Redefining the age of the lower Colorado River, southwestern United States: Comment
No abstract available.
Geology↗
Geology topics
Michael E. Oskin
Publications and source records attributed to Michael E. Oskin.
Airborne lidar and electro-optical imagery along surface ruptures of the 2019 Ridgecrest earthquake sequence, Southern California
Surface rupture from the 2019 Ridgecrest earthquake sequence, initially associated with the M 6.4 foreshock, occurred on July 4 on a ~17 km long, northeast-southwest oriented, left-lateral zone of faulting. Following the M 7.1 mainshock on July 5 (local time), extensive northwest-southeast-oriented, right-lateral faulting was then also mapped along a ~50 km long zone of faults, including sub-parallel splays in several areas. The largest slip was observed in the epicentral area, and crossing the dry lakebed of China Lake to the southeast. Surface fault rupture mapping by a large team, reported elsewhere, was used to guide the airborne data acquisition reported here. Rapid rupture mapping allowed for accurate and efficient flight line planning for the high-resolution lidar and aerial photography. Flight line planning trade-offs were considered to allocate the medium (25 pulses per square meter, or ppsm) and high resolution (80 ppsm) lidar data collection polygons. The National Center for Airborne Laser Mapping (NCALM) acquired the airborne imagery with a Titan multispectral lidar system and DiMAC aerial digital camera, and USGS acquired GPS ground control data. This effort required extensive coordination with the Navy as much of the airborne data acquisition occurred within their restricted airspace at the China Lake Ranges.
Calilfornia↗
An analysis of the factors that control fault zone architecture and the importance of fault orientation relative to regional stress
The moment magnitude 7.2 El Mayor−Cucapah (EMC) earthquake of 2010 in northern Baja California, Mexico produced a cascading rupture that propagated through a geometrically diverse network of intersecting faults. These faults have been exhumed from depths of 6−10 km since the late Miocene based on low-temperature thermochronology, synkinematic alteration, and deformational fabrics. Coseismic slip of 1−6 m of the EMC event was accommodated by fault zones that displayed the full spectrum of architectural styles, from simple narrow fault zones (<100 m in width) that have a single high-strain core, to complex wide fault zones (>100 m in width) that have multiple anastomosing high-strain cores. As fault zone complexity and width increase the full spectrum of observed widths (20−200 m), coseismic slip becomes more broadly distributed on a greater number of scarps that form wider arrays. Thus, the infinitesimal slip of the surface rupture of a single earthquake strongly replicates many of the fabric elements that were developed during the long-term history of slip on the faults at deeper levels of the seismogenic crust. We find that factors such as protolith, normal stress, and displacement, which control gouge production in laboratory experiments, also affect the architectural complexity of natural faults. Fault zones developed in phyllosilicate-rich metasedimentary gneiss are generally wider and more complex than those developed in quartzo-feldspathic granitoid rocks. We hypothesize that the overall weakness and low strength contrast of faults developed in phyllosilicate rich host rocks leads to strain hardening and formation of broad, multi-stranded fault zones. Fault orientation also strongly affects fault zone complexity, which we find to increase with decreasing fault dip. We attribute this to the higher resolved normal stresses on gently dipping faults assuming a uniform stress field compatible with this extensional tectonic setting. The conditions that permit slip on misoriented surfaces with high normal stress should also produce failure of more optimally oriented slip systems in the fault zone, promoting complex branching and development of multiple high-strain cores. Overall, we find that fault zone architecture need not be strongly affected by differences in the amount of cumulative slip and instead is more strongly controlled by protolith and relative normal stress.
