K.W. Ramsey | Search USGS

USGS2000

An updated Holocene sea-level curve for the Delaware coast

We present an updated Holocene sea-level curve for the Delaware coast based on new calibrations of 16 previously published radiocarbon dates (Kraft, 1976; Belknap and Kraft, 1977) and 22 new radiocarbon dates of basal peat deposits. A review of published and unpublished 137Cs and 210Pb analyses, and tide gauge data provide the basis for evaluating shorter-term (102 yr) sea-level trends. Paleosea-level elevations for the new basal peat samples were determined from the present vertical zonation of marsh plants relative to mean high water along the Delaware coast and the composition of plant fossils and foraminifera. Current trends in tidal range along the Delaware coast were used to reduce elevations from different locations to a common vertical datum of mean high water at Breakwater Harbor, Delaware. The updated curve is similar to Belknap and Kraft's [J. Sediment. Petrol., 47 (1977) 610-629] original sea-level curve from 12,000 to about 2000 yr BP. The updated curve documents a rate of sea-level rise of 0.9 mm/yr from 1250 yr BP to present (based on 11 dates), in good agreement with other recent sea-level curves from the northern and central U.S. Atlantic coast, while the previous curve documents rates of about 1.3 mm/yr (based on 4 dates). The precision of both estimates, however, is very low, so the significance of these differences is uncertain. A review of 210Pb and 137Cs analyses from salt marshes of Delaware indicates average marsh accretion rates of 3 mm/yr for the last 100 yr, in good agreement with shorter-term estimates of sea-level rise from tide gauge records. ?? 2000 Elsevier Science B.V.

Marine Geology↗

USGS1999

Connecting onshore and offshore near-surface geology: Delaware's sand inventory project

Beginning in 1988, the Delaware Geological Survey began a program to inventory on-land sand resources suitable for beach nourishment. The inventory included an assessment of the native beach textures using existing data and developing parameters of what would be considered suitable sand textures for Delaware's Atlantic beaches. An assessment of the economics of on-land sand resources was also conducted, and it was determined that the cost of the sand was competitive with offshore dredging costs. In addition, the sand resources were put into a geologic context for purposes of predicting which depositional environments and lithostratigraphic units were most likely to produce suitable sand resources. The results of the work identified several suitable on-land sand resource areas in the Omar and Beaverdam formations that were deposited in barrier-tidal delta and fluvial-estuarine environments, respectively. The identified on-land resources areas have not been utilized due to difficulties of truck transport and development pressures in the resource areas. The Delaware Geological Survey's participation in years 8, 9, and 10 of the Continental Margins Program was developed to extend the known resource areas onshore to offshore Delaware in order to determine potential offshore sand resources for beach nourishment. Years 8 and 9 involved primarily the collection of all available data on the offshore geology. These data included all seismic lines, surface grab samples, and cores. The data were filtered for those that had reliable locations and geologic information that could be used for geologic investigations. Year 10 completed the investigations onshore by construction of a geologic cross-section from data along the coast of Delaware from Cape Henlopen to Fenwick. This cross section identified the geologic units and potential sand resource bodies as found immediately along the coast. These units and resources are currently being extended offshore and tied to known and potential sand resources as part of the continuing cooperative effort between the Delaware Geological Survey and the Minerals Management Service's INTERMAR office as sand resources are identified in federal waters off Delaware. Offshore sand resources are found in the Pliocene Beaverdam Formation offshore where overlying Quaternary units have been stripped, in the tidal delta complexes of several Quaternary units likely equivalent to the onshore Omar Formation, and in late Pleistocene- and Holocene-age shoal complexes. Onshore lithostratigraphic units can be traced offshore and show another reason for continued geologic mapping both onshore and offshore.The Delaware Geological Survey's participation in years 8, 9, and 10 of the Continental Margins Program was developed to extend the known resource areas onshore to offshore Delaware in order to determine potential offshore sand resources for beach nourishment. Years 8 and 9 involved primarily the collection of all available data on the offshore geology. These data included all seismic lines, surface grab samples, and cores. The data were filtered for those that had reliable locations and geologic information that could be used for geologic investigations. Year 10 completed the investigations onshore by construction of a geologic cross-section from data along the coast of Delaware from cape Henlopen to Fenwick.

Marine Georesources and Geotechnology↗