Search USGS⌕ Search

Geology topics

Michael H. Bothner

Publications and source records attributed to Michael H. Bothner.

At least 73 records · Page 4Linked to original sources
USGS1993

A procedure for partitioning bulk sediments into distinct grain-size fractions for geochemical analysis

A method to separate sediments into discrete size fractions for geochemical analysis has been tested. The procedures were chosen to minimize the destruction or formation of aggregates and involved gentle sieving and settling of wet samples. Freeze-drying and sonication pretreatments, known to influence aggregates, were used for comparison. Freeze-drying was found to increase the silt/clay ratio by an average of 180 percent compared to analysis of a wet sample that had been wet sieved only. Sonication of a wet sample decreased the silt/clay ratio by 51 percent. The concentrations of metals and organic carbon in the separated fractions changed depending on the pretreatment procedures in a manner consistent with the hypothesis that aggregates consist of fine-grained organic- and metal-rich particles. The coarse silt fraction of a freeze-dried sample contained 20–44 percent higher concentrations of Zn, Cu, and organic carbon than the coarse silt fraction of the wet sample. Sonication resulted in concentrations of these analytes that were 18–33 percent lower in the coarse silt fraction than found in the wet sample. Sonication increased the concentration of lead in the clay fraction by an average of 40 percent compared to an unsonicated sample. Understanding the magnitude of change caused by different analysis protocols is an aid in designing future studies that seek to interpret the spatial distribution of contaminated sediments and their transport mechanisms.

Environmental Geology↗
USGS1992

Contaminant transport and accumulation in Massachusetts Bay and Boston Harbor: A summary of U.S. Geological Survey studies

The U.S. Geological Survey (USGS) is conducting studies in Boston Harbor, Massachusetts Bay, and Cape Cod Bay designed to define the geologic framework of the region and to understand the transport and accumulation of contaminated sediments. The region is being studied because of environmental problems caused by the introduction of wastes for a long time, because a new ocean outfall (to begin operation in 1995) will change the location for disposal of treated Boston sewage from Boston Harbor into Massachusetts Bay, and because of the need to understand the transport of sediments and associated contaminants in order to address a wide range of management questions. The USGS effort complements and is closely coordinated with the research and monitoring studies supported by the Massachusetts Environmental Trust, the Massachusetts Bays Program, and by the Massachusetts Water Resources Authority. The USGS study includes (1) geologic mapping, (2) circulation studies, (3) long-term current and sediment transport observations, (4) measurements of contaminant inventories and rates of sediment mixing and accumulation, (5) circulation modeling, (6) development of a contaminated sediments data base, and (7) information exchange. A long-term objective of the program is to develop a predictive capability for sediment transport and accumulation.

Massachusetts↗
USGS1991

Modern sedimentary environments in Boston Harbor, Massachusetts

Analyses of sidescan-sonar records supplemented by available bathymetric, sedimentary, subbottom, and bottom-current data reveal the distributions of the following three categories of sedimentary environments within the glaciated, topographically complex Boston Harbor estuary in Massachusetts. 1) Environments of erosion appear on the sonographs either as patterns with isolated strong reflections or as uniform patterns of strong reflectivity. These patterns define outcrops of bedrock or till and coarse lag deposits that are being scoured and winnowed by tidal- and wave-induced currents. Erosional areas are located primarily along mainland and insular shores, within large channels that have strong tidal currents, atop submerged ridges and knolls, and across much of the harbor entrance. 2) Environments of deposition are depicted on the sidescan-sonar records as smooth, featureless surfaces that have low to moderate reflectivity. Depositional environments are found predominantly over shallow subtidal flats and in broad bathymetric lows where tidal currents are weak. Sediments within depositional areas are organic-rich sandy and clayey silts that are accumulating at rates ranging from 0.01 to 0.11 g/cm 2 /yr or 4000 to 46,100 metric tons/yr. The cumulative mass of modern mud in harbor depocenters is 24.3 million metric tons. 3) Environments of sediment reworking constitute areas affected by a combination of erosional and depositional processes. They are characterized on the sonographs by mosaics of light and dark patches produced by relatively subtle and gradational changes in reflectivity. Reworked sediments have diverse grain sizes that overlap and are transitional between those of the other two sedimentary environments, and they are indicative of highly variable bottom currents.