Baja California↗
Breaching of strike-slip faults and successive flooding of pull-apart basins to form the Gulf of California seaway from ca. 8–6 Ma
The geologic record of the formation of marine basins during continental rifting is uncommonly preserved. Using GIS-based paleotectonic maps, we show that marine basin formation in the Gulf of California–Salton trough oblique rift (Mexico and the United States) occurred in a stepwise manner as crustal thinning lowered elevations within the Gulf of California Shear Zone, and subsidence along strike-slip and transtensional faults linked isolated pull-apart basins. At 8 Ma, the earliest marine conditions in the Gulf of California were restricted to an embayment at its southern mouth. Farther north, the plate boundary was a set of continental strike-slip faults and linked pull-apart basins, similar to the modern Walker Lane in Nevada and California. By ca. 7 Ma, a series of marine incursions breached across strike-slip faults to the Pescadero and Farallon basins. Marine waters then breached a 75–100 km-long transtensional fault zone between the Farallon and Guaymas basins, with intermittent flooding that led to accumulation of extensive evaporite deposits in the Guaymas basin. Marine incursion north of the Guaymas basin via breaches across the Guaymas and Tiburón strike-slip faults and transtensional zones resulted in flooding of the northern >500 km of the oblique rift by 6.5–6.3 Ma. Thus, strike-slip and transtensional faulting promoted localization of plate boundary strain and guided punctuated marine flooding of the Gulf of California seaway. Inception of the narrow, 1500-km-long Gulf of California at ca. 6.3 Ma was followed by complete continental rupture in the Guaymas basin at ca. 6.0 Ma.
Geology↗
Slip history of the La Cruz fault: Development of a late Miocene transformin response to increased rift obliquity in the northern Gulf of California
The Gulf of California rift has accommodated oblique divergence of the Pacific and North America plates in north-western México since Miocene time. Due to its infancy, its rifted margins preserve a rare onshore record of early continental break-up processes and an opportunity to investigate the role of rift obliquity in strain localization. We map rift-related structures and syn-tectonic basins on southern Isla Tiburón, a proximal onshore exposure of the rifted North America margin. We integrate analysis and geochronology of syn-tectonic sedimentary basins and mapping of crosscutting relationships to characterize the style and timing of fault activity. On southern Isla Tiburón, an early phase of extension initiated between~19–17 Ma and ~12.2Ma. Subsequently, these normal faults and related basins were cut by the La Cruz strike-slip fault and buried by deposits of the La Cruz basin, an elongate, fault-controlled trough coextensive with the La Cruz fault. Crosscutting relationships show that the NW-striking La Cruz fault accrued 5 ± 2 km of dextral slip ~8–4 Ma. The La Cruz fault and parallel Tiburón transform were kinematically linked to detachment faulting that accommodated latest Miocene to Pliocene oblique opening of the offshore Upper Tiburón pull-apart basin. The onset of strike-slip faulting on Isla Tiburón was synchronous with the ~8–6 Ma onset of transform faulting and basin formation along >1000 km of the reconstructed Pacific-NorthAmerica plate boundary. This transition coincides with the commencement of a clockwise azimuthal shift in Pacific-North America relative plate motion that increased the obliquity of the Gulf of California rift and formed the Gulf of California shear zone. The record from the proto-Gulf of California illustrates how highly oblique rift geometries, where transform faults are kinematically linked to pull-apart basins, enhance the ability of continental lithosphere to rupture and, ultimately, hasten the formation of new oceanic rift basins.
