Geology topics

M.E. Tuccillo

Publications and source records attributed to M.E. Tuccillo.

3 recordsLinked to original sources

USGS2001

Progression of natural attenuation processes at a crude-oil spill site . I. Geochemical evolution of the plume

A 16-year study of a hydrocarbon plume shows that the extent of contaminant migration and compound-specific behavior have changed as redox reactions, most notably iron reduction, have progressed over time. Concentration changes at a small scale, determined from analysis of pore-water samples drained from aquifer cores, are compared with concentration changes at the plume scale, determined from analysis of water samples from an observation well network. The small-scale data show clearly that the hydrocarbon plume is growing slowly as sediment iron oxides are depleted. Contaminants, such as ortho -xylene that appeared not to be moving downgradient from the oil on the basis of observation well data, are migrating in thin layers as the aquifer evolves to methanogenic conditions. However, the plume-scale observation well data show that the downgradient extent of the Fe 2+ and BTEX plume did not change between 1992 and 1995. Instead, depletion of the unstable Fe (III) oxides near the subsurface crude-oil source has caused the maximum dissolved iron concentration zone within the plume to spread at a rate of approximately 3 m/year. The zone of maximum concentrations of benzene, toluene, ethylbenzene and xylene (BTEX) has also spread within the anoxic plume. In monitoring the remediation of hydrocarbon-contaminated ground water by natural attenuation, subtle concentration changes in observation well data from the anoxic zone may be diagnostic of depletion of the intrinsic electron-accepting capacity of the aquifer. Recognition of these subtle patterns may allow early prediction of growth of the hydrocarbon plume.

Journal of Contaminant Hydrology↗

USGS2001

Progression of natural attenuation processes at a crude oil spill site: II. Controls on spatial distribution of microbial populations

A multidisciplinary study of a crude-oil contaminated aquifer shows that the distribution of microbial physiologic types is strongly controlled by the aquifer properties and crude oil location. The microbial populations of four physiologic types were analyzed together with permeability, pore-water chemistry, nonaqueous oil content, and extractable sediment iron. Microbial data from three vertical profiles through the anaerobic portion of the contaminated aquifer clearly show areas that have progressed from iron-reduction to methanogenesis. These locations contain lower numbers of iron reducers, and increased numbers of fermenters with detectable methanogens. Methanogenic conditions exist both in the area contaminated by nonaqueous oil and also below the oil where high hydrocarbon concentrations correspond to local increases in aquifer permeability. The results indicate that high contaminant flux either from local dissolution or by advective transport plays a key role in determining which areas first become methanogenic. Other factors besides flux that are important include the sediment Fe(II) content and proximity to the water table. In locations near a seasonally oscillating water table, methanogenic conditions exist only below the lowest typical water table elevation. During 20 years since the oil spill occurred, a laterally continuous methanogenic zone has developed along a narrow horizon extending from the source area to 50–60 m downgradient. A companion paper [J. Contam. Hydrol. 53, 369–386] documents how the growth of the methanogenic zone results in expansion of the aquifer volume contaminated with the highest concentrations of benzene, toluene, ethylbenzene, and xylenes.

Journal of Contaminant Hydrology↗

USGS1999

Iron reduction in the sediments of a hydrocarbon-contaminated aquifer

Sediments sampled at a hydrocarbon-contaminated, glacial-outwash, sandy aquifer near Bemidji, Minnesota, were analyzed for sediment-associated Fe with several techniques. Extraction with 0.5 M HCl dissolved poorly crystalline Fe oxides and small amounts of Fe in crystalline Fe oxides, and extracted Fe from phyllosilicates. Use of Ti-citrate-EDTA-bicarbonate results in more complete removal of crystalline Fe oxides. The average HCl-extractable Fe(III) concentration in the sediments closest to the crude-oil contamination (16.2 μmol/g) has been reduced by up to 30% from background values (23.8 μmol/g) as a result of Fe(III) reduction in contaminated anoxic groundwater. Iron(II) concentrations are elevated in sediments within an anoxic plume in the aquifer. Iron(II) values under the oil body (19.2 μmol/g) are as much as 4 times those in the background sediments (4.6 μmol/g), indicating incorporation of reduced Fe in the contaminated sediments. A 70% increase in total extractable Fe at the anoxic/oxic transition zone indicates reoxidation and precipitation of Fe mobilized from sediment in the anoxic plume. Scanning electron microscopy detected authigenic ferroan calcite in the anoxic sediments and confirmed abundant Fe(III) oxyhydroxides at the anoxic/oxic boundary. The redox biogeochemistry of Fe in this system is coupled to contaminant degradation and is important in predicting processes of hydrocarbon degradation.

Applied Geochemistry↗