Massachusetts↗
USGS1989

Impacts of exploratory drilling for oil and gas on the benthic environment of Georges Bank

A 3-year monitoring program was performed to assess the impacts of exploratory drilling for oil and gas on the benthic environment of Georges Bank, an important commercial fishery region in the North Atlantic east of Massachusetts, USA. Surficial sediments were sampled for chemical and benthic infaunal analysis and bottom still photographs were taken to document bottom microtopography and epifauna at 46 stations during 12 field surveys. The surveys were performed quarterly from just before drilling began, during drilling, and for nearly 2 years after completion of drilling. Two of the eight drilling sites were selected for monitoring. Twenty-nine stations were positioned in a tight radial array around a drilling site in 80 m of water. A second group of three stations was positioned near another drilling site in 140 m of water. The remaining stations covered a broad expanse of the Bank and adjacent suspected sites of deposition of fine-grained sediments.\ Of the 12 elements analyzed in bulk sediments, only barium increased in concentration during the period when drilling was taking place (July 1981 to September 1982). The concentration of barium in surficial sediment increased 4·7-fold from 28 ppm before drilling to 131·7 ppm after drilling at the station closest to the drilling site in 80 m of water and 5·9-fold from 32 ppm before drilling to 172 ppm after drilling at the station closest to the drilling site in 140 m of water. The concentrations of both barium and chromium increased in the fine (silt/clay) fraction (usually less than 5% by weight of sediment from most stations) of sediments from several stations around one or both rig sites monitored during the period of drilling. Elevated concentrations of chromium (about two-fold) occurred only in sediments near the drilling site in 140 m of water. Statistically significant increases in the concentration of barium in the fine fraction to sediment were detected approximately 65 km west (downcurrent) and 35 km east of the drilling site in 80 m of water after drilling was completed. The benthic fauna were abundant and diverse throughout the study area. At most stations, the dominant species remained nearly the same from one season to another over the 3 years of sampling. Polychaetes were the most abundant, followed by crustaceans. The number of individuals of some species, particularly the amphipods Erichthonius fasciatus and Unciola inermis , showed large seasonal variations. Cluster analysis revealed a strong relationship between community structure and both sediment type and water depth. Little seasonal variation was detected, but some interannual differences were revealed by cluster analysis and correspondence analysis. The replicates from a station always resembled each other more than they resembled any replicates from other stations. In addition, the combined replicates from a station always clustered with samples from that station taken on other cruises. This excellent replication and uniformity of the benthic infaunal community at a station over time made it possible to detect very subtle changes in community parameters that might be related to discharges of drilling fluid and drill cuttings. Nevertheless, no changes were detected in benthic communities of Georges Bank that could be attributed to drilling activities.

Massachusetts↗
USGS1987

Near-bottom suspended matter concentration on the Continental Shelf during storms: estimates based on in situ observations of light transmission and a particle size dependent transmissometer calibration

A laboratory calibration of Sea Tech and Montedoro-Whitney beam transmissometers shows a linear relation between light attenuation coefficient ( c p ) and suspended matter concentration (SMC) for natural sediments and for glass beads. However the proportionality constant between c p and SMC depends on the particle diameter and particle type. Thus, to measure SMC, observations of light attenuation must be used with a time-variable calibration when suspended particle characteristics change with time. Because of this variable calibration, time series of light attenuation alone may not directly reflect SMC and must be interpreted with care. The near-bottom concentration of suspended matter during winter storms on the U.S. East Coast Continental Shelf is estimated from light transmission measurements made 2 m above the bottom and from the size distribution of suspended material collected simultaneously in sediment traps 3 m above the bottom. The average concentrations during six storms between December 1979 and February 1980 in the Middle Atlantic Bight ranged from 2 to 4 mg l 1 (maximum concentration of 7 mg l 1 ) and 8 to 12 mg l 1 (maximum concentration of 22 mg l 1 ) on the south flank of Georges Bank.

