Search USGS⌕ Search

Geology topics

M. Garces

Publications and source records attributed to M. Garces.

2 recordsLinked to original sources

Infrasound from the 2007 fissure eruptions of Kīlauea Volcano, Hawai'i

Varied acoustic signals were recorded at Kīlauea Volcano in mid-2007, coincident with dramatic changes in the volcano's activity. Prior to this time period, Pu'u 'Ō'ō crater produced near-continuous infrasonic tremor and was the primary source of degassing and lava effusion at Kīlauea. Collapse and draining of Pu'u 'Ō'ō crater in mid-June produced impulsive infrasonic signals and fluctuations in infrasonic tremor. Fissure eruptions on 19 June and 21 July were clearly located spatially and temporally using infrasound arrays. The 19 June eruption from a fissure approximately mid-way between Kīlauea's summit and Pu'u 'O'o produced infrasound for ~30 minutes-the only observed geophysical signal associated with the fissure opening. The infrasound signal from the 21 July eruption just east of Pu'u 'Ō'ō shows a clear azimuthal progression over time, indicative of fissure propagation over 12.9 hours. The total fissure propagation rate is relatively slow at 164 m/hr, although the fissure system ruptured discontinuously. Individual fissure rupture times are estimated using the acoustic data combined with visual observations.

Hawai'i↗

Infrasonic tremor observed at Kilauea Volcano, Hawai'i

[1] Infrasonic array data collected at Kīlauea Volcano, Hawai'i, during November 12–21, 2002 indicate that the active vents and lava tube system near the Pu'u 'Ō'ō vent complex emit almost continuous infrasound in the 0.3–10 Hz frequency band. The spectral content of these infrasonic signals matches well that of synchronous seismic tremor. In sites protected from wind noise, significant signal to noise ratios were recorded as far as ∼13 km from the crater of Pu'u 'Ō'ō. The infrasonic recordings suggest that one or more tremor sources may be close to the surface. In addition, these results demonstrate that adequate site and instrument selections for infrasonic arrays are essential in order to obtain consistent and reliable infrasonic detections.

Hawai'i↗