basaltic affinity and coherent breccia of undetermined origin. Dark glass, containing abundant nickel-iron spheres, coats many rocks, mineral, and breccia fragments. Several types of homogeneous glass occur as fragments and spheres. Colorless spheres, probably an exotic component, are abundant in the fraction finer than 20 microns.

Science↗