Continental Shelf Research↗
USGS1986

The Georges Bank monitoring program 1985: Analysis of trace metals in bottom sediments during the third year of monitoring

Of the 12 elements analyzed in bulk (undifferentiated) sediments collected adjacent to drilling rigs on Georges Bank, only barium was found to increase in concentration during the period when eight exploratory wells were drilled (July 1981 until September 1982). The maximum postdrilling concentration of barium (a major element in drilling mud) reached 172 ppm in bulk sediments near the drill site in block 410. This concentration is higher than the predrilling concentration at this location by a factor of 5.9. This maximum barium concentration is within the range of predrilling concentrations (28-300 ppm) measured in various sediment types from the regional stations of this program. No drilling-related changes in the concentrations of the 11 other metals have been observed in bulk sediments at any of the locations sampled in this program. We estimate that about 25 percent of the barite discharged at block 312 was present in the sediments within 6 km of the rig, 4 weeks after drilling was completed at this location (drilling period was December 8, 1981-June 27, 1982). For almost a year following completion of this well, the inventory of barite decreased rapidly, with a half-life of 0.34 year. During the next year, the inventory decreased at a slower rate (half-life of 3.4 years). The faster rate probably reflects resuspension and sediment transport of bariterich material residing at the sediment surface. Elevated barium concentrations in post-drilling sediment-trap samples from block 312 indicate that such resuspension can occur up to at least 25 m above the sea floor. As the remaining barite particles are reworked deeper into the sediments by currents and bioturbation, removal by sediment-transport processes is slower. The barite discharged during the exploratory phase of drilling is associated with the fine fraction of sediment and is widely distributed around the bank. We found evidence for barium transport to Great South Channel, 115 km west of the drilling, and to stations 2 and 3, 35 km east of the easternmost drilling site. Small increases in barium concentrations, present in the fine fraction of sediment only, were measured also at the heads of both Lydonia and Oceanographer Canyons, located 8 and 39 km, respectively, seaward of the nearest exploratory well.

Georges Bank↗
USGS1984

The Georges Bank monitoring program 1983: Analysis of trace metals in bottom sediments

From July 1981, when drilling began on Georges Bank, to May 1982, the concentration of barium, a major element in drilling mud, has increased by a factor of 3.5 in bulk sediments 200 m from the drill site in block 410 and by a factor of 2.3 at the drill site in block 312. The postdrilling barium concentrations are within the range of predriiling concentrations measured at other locations on Georges Bank. We estimate that no more than 21 percent of the barite (principal barium-bearing mineral) discharged during drilling remains within 6 km of the drill site in block 312. No drilling-related changes in the concentration of chromium or other metals have been observed in bulk sediments from blocks 410 or 312. The chemical signal of drilling mud in surficial sediments has been enhanced by separating and analyzing the sediment fraction finer than 60 ?m. Barium concentrations in the fine fraction have increased by factors of 36 and 22 at the drill sites in blocks 410 and 312, respectively. At the drill site in block 410, aluminum, chromium, copper, and mercury concentrations in this fraction temporarily increased by approximately a factor of 2 and then decreased to background. The concentrations of aluminum, barium, cadmium, chromium, copper, iron, lead, manganese, mercury, nickel, organic carbon, vanadium, and zinc in surface sediments of Georges Bank both before and after drilling are low compared to concentrations in average crustal rocks and are characteristic of unpolluted, coarse-grained sediments as found in other Continental Shelf areas.

Georges Bank↗