Gulf of California↗
Animated tectonic reconstruction of the Lower Colorado River region: Implications for Late Miocene to Present deformation
Although the majority of late Miocene to present Pacific-North America plate boundary strain has been accommodated by faults of the San Andreas and Gulf of California systems, growing evidence of dextral shear east of the San Andreas Fault indicates that a component of plate boundary deformation occurred in the lower Colorado River (LoCR) region. Large-scale tectonic reconstructions across the Gulf of California and Salton Trough (GCAST) region (Fig. 1), a ~500 km-wide zone of deformation that affected the western margin of North America, provide important constraints on the location, timing, style, and magnitude of crustal deformation in the LoCR region (Fig. 2). Characterizing Miocene to present deformation in the LoCR region is important to resolve the presence and kinematics of upper crustal structures that accommodated intracontinental strain and improves our understanding of the processes that promoted localized or diffuse strain during reorganization of the Pacific-North America plate boundary. Map-view translations of crustal blocks influence the relative motions of adjacent blocks, an approach adhered to in global plate-circuit models (Atwater and Stock, 1998; 2013). Thus, a synthesis of the magnitude and timing of horizontal strain across a broad zone of distributed deformation can provide insight into processes of strain partitioning and potential kinematic links between adjacent structural domains. Furthermore, it can help prioritize and guide future work by identifying gaps in our understanding of plate boundary deformation and provide a degree of predictability for palinspastic reconstructions in areas where little information exists. At present, detailed geologic studies of crustal deformation related to the Pacific-North America plate boundary in the LoCR region are limited, leading to considerable uncertainty in the late Cenozoic tectonic evolution of the region. This uncertainty limits our understanding of how plate coupling evolves during the transition from a convergent margin to a transform margin. In this paper, we utilize animated palinspastic fault-based reconstructions to evaluate the tectonic evolution of the LoCR region and to examine potential inconsistencies of the spatio-temporal evolution of the late Cenozoic Pacific-North America plate boundary. Based on revised palinspastic reconstructions and remaining inconsistencies, we hypothesize that (1) late Miocene transtensional faulting related to the Gulf of California shear zone and eastern California shear zone promoted tectonic subsidence in the LoCR region that permitted the subsequent southward lake spillover of the Colorado River and connection with the northern Gulf of California, (2) distributed Pliocene transtensional faulting likely occurred within the southern LoCR region, and is presently unaccounted for in most studies of geologic units related to the Pliocene Colorado River, and (3) the Chocolate Mountains anticlinorium can be reconstructed to a broadly linear, E-W-oriented structure at ca. 11 Ma, consistent with reconstruction of several other strain markers along the southern San Andreas Fault system.
Lower Colorado River↗
Interactive terrain visualization enables virtual field work during rapid scientific response to the 2010 Haiti earthquake
The moment magnitude (M w ) 7.0 12 January 2010 Haiti earthquake is the first major earthquake for which a large-footprint LiDAR (light detection and ranging) survey was acquired within several weeks of the event. Here, we describe the use of virtual reality data visualization to analyze massive amounts (67 GB on disk) of multiresolution terrain data during the rapid scientific response to a major natural disaster. In particular, we describe a method for conducting virtual field work using both desktop computers and a 4-sided, 22 m 3 CAVE immersive virtual reality environment, along with KeckCAVES (Keck Center for Active Visualization in the Earth Sciences) software tools LiDAR Viewer, to analyze LiDAR point-cloud data, and Crusta, for 2.5 dimensional surficial geologic mapping on a bare-earth digital elevation model. This system enabled virtual field work that yielded remote observations of the topographic expression of active faulting within an ∼75-km-long section of the eastern Enriquillo–Plantain Garden fault spanning the 2010 epicenter. Virtual field observations indicated that the geomorphic evidence of active faulting and ancient surface rupture varies along strike. Landform offsets of 6–50 m along the Enriquillo–Plantain Garden fault east of the 2010 epicenter and closest to Port-au-Prince attest to repeated recent surface-rupturing earthquakes there. In the west, the fault trace is well defined by displaced landforms, but it is not as clear as in the east. The 2010 epicenter is within a transition zone between these sections that extends from Grand Goâve in the west to Fayette in the east. Within this transition, between L'Acul (lat 72°40′W) and the Rouillone River (lat 72°35′W), the Enriquillo–Plantain Garden fault is undefined along an embayed low-relief range front, with little evidence of recent surface rupture. Based on the geometry of the eastern and western faults that show evidence of recent surface rupture, we propose that the 2010 event occurred within a stepover that appears to have served as a long-lived boundary between rupture segments, explaining the lack of 2010 surface rupture. This study demonstrates how virtual reality–based data visualization has the potential to transform rapid scientific response by enabling virtual field studies and real-time interactive analysis of massive terrain data sets.
Geosphere↗