Seismology inside the fault zone: Applications to fault-zone properties and rupture dynamics
No abstract available.
Scientific Drilling↗
Geology topics
K. Imanishi
Publications and source records attributed to K. Imanishi.
Source parameters of a M4.8 and its accompanying repeating earthquakes off Kamaishi, NE Japan: Implications for the hierarchical structure of asperities and earthquake cycle
We determine the source parameters of a M4.9 ?? 0.1 'characteristic earthquake' sequence and its accompanying microearthquakes at ???50 km depth on the subduction plate boundary offshore of Kamaishi, NE Japan. The microearthquakes tend to occur more frequently in the latter half of the recurrence intervals of the M4.9 ?? 0.1 events. Our results show that the microearthquakes are repeating events and they are located not only around but also within the slip area for the 2001 M4.8 event. From the hierarchical structure of slip areas and smaller stress drops for the microearthquakes compared to the M4.8 event, we infer the small repeating earthquakes rupture relatively weak patches in and around the slip area for the M4.8 event and their activity reflects a stress concentration process and/or change in frictional property (healing) at the area. We also infer the patches for the M4.9 ?? 0.1 and other repeating earthquakes undergo aseismic slip during their interseismic period. Copyright 2007 by the American Geophysical Union.
Geophysical Research Letters↗
Earthquake source parameters determined by the SAFOD Pilot Hole seismic array
We estimate the source parameters of #3 microearthquakes by jointly analyzing seismograms recorded by the 32-level, 3-component seismic array installed in the SAFOD Pilot Hole. We applied an inversion procedure to estimate spectral parameters for the omega-square model (spectral level and corner frequency) and Q to displacement amplitude spectra. Because we expect spectral parameters and Q to vary slowly with depth in the well, we impose a smoothness constraint on those parameters as a function of depth using a linear first-differenfee operator. This method correctly resolves corner frequency and Q, which leads to a more accurate estimation of source parameters than can be obtained from single sensors. The stress drop of one example of the SAFOD target repeating earthquake falls in the range of typical tectonic earthquakes. Copyright 2004 by the American Geophysical Union.
Geophysical Research Letters↗
Source parameters and rupture velocities of microearthquakes in western Nagano, Japan, determined using stopping phases
We use an inversion method based on stopping phases (Imanishi and Takeo, 2002) to estimate the source dimension, ellipticity, and rupture velocity of microearthquakes and investigate the scaling relationships between source parameters. We studied 25 earthquakes, ranging in size from M 1.3 to M 2.7, that occurred between May and August 1999 at the western Nagano prefecture, Japan, which is characterized by a high rate of shallow earthquakes. The data consist of seismograms recorded in an 800-m borehole and at 46 surface and 2 shallow borehole seismic stations whose spacing is a few kilometers. These data were recorded with a sampling frequency of 10 kHz. In particular, the 800-m-borehole data provide a wide frequency bandwidth with greatly reduced ground noise and coda wave amplitudes compared with surface recordings. High-frequency stopping phases appear in the body waves in Hilbert transform pairs and are readily detected on seismograms recorded in the 800-m borehole. After correcting both borehole and surface data for attenuation, we also measure the rise time, which is defined as the interval from the arrival time of the direct wave to the timing of the maximum amplitude in the displacement pulse. The differential time of the stopping phases and the rise times were used to obtain source parameters. We found that several microearthquakes propagated unilaterally, suggesting that all microearthquakes cannot be modeled as a simple circular crack model. Static stress drops range from approximately 0.1 to 2 MPa and do not vary with seismic moment. It seems that the breakdown in stress drop scaling seen in previous studies using surface data is simply an artifact of attenuation in the crust. The average value of rupture velocity does not depend on earthquake size and is similar to those reported for moderate and large earthquakes. It is likely that earthquakes are self-similar over a wide range of earthquake size and that the dynamics of small and large earthquakes are similar.
Bulletin of the Seismological Society of America↗