Search USGS⌕ Search

Geology topics

Michael N. Machette

Publications and source records attributed to Michael N. Machette.

54 records · Page 3Linked to original sources

Segmentation and the coseismic behavior of Basin and Range normal faults: examples from east-central Idaho and southwestern Montana, U.S.A.

The range-front normal faults of the Lost River and Lemhi Ranges, and the Beaverhead and Tendoy Mountains in east-central Idaho and southwestern Montana have well-preserved fault scarps on Quaternary deposits along much of their lengths. Fault-scarp morphology, the age of deposits displaced by the faults, and the morphology of the range fronts provide a basis for dividing the faults into segments that are typically 20–25 km long. The Lost River, Lemhi and Beaverhead fault zones are 141–151 km long, and each has six segments. The 60-km-long Red Rock fault (the range-front fault of the Tendoy Mountains) has two central segments that have been active in late Quaternary time; these two segments span the central 27 km of the fault. We recognize four characteristics that help to identify segment boundaries: (1) major en échelon offsets or pronounced gaps in the continuity of fault scarps; (2) distinct, persistent, along-strike changes in fault-scarp morphology that indicate different ages of faulting; (3) major salients in the range front; and (4) transverse bedrock ridges where the cumulative throw is low compared to other places along the fault zone. Only features whose size is measured on the scale of kilometers are regarded as significant enough to represent a segment boundary that could inhibit or halt a propagating rupture.

Journal of Structural Geology↗

Geologic Map of the San Luis Hills Area, Conejos and Costilla Counties, Colorado

This report is a digital image of the U.S. Geological Survey Miscellaneous Investigations Series Map I-1906, 'Geologic map of the San Luis Hills area, Conejos and Costilla Counties, Colorado,' which was published in 1989 by Thompson and Machette, scale 1:50,000 but has been unavailable in a digital version. The map area represents the southwestern portion of the Alamosa 30' x 60' quadrangle, which is currently being remapped by the U.S. Geological Survey. The northern and eastern margins of the San Luis Hills area have been remapped at greater detail and thus small portions of the map area have been updated. The northern margin is shown on U.S. Geological Survey Open-File Report 2005-1392, the northeastern portion is shown on U.S. Geological Survey Open-File Report 2008-1124, and the eastern margin is shown on U.S. Geological Survey Open-File Report 2007-1074. The most significant changes to the 1989 map area are recognition of Lake Alamosa and its deposits (Alamosa Formation), remapping of bedrock in the northeastern San Luis Hills, and redating of volcanic units in the San Luis Hills. Although unpublished, new 40Ar/39Ar ages for volcanic units in the Conejos and Hinsdale Formations add precision to the previous K/Ar-dated rocks, but do not change the basic chronology of the units. The digital version of this map was prepared by Theodore R. Brandt by scanning the original map at 300 pixels per inch, prior to creating the press-quality (96 Mb) and standard (5 Mb) .pdf files.

IMAP↗

Integrated uranium system in the Marysvale volcanic field, west-central Utah

Uranium in the Marysvale volcanic field is known to occur in several geologic environments, and is hypothesized to occur in others. Together the known and hypothetical occurrences range from a source in rhyolite magma, through porphyry-type deposits, hydrothermal vein deposits, dispersed hydrothermal deposits, and after transport in ground and surface water, to roll-front or sedimentary trap-deposits in basin-fill sediments. To date, only the hydrothermal vein environment has been productive, but billions of pounds of uranium were available in all other environments, and if proper circumstances occurred, significant concentrations probably exist there too. The intracaldera fill of the Mount Belknap caldera and sediment-filled basins adjoining the Tushar Mountains are especially favorable for the undiscovered uranium that may be expected.

Utah↗

Geologic map of the greater Denver area, Front Range urban corridor, Colorado

This digital map shows the areal extent of surficial deposits and rock stratigraphic units (formations) as compiled by Trimble and Machette from 1973 to 1977 and published in 1979 under the Front Range Urban Corridor Geology Program. Trimble and Machette compiled their geologic map from published geologic maps and unpublished geologic mapping having varied map unit schemes. A convenient feature of the compiled map is its uniform classification of geologic units that mostly matches those of companion maps to the north (USGS I-855-G) and to the south (USGS I-857-F). Published as a color paper map, the Trimble and Machette map was intended for land-use planning in the Front Range Urban Corridor. This map recently (1997-1999) was digitized under the USGS Front Range Infrastructure Resources Project. In general, the mountainous areas in the western part of the map exhibit various igneous and metamorphic bedrock units of Precambrian age, major faults, and fault brecciation zones at the east margin (5-20 km wide) of the Front Range. The eastern and central parts of the map (Colorado Piedmont) depict a mantle of unconsolidated deposits of Quaternary age and interspersed outcroppings of Cretaceous or Tertiary-Cretaceous sedimentary bedrock. The Quaternary mantle comprises eolian deposits (quartz sand and silt), alluvium (gravel, sand, and silt of variable composition), colluvium, and a few landslides. At the mountain front, north-trending, dipping Paleozoic and Mesozoic sandstone, shale, and limestone bedrock formations form hogbacks and intervening valleys.

