Geology topics

P. Segall

Publications and source records attributed to P. Segall.

24 records · Page 2Linked to original sources

USGS1994

The co-seismic slip distribution of the Landers earthquake

We derived a model for the co-seismic slip distribution on the faults which ruptured during the Landers earthquake sequence of 28 June 1992. The model is based on the inversion of surface geodetic measurements, primarily vector displacements measured using the Global Positioning System ( GPS ). The inversion procedure assumes that the slip distribution is to some extent smooth and purely right-lateral strike slip. For a given fault geometry, a family of solutions of varying smoothness can be generated. We choose the optimal model from this family based on cross-validation, which measures the predictive power of the data, and the trade-off of misfit and roughness. Solutions which give roughly equal weight to misfit and smoothness are preferred and have certain features in common: (1) there are two main patches of slip, on the Johnson Valley fault, and on the Homestead Valley, Emerson, and Camp Rock faults; (2) virtually all slip is in the upper 10 to 12 km; and (3) the model reproduces the general features of the geologically measured surface displacements, without prior constraints on the surface slip. In all models, regardless of smoothing, very little slip is required on the fault that represents the Big Bear event, and the total moment of the Landers event is 9 · 10 19 N-m. The nearly simultaneous rupture of multiple distinct faults suggests that much of the crust in this region must have been close to failure prior to the earthquake.

California↗

USGS1992

Induced stresses due to fluid extraction from axisymmetric reservoirs

Earthquakes can be induced by fluid extraction, as well as by fluid injection. Segall (1989) proposed that poroelastic stresses are responsible for inducing earthquakes associated with fluid extraction. Here, I present methods for computing poroelastic stress changes due to fluid extraction for general axisymmetric reservoir geometries. The results of Geertsma (1973) for a thin disk reservoir with uniform pressure drop are recovered as a special case. Predicted surface subsidence agrees very well with measured leveling changes over the deep Lacq gas field in southwestern France. The induced stresses are finite if the reservoir pressure changes are continuous. Computed stress changes are on the order of several bars, suggesting that the preexisting stress states in regions of extraction induced seismicity are very close to frictional instability prior to production. ?? 1992 Birkha??user Verlag.

Pure and Applied Geophysics PAGEOPH↗

USGS1992

Rapid intraplate strain accumulation in the New Madrid seismic zone

Remeasurement of a triangulation network in the southern part of the New Madrid seismic zone with the Global Positioning System has revealed rapid crustal strain accumulation since the 1950s. This area experienced three large (moment magnitudes >8) earthquakes in 1811 to 1812. The orientation and sense of shear is consistent with right-lateral strike slip motion along a northeast-trending fault zone (as indicated by current seismicity). Detection of crustal strain accumulation may be a useful discriminant for identifying areas where potentially damaging intraplate earthquakes may occur despite the absence of large earthquakes during historic time.

New Madrid seismic zone↗

USGS1990

Late Cretaceous age of fractures in the Sierra Nevada batholith, California

Regional sets of steeply dipping joints and faults are common throughout the Sierra Nevada batholith, yet relatively little is known about how or when they formed. Within some east-northeast-striking, left-lateral fault zones in the Mount Abbot quadrangle of the central Sierra Nevada, the host granodiorite is hydrothermally altered to a lower greenschist assemblage that contains muscovite. The muscovite yields a mean K-Ar and 40 Ar/ 39 Ar age of 79 Ma, which provides a minimum age for the faulting. Field relations show that these faults developed from earlier formed, mineralized joints, so these ages also provide a minimum age for the jointing. Published ages of biotite, hornblende, and zircon from the host granodiorite of Lake Edison are 80 Ma (K-Ar), 85 Ma (K-Ar), and 90 Ma (U-Pb), respectively. The geochronology, field relations, and hydrothermal mineral assemblages together suggest that the mineralized joints and faults all formed between 85 and 79 Ma, soon after the host pluton was emplaced.

Geology↗

USGS1989

Earthquakes triggered by fluid extraction

Seismicity is correlated in space and time with production from some oil and gas fields where pore pressures have declined by several tens of megapascals. Reverse faulting has occurred both above and below petroleum reservoirs, and normal faulting has occurred on the flanks of at least one reservoir. The theory of poroelasticity requires that fluid extraction locally alter the state of stress. Calculations with simple geometries predict stress perturbations that are consistent with observed earthquake locations and focal mechanisms. Measurements of surface displacement and strain, pore pressure, stress, and poroelastic rock properties in such areas could be used to test theoretical predictions and improve our understanding of earthquake mechanics.

Geology↗

USGS1982

Formation and interpretation of dilatant echelon cracks

The relative displacements of the walls of many veins, joints, and dikes demonstrate that these structures are dilatant cracks. We infer that dilatant cracks propagate in a principal stress plane, normal to the maximum tensile or least compressive stress. Arrays of echelon crack segments appear to emerge from the peripheries of some dilatant cracks. Breakdown of a parent crack into an echelon array may be initiated by a spatial or temporal rotation of the remote principal stresses about an axis parallel to the crack propagation direction. Near the parent-crack tip, a rotation of the local principal stresses is induced in the same sense, but not necessarily through the same angle. Incipient echelon cracks form at the parent-crack tip normal to the local maximum tensile stress. Further longitudinal growth along surfaces that twist about axes parallel to the propagation direction realigns each echelon crack into a remote principal stress plane. The walls of these twisted cracks may be idealized as helicoidal surfaces. An array of helicoidal cracks sweeps out less surface area than one parent crack twisting through the same angle. Thus, many echelon cracks grow from a single parent because the work done in creating the array, as measured by its surface area, decreases as the number of cracks increases. In cross sections perpendicular to the propagation direction, echelon cracks grow laterally, each crack overlapping its neighbors, until the mechanical interaction of adjacent cracks limits this growth. Dilation of each crack pinches the tips of adjacent cracks into an asymmetrical form and introduces local stresses that can cause lateral growth along a curving, sigmoidal path. Sigmoidal echelon cracks may link at tip-to-plane intersections, leaving a step in the through-going crack wall. The geometry of dilatant echelon cracks may be used to infer spatial or temporal changes in the orientation of principal stresses in the Earth.

Geological Society of America Bulletin↗