Search USGSSearch

Geology topics

M.L. Abbott

Publications and source records attributed to M.L. Abbott.

3 recordsLinked to original sources

Mercury in soil near a long-term air emission source in southeastern Idaho

At the Idaho National Engineering and Environmental Laboratory in southeastern Idaho, a 500 °C fluidized bed calciner was intermittently operated for 37 years, with measured Hg emission rates of 9–11 g/h. Surface soil was sampled at 57 locations around the facility to determine the spatial distribution of Hg fallout and surface Hg variability, and to predict the total residual Hg mass in the soil from historical emissions. Measured soil concentrations were slightly higher ( p <0.05) within 5 km of the source but were overall very low (15–20 ng/g) compared to background Hg levels published for similar soils in the USA (50–70 ng/g). Concentrations decreased 4%/cm with depth and were found to be twice as high under shrubs and in depressions. Mass balance calculations accounted for only 2.5–20% of the estimated total Hg emitted over the 37-year calciner operating history. These results suggest that much of the Hg deposited from calciner operations may have been reduced in the soil and re-emitted as Hg(0) to the global atmospheric pool.

Idaho

Mercury accumulation in snow on the Idaho National Engineering and Environmental Laboratory and surrounding region, southeast Idaho, USA

Snow was sampled and analyzed for total mercury (THg) on the Idaho National Engineering and Environmental Laboratory (INEEL) and surrounding region prior to the start-up of a large (9-11 g/h) gaseous mercury emission source. The objective was to determine the effects of the source on local and regional atmospheric deposition of mercury. Snow samples collected from 48 points on a polar grid near the source had THg concentrations that ranged from 4.71 to 27.26 ng/L; snow collected from regional background sites had THg concentrations that ranged from 0.89 to 16.61 ng/L. Grid samples had higher concentrations than the regional background sites, which was unexpected because the source was not operating yet. Emission of Hg from soils is a possible source of Hg in snow on the INEEL. Evidence from Hg profiles in snow and from unfiltered/filtered split samples supports this hypothesis. Ongoing work on the INEEL is investigating Hg fluxes from soils and snow.

Idaho

Mercury deposition in snow near an industrial emission source in the western U.S. and comparison to ISC3 model predictions

Mercury (total and methyl) was evaluated in snow samples collected near a major mercury emission source on the Idaho National Engineering and Environmental Laboratory (INEEL) insoutheastern Idaho and 160 km downwind in Teton Range in westernWyoming. The sampling was done to assess near-field (<12 km)deposition rates around the source, compare them to those measured in a relatively remote, pristine downwind location, andto use the measurements to develop improved, site-specific modelinput parameters for precipitation scavenging coefficient and thefraction of Hg emissions deposited locally. Measured snow waterconcentrations (ng L -1 ) were converted to deposition (ugm -2 ) using the sample location snow water equivalent. Thedeposition was then compared to that predicted using the ISC3 airdispersion/deposition model which was run with a range ofparticle and vapor scavenging coefficient input values. Acceptedmodel statistical performance measures (fractional bias andnormalized mean square error) were calculated for the differentmodeling runs, and the best model performance was selected. Measured concentrations close to the source (average = 5.3 ngL -1 ) were about twice those measured in the Teton Range(average = 2.7 ng L -1 ) which were within the expected rangeof values for remote background areas. For most of the samplinglocations, the ISC3 model predicted within a factor of two of theobserved deposition. The best modeling performance was obtainedusing a scavenging coefficient value for 0.25 μm diameterparticulate and the assumption that all of the mercury isreactive Hg(II) and subject to local deposition. A 0.1 μm particle assumption provided conservative overprediction of thedata, while a vapor assumption resulted in highly variable predictions. Partitioning a fraction of the Hg emissions to elemental Hg(0) (a U.S. EPA default assumption for combustion facility risk assessments) would have underpredicted the observed fallout.

Idaho