Geology topics

Lee-Gray Boze

Publications and source records attributed to Lee-Gray Boze.

4 recordsLinked to original sources

USGS2026

Production of secondary microbial methane from a gas hydrate-bearing reservoir at the HYDRATE P1 Production Test Well (PTW-1) on the Alaskan North Slope

Gas hydrate in the Alaskan North Slope (ANS) is believed to contain as much methane as the known conventional gas accumulations in the Prudhoe Bay field. The JOGMEC-DOE-USGS Collaborative Gas Hydrate R&D Project conducted an extended-duration production test from the sub-permafrost, gas-hydrate saturated B1 sand reservoir (unit B) at the Kuparuk State 7-11-12 Site in the Prudhoe Bay Unit of the ANS. Using compositional and stable isotopic data measured on gas produced from well cuttings and pressure cores collected from the HYDRATE 02 Geo Data Well (GDW), we differentiate primary microbial, secondary microbial, and trace thermogenic gas sources. The upper part of the well contained predominantly primary microbial methane from near the surface to the SV6 stratigraphic horizon at 1133 ft (345.3 m) measured depth (MD). Below that, the gas composition transitioned to a mixture of mostly primary and secondary microbial methane to near the base of ice-bearing permafrost at 1968 ft (599.8 m) MD. With greater depth to 3558 ft (1084.5 m) MD, which includes the D1 sand (unit D), the B1 sand (unit B), and the base of gas hydrate stability at 3113 ft (948.8 m) MD, the gas composition was greater than 98% secondary microbial methane with the remainder being oil-associated thermogenic gas migrated from the deep Sadlerochit Formation. The unit B vertical gas profile derived from degassed pressure cores demonstrated that gas dissolved in the clay-rich sediment intervals bounding the B1 sand reservoir was distinct from dissolved and hydrate-caged gases in the sand-rich hydrate-bearing reservoir. The HYDRATE P1 Production Test Well (PTW-1) targeted and successfully extracted gas dissociated from hydrate gas in the B1 sand for 151 days when using an electrical submersible pump to depressurize the reservoir with subsequent depressurization achieved through the use of a jet pump. Gas produced from PTW-1 was mostly indistinguishable from the gas compositional profile measured through the B1 sand and generally distinct from dissolved gas in the bounding clay-rich sediments, confirming that the upper and lower bounding units limited infiltration into the reservoir during production. Isolation of the bounding units from the reservoir contributed to the unexpectedly high ratio of production gas to water observed during the extended-duration gas hydrate production test at PTW-1.

Alaska↗

USGS2022

USGS tools perform gas source analysis in the field

Field studies of gas hydrate rely on gas sampling and analysis tools to determine the origins and alteration of methane and other hydrocarbons. The conventional strategy for deciphering gas origins has been to collect gas and other related samples in the field then pack, ship, store, and later analyze these discrete samples in a laboratory using instruments that require specialized training and dedicated operators. Two critical drawbacks to the conventional strategy are that: 1) measurements made and analyzed after completing the field program often highlight where data should have been collected; 2) discrete sampling limits the spatial or temporal measurement density, increasing the likelihood of missing small-scale natural features.

Fire in the Ice↗

USGS2020

Ryder Glacier in northwest Greenland is shielded from warm Atlantic water by a bathymetric sill

The processes controlling advance and retreat of outlet glaciers in fjords draining the Greenland Ice Sheet remain poorly known, undermining assessments of their dynamics and associated sea-level rise in a warming climate. Mass loss of the Greenland Ice Sheet has increased six-fold over the last four decades, with discharge and melt from outlet glaciers comprising key components of this loss. Here we acquired oceanographic data and multibeam bathymetry in the previously uncharted Sherard Osborn Fjord in northwest Greenland where Ryder Glacier drains into the Arctic Ocean. Our data show that warmer subsurface water of Atlantic origin enters the fjord, but Ryder Glacier’s floating tongue at its present location is partly protected from the inflow by a bathymetric sill located in the innermost fjord. This reduces under-ice melting of the glacier, providing insight into Ryder Glacier’s dynamics and its vulnerability to inflow of Atlantic warmer water.

Ryder Glacier↗

USGS2019

Pressure core analysis of geomechanical and fluid flow properties of seals associated with gas hydrate-bearing reservoirs in the Krishna-Godavari Basin, offshore India

Physical properties of the sediment directly overlying a gas hydrate reservoir provide important controls on the effectiveness of depressurizing that reservoir to extract methane from gas hydrate as an energy resource. The permeability of overlying sediment determines if a gas hydrate reservoir’s upper contact will provide an effective seal that enables efficient reservoir depressurization. Compressibility, stiffness and strength indicate how overlying sediment will deform as the in situ stress changes during production, providing engineering data for well designs. Assessing these properties requires minimally-disturbed sediment. India’s National Gas Hydrates Program Expedition 2 (NGHP-02) provided an opportunity to study these seal sediment properties, reducing disturbance from gas exsolution and bubble growth by collecting a pressure core from the seal sediment just above the primary gas hydrate reservoir at Site NGHP-02-08 in Area C of the Krishna-Godavari Basin. The effective stress chamber (ESC) and the direct shear chamber (DSC) devices in the suite of Pressure Core Characterization Tools (PCCTs) were used to measure permeability, compressibility, stiffness and shear strength at the in situ vertical stress. Geotechnical properties of the predominantly fine-grained seal layer at in situ vertical stress are in typical clay sediment ranges, with low measured permeability (0.02 mD), high compressibility (Cc = 0.26 – 0.33) and low shear strength (404 kPa). Though pressure and temperature were maintained throughout the collection and measurement process to stabilize gas hydrate, the lack of effective stress in the pressure core storage chamber and the chamber pressurization with methane-free water caused core expansion and gas hydrate in a thin coarser-grained layer to dissolve. The PCCTs can reapply in situ stress with incremental loading steps during a consolidation test to account for sediment compaction. Gas hydrate dissolution can be limited by storing cores just above freezing temperatures, and by using solid spacers to reduce the storage chamber’s free volume.

Marine and Petroleum Geology↗