Geology topics
John W. Lane
Publications and source records attributed to John W. Lane.
Characteristics of fractures in crystalline bedrock determined by surface and borehole geophysical surveys, eastern surplus superfund site, Meddybemps, Maine
Surface and borehole geophysical methods were used to determine fracture orientation in crystalline bedrock at the Eastern Surplus Superfund Site in Meddybemps, Maine. Fracture-orientation information is needed to address concerns about the fate of contaminants in ground water at the site. Azimuthal square-array resistivity surveys were conducted at 3 locations at the site, borehole-acoustic televiewer and borehole-video logs were collected in 10 wells, and single-hole directional radar surveys were conducted in 9 wells. Borehole-video logs were used to supplement the results of other geophysical techniques and are not described in this report. Analysis of azimuthal square-array resistivity data indicated that high-angle fracturing generally strikes northeast-southwest at the three locations. Borehole-acoustic televiewer logs detected one prominent low-angle and two prominent high-angle fracture sets. The low-angle fractures strike generally north-northeast and dip about 20 degrees west-northwest. One high-angle fracture set strikes north-northeast and dips east-southeast; the other high-angle set strikes east-northeast and dips south-southeast. Single-hole directional radar surveys identified two prominent fracture sets: a low-angle set striking north-northeast, dipping west-northwest; and a high-angle fracture set striking north-northeast, dipping east-southeast. Two additional high-angle fracture sets are defined weakly, one striking east-west, dipping north; and a second striking east-west, dipping south. Integrated results from all of the geophysical surveys indicate the presence of three primary fracture sets. A low-angle set strikes north-northeast and dips west-northwest. Two high-angle sets strike north-northeast and east-northeast and dip east-southeast and south-southeast. Statistical correction of the fracture data for orientation bias indicates that high-angle fractures are more numerous than observed in the data but are still less numerous than the low-angle fractures. The orientation and distribution of water-yielding fractures sets were determined by correlating the fracture data from this study with previously collected borehole-flowmeter data. The water-yielding fractures are generally within the three prominent fracture sets observed for the total fracture population. The low-angle water-yielding fractures primarily strike north-northeast to west-northwest and dip west-northwest to south-southwest. Most of the high-angle water-yielding fractures strike either north-northeast or east-west and dip east-southeast or south. The spacing between water-yielding fractures varies but the probable average spacing is estimated to be 30 feet for low-angle fractures; 27 feet for the east-southeast dipping, high-angle fractures; and 43 feet for the south-southeast dipping, high-angle fractures. The median estimated apparent transmissivity of individual water-yielding fractures or fracture zones was 0.3 feet squared per day and ranged from 0.01 to 382 feet squared per day. Ninety-five percent of the water-yielding fractures or fracture zones had an estimated apparent transmissivity of 19.5 feet squared per day or less. The orientation, spacing, and hydraulic properties of water-yielding fractures identified during this study can be used to help estimate recharge, flow, and discharge of ground water contaminants. High-angle fractures provide vertical pathways for ground water to enter the bedrock, interconnections between low-angle fractures, and, subsequently, pathways for water flow within the bedrock along fracture planes. Low-angle fractures may allow horizontal ground-water flow in all directions. The orientation of fracturing and the hydraulic properties of each fracture set strongly affect changes in ground-water flow under stress (pumping) conditions.
Subsurface fracture measurement by polarimetric borehole radar at the Mirror Lake site
No abstract available.
Use of time-lapse attenuation-difference radar tomography methods to monitor saline tracer transport in fractured crystalline bedrock
No abstract available.
