Search USGS⌕ Search

Geology topics

Lee L. Landkamer

Publications and source records attributed to Lee L. Landkamer.

5 recordsLinked to original sources
USGS2013

Colloid transport in saturated porous media: Elimination of attachment efficiency in a new colloid transport model

A colloid transport model is introduced that is conceptually simple yet captures the essential features of colloid transport and retention in saturated porous media when colloid retention is dominated by the secondary minimum because an electrostatic barrier inhibits substantial deposition in the primary minimum. This model is based on conventional colloid filtration theory (CFT) but eliminates the empirical concept of attachment efficiency. The colloid deposition rate is computed directly from CFT by assuming all predicted interceptions of colloids by collectors result in at least temporary deposition in the secondary minimum. Also, a new paradigm for colloid re-entrainment based on colloid population heterogeneity is introduced. To accomplish this, the initial colloid population is divided into two fractions. One fraction, by virtue of physiochemical characteristics (e.g., size and charge), will always be re-entrained after capture in a secondary minimum. The remaining fraction of colloids, again as a result of physiochemical characteristics, will be retained “irreversibly” when captured by a secondary minimum. Assuming the dispersion coefficient can be estimated from tracer behavior, this model has only two fitting parameters: (1) the fraction of the initial colloid population that will be retained “irreversibly” upon interception by a secondary minimum, and (2) the rate at which reversibly retained colloids leave the secondary minimum. These two parameters were correlated to the depth of the Derjaguin-Landau-Verwey-Overbeek (DLVO) secondary energy minimum and pore-water velocity, two physical forces that influence colloid transport. Given this correlation, the model serves as a heuristic tool for exploring the influence of physical parameters such as surface potential and fluid velocity on colloid transport.

Water Resources Research↗
USGS2010

Influence of organic matter on the transport of Cryptosporidium parvum oocysts in a ferric oxyhydroxide-coated quartz sand saturated porous medium

To assess the effect of organic matter on the transport of Cryptosporidium parvum oocysts in a geochemically heterogeneous saturated porous medium, we measured the breakthrough and collision efficiencies of oocysts as a function of dissolved organic matter concentration in a flow-through column containing ferric oxyhydroxide-coated sand. We characterized the surface properties of the oocysts and ferric oxyhydroxide-coated sand using microelectrophoresis and streaming potential, respectively, and the amount of organic matter adsorbed on the ferric oxyhydroxide-coated sand as a function of the concentration of dissolved organic matter (a fulvic acid isolated from Florida Everglades water). The dissolved organic matter had no significant effect on the zeta potential of the oocysts. Low concentrations of dissolved organic matter were responsible for reversing the charge of the ferric oxyhydroxide-coated sand surface from positive to negative. The charge reversal and accumulation of negative charge on the ferric oxyhydroxide-coated sand led to increases in oocyst breakthrough and decreases in oocyst collision efficiency with increasing dissolved organic matter concentration. The increase in dissolved organic matter concentration from 0 to 20 mg L -1 resulted in a two-fold decrease in the collision efficiency.

Water Research↗
USGS2008

Pathogen and chemical transport in the karst limestone of the Biscayne aquifer: 3. Use of microspheres to estimate the transport potential of Cryptosporidium parvum oocysts

The vulnerability of a municipal well in the Northwest well field in southeastern Florida to potential contamination by Cryptosporidium parvum oocysts was assessed in a large‐scale, forced‐gradient (convergent) injection and recovery test. The field study involved a simultaneous pulse introduction of a nonreactive tracer (SF 6 , an inert gas) and oocyst‐sized (1.6, 2.9, and 4.9 μ m diameter) carboxylated polystyrene microspheres into karst limestone of the Biscayne aquifer characterized by a complex triple (matrix, touching‐vug, and conduit) porosity. Fractional recoveries 97 m down gradient were inversely related to diameter and ranged from 2.9% for the 4.9 μ m microspheres to 5.8% for 1.6 μ m microspheres. Their centers of mass arrived at the pumping well approximately threefold earlier than that of the nonreactive tracer SF 6 (gas), underscoring the need for use of colloid tracers and field‐scale tracer tests for these kinds of evaluations. In a modified triaxial cell using near in situ chemical conditions, 2.9 and 4.9 μ m microspheres underestimated by fourfold to sixfold the attachment potential of the less electronegative 2.9–4.1 μ m oocysts in the matrix porosity of limestone core samples. The field and laboratory results collectively suggested that it may take 200–300 m of transport to ensure even a 1‐log unit removal of oocysts, even though the limestone surfaces exhibited a substantive capability for their sorptive removal. The study further demonstrated the utility of microspheres as oocyst surrogates in field‐scale assessments of well vulnerability in limestone, provided that differences in attachment behaviors between oocysts and microspheres are taken into account.

Water Resources Research↗
USGS2007

Transport of microorganisms in the terrestrial subsurface: In situ and laboratory methods

This chapter describes and discusses laboratory and field techniques for studying microbial transport behavior in aquifer materials and model porous media. Changes in ionic strength (I) during transport studies may occur inadvertently as a result of using halides as conservative tracers and may lead to density-induced sinking of the tracer cloud. Substantive increases in I as a result of injection of high concentrations of halide tracers can also result in overestimations of microbial attachment. In order to differentiate "test" microorganisms from indigenous subsurface populations and/or from other inadvertently introduced populations, microorganisms used in laboratory or in situ transport tests are typically labeled a priori with a stable tag. Other methods of labeling microorganisms for use in in situ and column transport studies have involved the use of stable isotopes ratio mass spectrometry (IRMS). The characteristics of the conservative tracer breakthrough curve can then be used comparatively to determine some of the major transport parameters exhibited by the introduced microorganisms. Most controlled field investigations of subsurface microbial transport are conducted on limited spatial scales relative to the scales of interest to those concerned with pathogen transport to water supply wells, with microbially enhanced oil recovery from petroleum reservoirs, and with the feasibility of using introduced bacteria for aquifer restoration.

Book chapter↗