Geology topics

M.I. Staid

Publications and source records attributed to M.I. Staid.

4 recordsLinked to original sources

USGS2011

Compositional diversity and geologic insights of the Aristarchus crater from Moon Mineralogy Mapper data

The Moon Mineralogy Mapper (M3) acquired high spatial and spectral resolution data of the Aristarchus Plateau with 140 m/pixel in 85 spectral bands from 0.43 to 3.0 m. The data were collected as radiance and converted to reflectance using the observational constraints and a solar spectrum scaled to the Moon-Sun distance. Summary spectral parameters for the area of mafic silicate 1 and 2 m bands were calculated from the M3 data and used to map the distribution of key units that were then analyzed in detail with the spectral data. This analysis focuses on five key compositional units in the region. (1) The central peaks are shown to be strongly enriched in feldspar and are likely from the upper plagioclase-rich crust of the Moon. (2) The impact melt is compositionally diverse with clear signatures of feldspathic crust, olivine, and glass. (3) The crater walls and ejecta show a high degree of spatial heterogeneity and evidence for massive breccia blocks. (4) Olivine, strongly concentrated on the rim, wall, and exterior of the southeastern quadrant of the crater, is commonly associated the impact melt. (5) There are at least two types of glass deposits observed: pyroclastic glass and impact glass. Copyright 2011 by the American Geophysical Union.

Journal of Geophysical Research E: Planets↗

USGS2011

Remote compositional analysis of lunar olivine-rich lithologies with Moon Mineralogy Mapper (M3) spectra

A systematic approach for deconvolving remotely sensed lunar olivine‐rich visible to near‐infrared (VNIR) reflectance spectra with the Modified Gaussian Model (MGM) is evaluated with Chandrayaan‐1 Moon Mineralogy Mapper (M 3 ) spectra. Whereas earlier studies of laboratory reflectance spectra focused only on complications due to chromite inclusions in lunar olivines, we develop a systematic approach for addressing (through continuum removal) the prominent continuum slopes common to remotely sensed reflectance spectra of planetary surfaces. We have validated our continuum removal on a suite of laboratory reflectance spectra. Suites of olivine‐dominated reflectance spectra from a small crater near Mare Moscoviense, the Copernicus central peak, Aristarchus, and the crater Marius in the Marius Hills were analyzed. Spectral diversity was detected in visual evaluation of the spectra and was quantified using the MGM. The MGM‐derived band positions are used to estimate the olivine's composition in a relative sense. Spectra of olivines from Moscoviense exhibit diversity in their absorption features, and this diversity suggests some variation in olivine Fe/Mg content. Olivines from Copernicus are observed to be spectrally homogeneous and thus are predicted to be more compositionally homogeneous than those at Moscoviense but are of broadly similar composition to the Moscoviense olivines. Olivines from Aristarchus and Marius exhibit clear spectral differences from those at Moscoviense and Copernicus but also exhibit features that suggest contributions from other phases. If the various precautions discussed here are weighed carefully, the methods presented here can be used to make general predictions of absolute olivine composition (Fe/Mg content).

Journal of Geophysical Research E: Planets↗

USGS2007

Thermal infrared spectroscopy and modeling of experimentally shocked basalts

New measurements of thermal infrared emission spectra (250-1400 cm -1 ; ∼7-40 μm) of experimentally shocked basalt and basaltic andesite (17-56 GPa) exhibit changes in spectral features with increasing pressure consistent with changes in the structure of plagioclase feldspars. Major spectral absorptions in unshocked rocks between 350-700 cm -1 (due to Si-O-Si octahedral bending vibrations) and between 1000-1250 cm -1 (due to Si-O antisymmetric stretch motions of the silica tetrahedra) transform at pressures >20-25 GPa to two broad spectral features centered near 950-1050 and 400-450 cm -1 . Linear deconvolution models using spectral libraries composed of common mineral and glass spectra replicate the spectra of shocked basalt relatively well up to shock pressures of 20-25 GPa, above which model errors increase substantially, coincident with the onset of diaplectic glass formation in plagioclase. Inclusion of shocked feldspar spectra in the libraries improves fits for more highly shocked basalt . However, deconvolution models of the basaltic andesite select shocked feldspar end-members even for unshocked samples, likely caused by the higher primary glass content in the basaltic andesite sample.

American Mineralogist↗

USGS2001

Mineralogy of the last lunar basalts: Results from Clementine

The last major phase of lunar volcanism produced extensive high-titanium mare deposits on the western nearside which remain unsampled by landing missions. The visible and near-infrared reflectance properties of these basalts are examined using Clementine multispectral images to better constrain their mineralogy. A much stronger 1 μm ferrous absorption was observed for the western high-titanium basalts than within earlier maria, suggesting that these last major mare eruptions also may have been the most iron-rich. These western basalts also have a distinctly long-wavelength, 1 μm ferrous absorption which was found to be similar for both surface soils and materials excavated from depth, supporting the interpretation of abundant olivine within these deposits. Spectral variation along flows within the Imbrium basin also suggests variations in ilmenite content along previously mapped lava flows as well as increasing olivine content within subsequent eruptions.

Journal of Geophysical Research E: Planets↗