Geology topics

Kevin Oberg

Publications and source records attributed to Kevin Oberg.

11 recordsLinked to original sources

USGS2023

Improvements to estimate ADCP uncertainty sources for discharge measurements

The use of moving boat ADCPs (Acoustic Doppler Current Profilers) for discharge measurements requires identification of the sources and magnitude of uncertainty to ensure accurate measurements. Recently, a tool known as QUant was developed to estimate the contribution to the uncertainty estimates for each transect of moving-boat ADCP discharge measurements, by varying different sampling configurations parameters through the use of Monte Carlo simulations. QUant is not only useful for estimating ADCP discharge measurement uncertainty, but also for identifying contributions of the various sources of uncertainty. However, the software requires long computational times, and the method to estimate the uncertainty of multiple-transect measurements does not consider the correlation of the variables between transects. Therefore, improvements in QUant are needed to optimize its application for practical purposes by hydrographers immediately after discharge measurements. This work presents four approaches for optimizing the performance of QUant to estimate the contribution to the uncertainty of different selected variables on ADCP discharge measurements and describes a new method of estimating multi-transect uncertainty with the QUant model that considers the correlation of errors in selected variables between transects. The approaches for optimization and the new multi-transect uncertainty method are evaluated using a dataset of 38 field measurements from a variety of riverine settings.

Flow Measurement and Instrumentation↗

USGS2021

Dynamic selection of exposure time for turbulent flow measurements

The selection of optimum sampling configurations to measure the aspects of turbulent flow of water depends on the variable being measured, the applied measurement technique, the degree of environmental noise, and flow characteristics in and near the sampling location. This work presents a method to dynamically select the exposure time (SET) during the flow-velocity measurement at each sampling location on the basis of the moving block bootstrap (MBB) technique. The MBB enables near real-time estimation of the confidence intervals and, subsequently, the COV for turbulence parameters. The dynamic SET method has been tested in this work using time series of synthetic turbulent flow-velocity signals. This method was implemented using actual flow-velocity signals recorded with acoustic Doppler velocity (ADVs) instruments and acoustic Doppler current profilers (ADCPs). The results obtained from the implementation of the dynamic SET method show that the sampling time to achieve a defined uncertainty threshold is not the same for different turbulence parameters. Consequently, using the dynamic SET method, the exposure time can be optimized to obtain the turbulence parameters with the required uncertainty level. The dynamic SET method can be implemented in the instrument’s data logger to dynamically select the exposure time during flow measurements for a given uncertainty of the required turbulence parameter.

Journal of Hydraulic Engineering↗

USGS2020

Dunes in the world's big rivers are characterized by low-angle lee-side slopes and a complex shape

Dunes form critical agents of bedload transport in all of the world’s big rivers, and constitute appreciable sources of bed roughness and flow resistance. Dunes also generate stratification that is the most common depositional feature of ancient riverine sediments. However, current models of dune dynamics and stratification are conditioned by bedform geometries observed in small rivers and laboratory experiments. For these dunes, the downstream lee-side is often assumed to be simple in shape and sloping at the angle of repose. Here we show, using a unique compilation of high-resolution bathymetry from a range of large rivers, that dunes are instead characterized predominantly by low-angle lee-side slopes (<10°), complex lee-side shapes with the steepest portion near the base of the lee-side slope and a height that is often only 10% of the local flow depth. This radically different shape of river dunes demands that such geometries are incorporated into predictions of flow resistance, water levels and flood risk and calls for rethinking of dune scaling relationships when reconstructing palaeoflow depths and a fundamental reappraisal of the character, and origin, of low-angle cross-stratification within interpretations of ancient alluvial sediments.

Nature Geoscience↗

USGS2020

Comparing discharge computation methods in the Great Lakes connecting channels

Records of discharge for the connecting channels within the Great Lakes Basin are important to national governments of Canada and the United States and the various water management agencies and users in the basin. For more than 100 years, the official discharge records for the St. Clair and Detroit Rivers, two connecting channels within the Great Lakes Basin, have been computed using various stage-fall-discharge (SFQ) methods. However, as a result of technological advancements, newer methods have recently been considered for discharge computations. In this study, three discharge computation methods were compared: two SFQ methods and the index-velocity discharge (IVQ) method. Although the two SFQ methods have significantly different assumptions and use different data from the index-velocity method, the differences between the computed discharges derived from the methods are small, especially as the time step approaches monthly discharge values. Statistical analyses of discharge measurements and discharges computed using each of these methods indicate that there is no substantive difference in the discharges computed using the three methods. However, the IVQ method provides distinct advantages over the SFQ methods, including increased temporal resolution of computed discharge (minutes versus daily) and the ability to account for changes caused by aquatic vegetation and ice. Based on the results of the comparisons described herein, the IVQ discharge computation method is the most appropriate method for discharge computation in the St. Clair and Detroit Rivers. Updated SFQ equations for the St. Clair and Detroit Rivers, also presented herein, can be used to compute discharge during periods of missing or invalid IVQ record.

