Search USGSSearch

Geology topics

L. A. Mayer

Publications and source records attributed to L. A. Mayer.

9 recordsLinked to original sources

Dissolution of biogenic ooze over basement edifices in the equatorial Pacific with implications for hydrothermal ventilation of the oceanic crust

Recent observations indicate that curious closed depressions in carbonate sediments overlying basement edifices are widespread in the equatorial Pacific. A possible mechanism for their creation is dissolution by fluids exiting basement vents from off-axis hydrothermal flow. Quantitative analysis based on the retrograde solubility of calcium carbonate and cooling of basement fluids during ascent provides an estimate for the dissolution capacity of the venting fluids. Comparison of the dissolution capacity and fluid flux with typical equatorial Pacific carbonate mass accumulation rates shows that this mechanism is feasible. By maintaining sediment-free basement outcrops, the process may promote widespread circulation of relatively unaltered seawater in the basement in an area where average sediment thicknesses are 300–500 m. The enhanced ventilation can explain several previously puzzling observations in this region, including anomalously low heat flux, relatively unaltered seawater in the basement, and aerobic and nitrate-reducing microbial activity at the base of the sediments.

Geology

Shelf-edge deltas and drowned barrier-island complexes on the northwest Florida outer continental shelf

A high-resolution multibeam survey of the northwest Florida shelf mapped six relict shelf-edge deltas, each with a drowned barrier-island system developed on its south and southwestern rims. The deltas appear to have formed during periods of sea-level stasis that occurred between 58,000 and 28,000 years ago. The barrier islands formed on the deltas during periods of slow regression during this same time interval. Large fields of asymmetric dunes are found on the delta surfaces as well as on the south and southwestern flanks of the deltas. The asymmetry and orientation of the dunes suggest that a northward-flowing current was sheared by the presence of the delta topography, and as a result, the upper layer of the flow continued to the north, whereas the lower layer was steered by the topography. The topographic steering accelerated the northward flow around the south and southwestern flanks with speeds adequate to form large dunes. The flow slowed after rounding southwestern flank but accelerated again as it encountered the next delta flank to the north. The age of the dune formation is unknown, and no northward-flowing geostrophic flow has been reported in the literature from this area. ?? 2004 Elsevier B.V. All rights reserved.

Geomorphology

Morphology, volcanism, and mass wasting in Crater Lake, Oregon

Crater Lake was surveyed nearly to its shoreline by high-resolution multibeam echo sounding in order to define its geologic history and provide an accurate base map for research and monitoring surveys. The bathymetry and acoustic backscatter reveal the character of landforms and lead to a chronology for the concurrent filling of the lake and volcanism within the ca. 7700 calibrated yr B.P. caldera. The andesitic Wizard Island and central-plattform volcanoes are composed of sequences of lava deltas that record former lake levels and demonstrate simultaneous activity at the two vents. Wizard Island eruptions ceased when the lake was ~80 m lower than at present. Lava streams from prominent channels on the surface of the central platform descended to feed extensive subaqueous flow fields on the caldera floor. The Wizard Island and central-platform volcanoes, andesitic Merriam Cone, and a newly discovered probable lava flow on the eastern floor of the lake apparently date from within a few hundred years of caldera collapse, whereas a small rhydacite dome was emplaced on the flank of Wizard Island at ca. 4800 cal. yr B.P. Bedrock outcrops on the submerged caldera walls are shown in detail and, in some cases, can be correlated with exposed geologic units of Mount Mazama. Fragmental debris making up the walls elsewhere consists of narrow talus cones forming a dendritic pattern that leads to fewer, wider ridges downslope. Hummocky topography and scattered blocks up to ~280 m long below many of the embayments in the caldera wall mark debris-avalanche deposits that probably formed in single events and commonly are affected by secondary failures. The flat-floored, deep basins contain relatively fine-grained sediment transported from the debris aprons by sheet-flow turbidity currents. Crater Lake apparently filled rapidly (ca. 400-750 yr) until reaching a permeable layer above glaciated lava identified by the new survey in the northeast caldera wall at ~1845 m elevation. Thereafter, a gradual, climatically modulated rise in lake level to the present 1883 m produced a series of beaches culminating in a modern wave-cut platform, commonly ~40 m wide, where suitable material is present. The new survey reveals landforms that result from intermediate-composition volcanism in rising water, delineates mass wasting and sediment transport into a restricted basin, and yields a more accurate postcaldera history leading to improved assessment of volcanic hazards.

Oregon

Interactive 3-D visualization: A tool for seafloor navigation, exploration and engineering

Recent years have seen remarkable advances in sonar technology, positioning capabilities, and computer processing power that have revolutionized the way we image the seafloor. The massive amounts of data produced by these systems present many challenges but also offer tremendous opportunities in terms of visualization and analysis. The authors have developed a suite of interactive 3D visualization and exploration tools specifically designed to facilitate the interpretation and analysis of very large (10s to 100s of megabytes), complex, multi-component spatial data sets. If properly georeferenced and treated, these complex data sets can be presented in a natural and intuitive manner that allows the integration of multiple components each at their inherent level of resolution and without compromising the quantitative nature of the data. Artificial sun-illumination, shading, and 3D rendering can be used with digital bathymetric data (DTMs) to form natural looking and easily interpretable, yet quantitative, landscapes. Color can be used to represent depth or other parameters (like backscatter or sediment properties) which can be draped over the DTM, or high resolution imagery can be texture mapped on bathymetric data. When combined with interactive analytical tools, this environment has facilitated the use of multibeam sonar and other data sets in a range of geologic, environmental, fisheries, and engineering applications.

Conference Paper