Search USGSSearch

Geology topics

L. Wald

Publications and source records attributed to L. Wald.

2 recordsLinked to original sources

Integration of P- and SH-wave high-resolution seismic reflection and micro-gravity techniques to improve interpretation of shallow subsurface structure: New Madrid seismic zone

Shallow high-resolution seismic reflection surveys have traditionally been restricted to either compressional (P) or horizontally polarized shear (SH) waves in order to produce 2-D images of subsurface structure. The northernmost Mississippi embayment and coincident New Madrid seismic zone (NMSZ) provide an ideal laboratory to study the experimental use of integrating P- and SH-wave seismic profiles, integrated, where practicable, with micro-gravity data. In this area, the relation between "deeper" deformation of Paleozoic bedrock associated with the formation of the Reelfoot rift and NMSZ seismicity and "shallower" deformation of overlying sediments has remained elusive, but could be revealed using integrated P- and SH-wave reflection. Surface expressions of deformation are almost non-existent in this region, which makes seismic reflection surveying the only means of detecting structures that are possibly pertinent to seismic hazard assessment. Since P- and SH-waves respond differently to the rock and fluid properties and travel at dissimilar speeds, the resulting seismic profiles provide complementary views of the subsurface based on different levels of resolution and imaging capability. P-wave profiles acquired in southwestern Illinois and western Kentucky (USA) detect faulting of deep, Paleozoic bedrock and Cretaceous reflectors while coincident SH-wave surveys show that this deformation propagates higher into overlying Tertiary and Quaternary strata. Forward modeling of micro-gravity data acquired along one of the seismic profiles further supports an interpretation of faulting of bedrock and Cretaceous strata. The integration of the two seismic and the micro-gravity methods therefore increases the scope for investigating the relation between the older and younger deformation in an area of critical seismic hazard. ?? 2006 Elsevier B.V. All rights reserved.

Tectonophysics

Preliminary report on the 16 October 1999 M 7.1 Hector mine, California, earthquake

The M w 7.1 Hector Mine, California, earthquake occurred at 9:46 GMT on 16 October 1999. The event caused minimal damage because it was located in a remote, sparsely populated part of the Mojave Desert, approximately 47 miles east-southeast of Barstow, with epicentral coordinates 34.59°N 116.27°W and a hypocentral depth of 5 ± 3 km. Twelve foreshocks, M 1.9-3.8, preceded the mainshock during the previous twelve hours. All of these events were located close to the hypocenter of the mainshock. The Hector Mine earthquake occurred within the Eastern California Shear Zone (ECSZ). By virtue of its remote location, the societal impact of the Hector Mine earthquake was, fortunately, minimal in spite of the event's appreciable size. The ECSZ is characterized by high seismicity, a high tectonic strain rate, and a broad, distributed zone of north-northwest-trending faults (ECSZ; Figure 1 ; Dokka and Travis, 1990 ; Sauber et al., 1986 ; Sauber et al., 1994 ; Sieh et al., 1993 ). Data regarding the slip rates of faults within the ECSZ suggest that on the order of 15% of the Pacific-North American plate motion occurs along this zone ( Sauber et al., 1986 ; Wesnousky, 1986 ). Most of the faults in the ECSZ have low slip rates and long repeat times for major earthquakes, on the order of several thousands to tens of thousands of years. The occurrence of the Hector Mine earthquake within seven years and only about 30 km east of the 1992 M w 7.3 Landers earthquake suggests that the closely spaced surface faults in the ECSZ are mechanically related. The Hector Mine event involved rupture on two previously mapped fault zones—the Bullion Fault and an unnamed, more northerly-trending fault that is informally referred to in this paper as the Lavic Lake Fault (Dibblee, 1966 , 1967a , b ). Traces of the Bullion Fault exhibit evidence of Holocene displacement and were zoned as active in 1988 under California's Mquist-Priolo Earthquake Fault Zoning Act ( Hart and Bryant, 1997 ). The pattern of rupture along more than one named fault was also observed from the 1992 Landers earthquake ( Hauksson et al., 1993 ; Sieh et al., 1994). Much of the fault zone that produced the Hector Mine earthquake had been buried by relatively young stream deposits, and the fault scarps in bedrock have a subdued morphology. It appears that these faults have not experienced significant offset for perhaps 10,000 years or more ( Hart, 1987 ). Planned future investigations will refine the age of the last event on these faults. The portion of the Lavic Lake Fault that ruptured between the northern end of the Bullion Mountains and Lavic Lake had not previously been mapped. However, our field investigations have identified ancient, subdued fault scarps along portions of the 1999 rupture zone in this area. It thus appears that the entire segment of the Lavic Lake Fault that was involved in the 1999 event had ruptured in the past. As is typical for most faults within the Eastern California Shear Zone, the rate of movement along the Lavic Lake Fault may be quite slow (<1 mm/yr) and should produce earthquakes only infrequently. This event is a reminder that faults that have ruptured in late Quaternary time, but that lack evidence of Holocene displacement, can still produce earthquakes in this low-slip-rate tectonic setting. Additionally, the Hector Mine earthquake is noteworthy for a couple of other reasons. First, it clearly produced triggered seismicity over much of southern California, from the rupture zone toward the south-southwest in particular. Second, as we will discuss, the event may provide new data and insight into recently developed paradigms concerning earthquake interactions and the role of static stress changes. Questions such as these will, of course, be the subject of extensive detailed analyses in years to come. Fortunately, the Hector Mine sequence will provide one of the best data sets obtained to date for a significant earthquake in the United States. Because it occurred when major upgrades to both the regional seismic network (TriNet) and the regional geodetic network (SCIGN) were well underway, the Earth science community will have abundant high-quality data with which to explore the important and interesting questions that have been raised. In this paper, we present and discuss the basic data and preliminary results from the Hector Mine earthquake.

California