Indiana, Michigan, Minnesota, New York, Ohio, Onta↗

USGS2019

Estimating sand concentrations using ADCP‐based acoustic inversion in a large fluvial system characterized by bi‐modal suspended‐sediment distributions

Quantifying sediment flux within rivers is a challenge for many disciplines due, mainly, to difficulties inherent to traditional sediment sampling methods. These methods are operationally complex, high cost, and high risk. Additionally, the resulting data provide a low spatial and temporal resolution estimate of the total sediment flux, which has impeded advances in the understanding of the hydro‐geomorphic characteristics of rivers. Acoustic technologies have been recognized as a leading tool for increasing the resolution of sediment data by relating their echo intensity level measurements to suspended sediment. Further effort is required to robustly test and develop these techniques across a wide range of conditions found in natural river systems. This article aims to evaluate the application of acoustic inversion techniques using commercially available, down‐looking acoustic Doppler current profilers (ADCPs) in quantifying suspended sediment in a large sand bed river with varying bi‐modal particle size distributions, wash load and suspended‐sand ratios, and water stages. To achieve this objective, suspended sediment was physically sampled along the Paraná River, Argentina, under various hydro‐sedimentological regimes. Two ADCPs emitting different sound frequencies were used to simultaneously profile echo intensity level within the water column. Using the sonar equation, calibrations were determined between suspended‐sand concentrations and acoustic backscatter to solve the inverse problem. The study also analyzed the roles played by each term of the sonar equation, such as ADCP frequency, power supply, instrument constants, and particle size distributions typically found in sand bed rivers, on sediment attenuation and backscatter. Calibrations were successfully developed between corrected backscatter and suspended‐sand concentrations for all sites and ADCP frequencies, resulting in mean suspended‐sand concentration estimates within about 40% of the mean sampled concentrations. Noise values, calculated using the sonar equation and sediment sample characteristics, were fairly constant across evaluations, suggesting that they could be applied to other sand bed rivers.

Earth Surface Processes and Landforms↗

USGS2012

Role of turbulence fluctuations on uncertainties of acoutic Doppler current profiler discharge measurements

This work presents a systematic analysis quantifying the role of the presence of turbulence fluctuations on uncertainties (random errors) of acoustic Doppler current profiler (ADCP) discharge measurements from moving platforms. Data sets of three-dimensional flow velocities with high temporal and spatial resolution were generated from direct numerical simulation (DNS) of turbulent open channel flow. Dimensionless functions relating parameters quantifying the uncertainty in discharge measurements due to flow turbulence (relative variance and relative maximum random error) to sampling configuration were developed from the DNS simulations and then validated with field-scale discharge measurements. The validated functions were used to evaluate the role of the presence of flow turbulence fluctuations on uncertainties in ADCP discharge measurements. The results of this work indicate that random errors due to the flow turbulence are significant when: (a) a low number of transects is used for a discharge measurement, and (b) measurements are made in shallow rivers using high boat velocity (short time for the boat to cross a flow turbulence structure).

Water Resources Research↗

USGS2012

Sediment mobility and bed armoring in the St Clair River: insights from hydrodynamic modeling

The lake levels in Lake Michigan-Huron have recently fallen to near historical lows, as has the elevation difference between Lake Michigan-Huron compared to Lake Erie. This decline in lake levels has the potential to cause detrimental impacts on the lake ecosystems, together with social and economic impacts on communities in the entire Great Lakes region. Results from past work suggest that morphological changes in the St Clair River, which is the only natural outlet for Lake Michigan-Huron, could be an appreciable factor in the recent trends of lake level decline. A key research question is whether bed erosion within the river has caused an increase in water conveyance, therefore, contributed to the falling lake level. In this paper, a numerical modeling approach with field data is used to investigate the possibility of sediment movement in the St Clair River and assess the likelihood of morphological change under the current flow regime. A two-dimensional numerical model was used to study flow structure, bed shear stress, and sediment mobility/armoring over a range of flow discharges. Boundary conditions for the numerical model were provided by detailed field measurements that included high-resolution bathymetry and three-dimensional flow velocities. The results indicate that, without considering other effects, under the current range of flow conditions, the shear stresses produced by the river flow are too low to transport most of the coarse bed sediment within the reach and are too low to cause substantial bed erosion or bed scour. However, the detailed maps of the bed show mobile bedforms in the upper St Clair River that are indicative of sediment transport. Relatively high shear stresses near a constriction at the upstream end of the river and at channel bends could cause local scour and deposition. Ship-induced propeller wake erosion also is a likely cause of sediment movement in the entire reach. Other factors that may promote sediment movement, such as ice cover and dredging in the lower river, require further investigation.

