Geology topics

Preston S. Wilson

Publications and source records attributed to Preston S. Wilson.

4 recordsLinked to original sources

USGS2024

Direct measurements of sediment geoacoustic properties in the New England Mud Patch and shelf break

This paper reports on an original set of direct sound speed measurements collected with the acoustic coring system in the New England Mud Patch (NEMP) and shelf break area to the south. Cores collected within the NEMP show range-dependence of the mud with slower sound speed and lower attenuation on the west side. In the shelf break region, the highest sound speeds are observed between the 200- and 350-m isobaths. The depth-dependence of the mud layer in the NEMP includes a surficial layer with a negative sound speed gradient of 28 s −1 . The remainder of the mud column has a weak positive sound speed gradient of 6.2 s −1 over an isovelocity layer. Comparison between in situ and ex situ sound speed measurements provides an assessment of the effects of sediment disturbance from gravity coring operations. Small differences in the upper 2.5 m were attributed to the changes in the geoacoustic properties caused by disturbance from the coring process. Below 2.5 m, the average difference is close to zero, suggesting that these sediments were minimally disturbed. Finally, an in situ measurement of shear speed was obtained near the depth of maximum penetration. The shear speed was well correlated with sound speed from approximately the same depth interval.

New England Mud Patch↗

USGS2020

Maximum entropy derived statistics of sound speed structure in a fine-grained sediment inferred from sparse broadband acoustic measurements on the New England continental shelf

Marginal probability distributions for parameters representing an effective sound-speed structure of a fine-grained sediment are inferred from a data ensemble maximum entropy method that utilizes a sparse spatially distributed set of received pressure time series resulting from multiple explosive sources in a shallow-water ocean environment possessing significant spatial variability of the seabed. A remote sensing seabed acoustics experiment undertaken in March 2017 off the New England Shelf was designed so that multiple independent analyses could infer the statistical properties of the seabed. The current analysis incorporates the measured horizontal variability from interpretations of a subbottom profiling survey of the experimental area. An idealized range- and azimuth-dependent parameterization of the seabed is derived from identification of horizons within the seabed that define multiple sediment layers. A sparse set of explosive charges were deployed on circular tracks with radii of about 2, 4, and 6.5 km with an acoustic array at the center to correlate a set of random measurements to physical acoustic processes that characterize the seabed. The mean values of a surface sound speed ratio and a linear sound speed gradient for the fine-grained sediment layer derived from 12 data samples processed in the 25–275-Hz band provide an estimate of the effective sound-speed structure in a 130-km $^2$ area. The inferred sediment sound speed values are evaluated by predicting measured time series data not used in the statistical inference, and are also compared to historical measurements. Finally, the low-frequency maximum entropy estimate of the sediment sound speed along with physical measurements derived from piston core measurements are utilized to estimate the sediment grain bulk modulus. predictions made by the viscous grain shearing model.

Maine, Vermont, New Hampshire, Massachusetts, Rhod↗

USGS2020

In situ measurements of compressional wave speed during gravity coring operations in the New England mud patch

This paper presents measurements of sediment sound-speed profiles measured in situ using the acoustic coring system (ACS). The reported measurements were obtained from seven gravity cores collected in the New England Mud Patch. The ACS uses two sets of transducers mounted below the penetrating tip of a sediment corer to make in situ measurements of geoacoustic properties as the corer penetrates the seabed. The in situ sound-speed profiles are interpreted in the context of stratigraphic layering measured by a seismic survey, and the measured sound-speed profiles are consistent with the geophysical description. The in situ sound-speed profiles measured by the ACS were compared to conventional measurements of sound speed on the recovered cores using the multisensor core logger (MSCL). The MSCL data displayed both random and systematic errors that were attributed to disturbance from the coring process and/or the handling of the sediments after collection. Finally, using porosity and grain size distributions measured from discrete samples of the cored sediments, the in situ sound-speed measurements were compared to empirical regressions based on independent data sets.

Atlantic Ocean, New England Mud Patch↗

USGS2015

Unusually loud ambient noise in tidewater glacier fjords: a signal of ice melt

In glacierized fjords, the ice-ocean boundary is a physically and biologically dynamic environment that is sensitive to both glacier flow and ocean circulation. Ocean ambient noise offers insight into processes and change at the ice-ocean boundary. Here we characterize fjord ambient noise and show that the average noise levels are louder than nearly all measured natural oceanic environments (significantly louder than sea ice and non-glacierized fjords). Icy Bay, Alaska has an annual average sound pressure level of 120 dB (re 1 μPa) with a broad peak between 1000 and 3000 Hz. Bubble formation in the water column as glacier ice melts is the noise source, with variability driven by fjord circulation patterns. Measurements from two additional fjords, in Alaska and Antarctica, support that this unusually loud ambient noise in Icy Bay is representative of glacierized fjords. These high noise levels likely alter the behavior of marine mammals.

Alaska↗