Colorado↗

Dating Quaternary faults in the southwestern United States by using buried calcic paleosols

Calcareous soils are widespread on upper Pliocene to upper Pleistocene unconsolidated surflcial deposits in semiarid portions of the southwestern United States. Where these soils are related to faults, the soils may provide a means for quantitatively estimating timing and amounts of Quaternary faulting. Soil age estimates are based on the amount of pedogenic CaCO 3 (g/cm 2 -soil column) that has accumulated from soil processes, whereas rates of calcic-soil formation were calibrated by the K-Ar dating method, tephrochronology, vertebrate paleontology, and regional soil studies. The County Dump fault, west of Albuquerque, N. Mex. cuts a 500 000-yearold datum, the Llano de Albuquerque. The downdropped block of this fault contains a sequence of faulted younger deposits and intercalated calcic paleosols. Soil ages, and hence fault ages, can be calculated by measuring the total pedogenic calcium carbonate content in a section of buried paleosols and by using an independently established maximum soil formation rate of 0.35 g CaCO 3 • cm -2 • 10 -3 yr -1 for the Albuquerque area. This particular fault segment has had four discrete episodes of movement in the past 500 000 yr, the most recent of which occurred about 20000 yr B.P. Recurrence intervals on the segment are 90 000-190 000 yr, but the composite recurrence interval for all fault movements in this area may be less by several orders of magnitude. This technique of quantifying soil properties and calculating ages of relict soils can be used to estimate ages of Quaternary deposits and associated surfaces, to correlate such features over broad regions, and to analyze regional trends in calcic-soil formation.

New Mexico↗

Calcic soils and calcretes in the southwestern United States

Secondary calcium carbonate of diverse origins, 'caliche' of many authors, is widespread in the southwestern United States. 'Caliche' includes various carbonates such as calcic soils and products of groundwater cementation. The term 'caliche' is generally avoided in this report in favor of such terms as calcrete, calcic soils, and pervasively cemented deposits. Criteria for the recognition of various types of calcrete of diverse origins include field relations and laboratory data. Calcic soils provide a comprehensive set of characteristics that aid in their recognition in the field. These characteristics include a distinctive morphology that is zoned horizontally and can frequently be traced over tens to hundreds of square kilometers. The major process in the formation of pedogenic calcrete and calic soils is the leaching of calcium carbonate from upper soil horizons by downward percolating soil solutions and reprecipitation of the carbonate in alluvial horizons near the base of the soil profile. The formation of pedogenic calcrete involves many factors including climate, source of carbonate, and tectonic stability of the geomorphic surface on which the calcrete is deposited. Most of the carbonate in pedogenic calcrete is probably derived from windblown sand, dust, and rain. Calcic soils and pedogenic calcretes follow a six-stage sequence morphologic development and is based on a classification devised by Gile, Peterson and Grossman in 1966. The .six morphologic stages of carbonate deposition in soils are related to the relative age of the soil and are as follows: I. The first or youngest stage includes filamentous or faint coatings of carbonate on detrital grains. II. The second stage includes pebble coatings which are continuous; firm carbonate nodules are few to common. III. The third stage includes coalesced nodules which occur in a friable or disseminated carbonate matrix. IV. The fourth stage includes platy, firmly cemented matrix which engulfs nodules; horizon is plugged to downward moving solutions. V. The fifth stage includes soils which are platy to tabular, dense, strongly cemented. A well-developed laminar layer occurs on the upper surface. VI. The sixth and most advanced stage is massive, multilaminar, and strongly cemented calcrete with abundant pisoliths, the upper surface of which may be brecciated. Pisoliths may indicate many generations of brecciation and reformation. In general calcic soils include stages I through III and are friable to moderately indurated; whereas pedogenic calcretes include stages IV through VI and are dense and strongly indurated. In a single pedon the morphologic stage of carbonate deposition decreases downward in the profile. The stage of development may be used in local regions for correlation and determination of relative ages of soils and geomorphic surfaces. Some structures observed in pedogenic calcretes may be present in other types of calcrete but the horizontal zonation typical of deposits of soil processes is absent. Laminar structure in particular is not restricted to pedogenic deposits and is common in many varieties of calcrete. Very little chemical change occurs in the noncalcareous nonclayey fractions of calcretes with age; but clay minerals within calcretes undergo a complex history of authigenesis. There is a depletion of magnesium in the calcareous portion and an enrichment of magnesium in the clayey portion of a calcrete with age. In keeping with this relationship, montmorillonite, or mixed layer montmorillonite-illite, is common in younger calcretes; whereas the high magnesium-silicate clays, sepiolite and palygorskite, are common in older calcretes. This indicates that the magnesium depleted from the carbonate is redistributed authigenically in clay minerals. The mobility of carbonate introduces many problems in attempts to date calcretes directly. Although the relative ages of soils within a province may be determined by quant

Open-File Report↗