St. Clair River↗

USGS2012

Variance of discharge estimates sampled using acoustic Doppler current profilers from moving boats

This paper presents a model for quantifying the random errors (i.e., variance) of acoustic Doppler current profiler (ADCP) discharge measurements from moving boats for different sampling times. The model focuses on the random processes in the sampled flow field and has been developed using statistical methods currently available for uncertainty analysis of velocity time series. Analysis of field data collected using ADCP from moving boats from three natural rivers of varying sizes and flow conditions shows that, even though the estimate of the integral time scale of the actual turbulent flow field is larger than the sampling interval, the integral time scale of the sampled flow field is on the order of the sampling interval. Thus, an equation for computing the variance error in discharge measurements associated with different sampling times, assuming uncorrelated flow fields is appropriate. The approach is used to help define optimal sampling strategies by choosing the exposure time required for ADCPs to accurately measure flow discharge.

Journal of Hydraulic Engineering↗

USGS2010

A new methodology for the quantitative visualization of coherent flow structures in alluvial channels using multibeam echo-sounding (MBES)

In order to investigate the interactions between turbulence and suspended sediment transport in natural aqueous environments, we ideally require a technique that allows simultaneous measurement of fluid velocity and sediment concentration for the whole flow field. Here, we report on development of a methodology using the water column acoustic backscatter signal from a multibeam echo sounder to simultaneously quantify flow velocities and sediment concentrations. The application of this new technique is illustrated with reference to flow over the leeside of an alluvial sand dune, which allows, for the first time in a field study, quantitative visualization of large-scale, whole flow field, turbulent coherent flow structures associated with the dune leeside that are responsible for suspending bed sediment. This methodology holds great potential for use in a wide range of aqueous geophysical flows.

Geophysical Research Letters↗

USGS2009

Discharge and other hydraulic measurements for characterizing the hydraulics of Lower Congo River

The first direct measurements of discharge of the Lower Congo River below Malebo Pool and upstream from Kinganga, Democratic Republic of Congo (DRC) were made in July 2008 using acoustic Doppler current profilers, differential GPS, and echo sounders. These measurements were made in support of research that is attempting to understand the distribution of fish species in the Lower Congo River and reasons for separation of species within this large river. Analyses of these measurements show that the maximum depth in the Lower Congo River was in excess of 200 m and maximum water velocities were greater than 4 m/s. The discharge measured near Luozi, DRC was 35,800 m3/s, and decreased slightly beginning midway through the study. Local bedrock controls seem to have a large effect on the flow in the river, even in reaches without waterfalls and rapids. Dramatic changes in bed topography are evident in transects across the river.

Congo River and Malebo Pool↗

USGS2009

The effect of channel shape, bed morphology, and shipwrecks on flow velocities in the Upper St. Clair River

In the Great Lakes of North America, the St. Clair River is the major outlet of Lake Huron and conveys water to Lake St. Clair which then flows to Lake Erie. One major topic of interest is morphological change in the St. Clair River and its impact on water levels in the Upper Great Lakes and connecting channel flows. A combined multibeam echosounder (MBES) bathymetric survey and acoustic Doppler current profiler (ADCP) flow survey of the outlet of Lake Huron and the Upper St. Clair River was conducted July 21-25, 2008. This paper presents how channel morphology and shipwrecks affect the flow in the Upper St. Clair River. The river is most constricted at the Blue Water Bridge near Port Huron, Michigan, with water velocities over 2 ms-1 for a flow of 5,200 m 3 s-1. Downstream of this constriction, the river flows around a bend and expands creating a large recirculation zone along the left bank due to flow separation. This recirculation zone reduces the effective channel width, and thus increases flow velocities to over 2 ms-1 in this region. The surveys reveal several shipwrecks on the bed of the St. Clair River, which possess distinct wakes in their flow velocity downstream of the wrecks. The constriction and expansion of the channel, combined with forcing of the flow by bed topography, initiates channel-scale secondary flow, creating streamwise vortices that maintain coherence downstream over a distance of several channel widths.

Upper St. Clair River↗