Search USGS⌕ Search

Geology topics

Kaitlyn M. Finkelstein

Publications and source records attributed to Kaitlyn M. Finkelstein.

4 recordsLinked to original sources

Spatiotemporal variability of algal biomass and nitrate in Owasco and Seneca Lakes in the Finger Lakes Region, New York, in 2019

Cyanobacterial harmful algal blooms (CyanoHABs) have become increasingly common, threatening the security of water resources globally. The U.S. Geological Survey conducted high-resolution nearshore mapping surveys using boat-mounted multiparameter sondes and nitrate sensors during the summer and fall of 2019 on Owasco Lake and Seneca Lake, two lakes with documented CyanoHABs in the Finger Lakes region of New York State. Discrete sensor measurements and water-quality samples were collected at fixed points along survey routes and continuous data were generated at open-water monitoring platforms. This investigation examined whether water-quality information from nearshore surveys was representative of open-water conditions and if nearshore surveys could be used to identify areas with localized nearshore CyanoHABs and potential sources of nutrients not captured by tributary sampling. In addition to comparisons across methods, nearshore concentrations of nitrate and chlorophyll were evaluated relative to tributary outlets, cyanobacterial abundance and biovolume at discrete locations, and the locations of near-surface CyanoHABs that were designated as “confirmed with high toxins” by the New York State Department of Environmental Conservation. Nitrate and chlorophyll concentrations were comparable across methods for each lake, although concentration ranges were typically higher for nearshore mapping datasets than for nearshore discrete datasets. Nearshore surveys indicated areas of nitrate enrichment that varied temporally in both lakes. Orthophosphate was not routinely detected. Across methods, median chlorophyll concentrations were higher for the summer survey than for the fall survey in Owasco Lake. Nearshore chlorophyll concentrations varied more temporally in Owasco Lake than in Seneca Lake. Phytoplankton and cyanobacterial abundance and biovolume were about five times higher in Owasco Lake than in Seneca Lake. Cyanobacteria dominated the phytoplankton community in most samples, and Microcystis comprised the bulk of the cyanobacterial biovolume. The most abundant potential cyanotoxin-producing (specifically microcystins) genera were Microcystis , Synechococcus , Aphanocapsa , and Pseudanabaena . The cyanobacterial community composition was comparable between open-water monitoring platforms and nearshore samples. Microcystins were detected in seven survey samples from Owasco Lake, in one survey sample from Seneca Lake, and in one sample each from the open-water monitoring platforms on Owasco and Seneca Lakes that were collected about 7 days before the fall surveys. Microcystin detections were not consistently associated with high cyanobacterial cell counts or cyanotoxin-producing genera. Results from nearshore surveys were comparable to open-water monitoring platforms and discrete nearshore observations in the absence of nearshore or open-water CyanoHABs in these systems during the study. Patterns of nearshore concentrations of nitrate and chlorophyll from nearshore surveys may aid in the identification of areas with localized nitrate loading and shifts in phytoplankton abundance and community composition.

New York↗

Evaluation of sensors for continuous monitoring of harmful algal blooms in the Finger Lakes region, New York, 2019 and 2020

In response to the increasing frequency of cyanobacterial harmful algal blooms (CyanoHABs) in the Finger Lakes region of New York State, a pilot study by the U.S. Geological Survey, in collaboration with the New York State Department of Environmental Conservation, was conducted to enhance CyanoHAB monitoring and understanding. High-frequency sensors were deployed on open water monitoring-station platforms at Seneca Lake in 2019–20, at Owasco Lake in 2019–20, and at Skaneateles Lake in 2019. One of the goals of this study was to evaluate the ability of in-place sensors to make representative measurements of dissolved organic matter, nutrients, and algal pigments (as indicators of phytoplankton biomass) while collecting routine field parameters (water temperature, specific conductance, pH, dissolved oxygen, turbidity, weather, and light) to provide additional information about environmental conditions. Despite challenges like power issues and sensor fouling, the sensors performed well overall. However, correlation analyses between sensor readings and laboratory measurements revealed variable performance. Results indicate the relation between the fluorescent dissolved organic matter sensor and laboratory-measured dissolved organic carbon was weak at all study lakes. The nitrate sensors can be sensitive to ambient temperature and have a substantial power requirement, and the relation between sensor- and laboratory-measured nitrate values differed among lakes. The orthophosphate sensors, which were complex and prone to data loss, yielded results that were difficult to interpret because orthophosphate detections are rare in the study lakes. The multichannel fluorometer was also complex to use and required several unique procedures for its operation. Chlorophyll measurements from the fluorometers correlated moderately well with laboratory-measured chlorophyll- a , although relations with total phytoplankton biovolume were weaker. Relations between phycocyanin concentration measurements from the dual-channel fluorometers and cyanobacterial biovolume were not significant; however, the cyanobacterial biovolume correlation was moderately strong with chlorophyll contribution from cyanobacteria measurements from the multichannel fluorometer. Of all collected parameters, water temperature was among the strongest correlated with chlorophyll- a , total phytoplankton biovolume, and cyanobacterial biovolume. Stepwise regression analysis was used to identify the best parameters for modeling variance in laboratory measures of phytoplankton biomass. This analysis included factors such as chlorophyll fluorescence, pH, water temperature, and others, which varied by lake. Overall, the models had limited explanatory power for chlorophyll- a and other biovolumes, possibly due to the absence of CyanoHABs at the open-water monitoring locations. Multivariate models did not outperform simple fluorescence-based models. Notably, turbidity was a more significant indicator of cyanobacterial biovolume variability than phycocyanin from dual-channel fluorometers. The study concludes that while single and multivariate models based on sensor data are useful, they did not explain any more variance than fluorescence-based models. Broader data collection, including more CyanoHAB events, is necessary to refine these models. Integrating machine learning could leverage large, complex datasets to improve CyanoHAB predictions, thereby enhancing the management and understanding of these blooms.

New York↗

Pharmaceutical manufacturing facility discharges can substantially increase the pharmaceutical load to U.S. wastewaters

Discharges from pharmaceutical manufacturing facilities (PMFs) previously have been identified as important sources of pharmaceuticals to the environment. Yet few studies are available to establish the influence of PMFs on the pharmaceutical source contribution to wastewater treatment plants (WWTPs) and waterways at the national scale. Consequently, a national network of 13 WWTPs receiving PMF discharges, six WWTPs with no PMF input, and one WWTP that transitioned through a PMF closure were selected from across the United States to assess the influence of PMF inputs on pharmaceutical loading to WWTPs. Effluent samples were analyzed for 120 pharmaceuticals and pharmaceutical degradates. Of these, 33 pharmaceuticals had concentrations substantially higher in PMF-influenced effluent (maximum 555,000 ng/L) compared to effluent from control sites (maximum 175 ng/L). Concentrations in WWTP receiving PMF input are variable, as discharges from PMFs are episodic, indicating that production activities can vary substantially over relatively short (several months) periods and have the potential to rapidly transition to other pharmaceutical products. Results show that PMFs are an important, national-scale source of pharmaceuticals to the environment.

Science of the Total Environment↗