Use of multi-offset borehole-radar reflection method in fractured crystalline bedrock at Mirror Lake, Grafton County, New Hampshire
Multi-offset, single-hole, borehole-radar reflection surveys were conducted at the U.S. Geological Survey Fractured Rock Research Site at Mirror Lake, in Grafton County, New Hampshire. The study was conducted to evaluate the benefits of applying multi-offset seismic processing techniques to borehole-radar reflection surveys in fractured rock. The multi-offset reflection surveys were conducted in conjunction with a saline tracer- injection experiment. During injection, a sodium chloride (NaCl) solution was continuously pumped into a hydraulically conductive zone that was isolated by specially constructed, reusable, PVC straddle packers suspended from PVC casing. Eight common-offset borehole reflection profiles were collected within the PVC-sleeved portion of the borehole before and during the tracer injection. The offset between the transmitter and receiver antennas ranged from 6.4 to 9.9 m (meters). The common offset data were filtered, sorted into common distance-point (CDP) gathers, normal move-out (NMO) corrected, and stacked to produce a zero-offset borehole CDP profile. Comparison of the common-offset and CDP profiles indicates that multi-offset data acquisition and CDP processing; (1) increases the resolution of reflectors near the borehole, (2) decreases the effects of direct wave coupling, antenna ringing, and system noise, and (3) improves the clarity of difference images used to identify the effects of saline tracer on reflections from transmissive fractures.
Use of borehole-radar methods to monitor the movement of a saline tracer in carbonate rock at Belvidere, Illinois
Common-depth (CD) radar surveys and cross-hole radar tomography methods were used to monitor the movement of a saline tracer in a dual-porosity dolomite aquifer at Belvidere, Illinois. The tracer test was conducted using an array of six open-hole bedrock wells at the Parson’s Casket Hardware Superfund site. The injection and recovery boreholes were about 20 m (meters) apart, and the imaging boreholes were arranged to provide planar coverage across and along the anticipated tracer path. A hydraulically conductive zone identified during previous investigations was isolated using straddle packers and pumped to establish a hydraulic gradient between the injection and recovery wells. A sodium chloride (NaCl) solution was continuously injected into this zone to move the tracer across the tomographic image plane. CD cross-hole radar surveys and cross-hole tomography surveys were conducted before and periodically during the tracer injection. Background tomograms contain similar radar velocity and attenuation changes with depth, consistent with a layered dolomite that has variable porosity and electrical conductivity. Slow changes in attenuation associated with low tracer velocity permitted the acquisition of multiple CD surveys and two cross-hole tomography surveys during injection. CD surveys were used to rapidly identify the presence of tracer between wells. Attenuation-difference tomograms contain attenuation increases that delineate the spatial distribution with time of the saline tracer and show the progressive movement of the tracer within the tomographic image plane. Formation porosity and resistivities calculated from radar velocity and attenuation tomograms were used to estimate changes in fluid resistivity and tracer concentration in the tomographic image plane.
Mapping hydraulically permeable fractures using directional borehole radar and hole-to-hole tomography with a saline tracer
Reflection-mode borehole radar and transmission-mode radar tomograms image heterogeneity in the electromagnetic properties of rock. Heterogeneity may be produced by interfaces between different rock types, foliation, and fracturing. In crystalline rock, hydraulic flow is primarily through fracture networks rather than through the rock matrix. Borehole radar methods have been applied to help map flow paths in crystalline rock. Correlation of features identified in borehole radar reflection records and tomograms with hydraulic flow paths is generally uncertain because the records show responses to heterogeneity of all- kinds, not just to hydraulically permeable fractures. Even in lithologically uniform rock, it is often not possible to distinguish fractures of high hydraulic permeabilities from those with low permeabilities. It is possible to “erase” signatures from lithologic interfaces and rock fabric to identify the signatures of hydraulically permeable fractures by using a saline tracer in fractured crystalline rock because the electrical properties of the rock, except for the fractures that are open to infiltration by the brine solution, remain the same after the injection of the brine and may be removed by examining differences. Saline tracer experiments were carried out in 1995, 1996, and 1997 in the FSE well field at the Mirror Lake fractured-rock hydrology research site in Grafton County, New Hampshire. Comparisons of results from directional radar reflection surveys to well-to-well difference attenuation tomography in the same pairs of wells show generally good correspondence between the location of radar reflections and attenuation anomalies. Our results demonstrate the advantage of using a saline tracer for before-and-after difference mapping of hydraulically permeable fractures in lithologically heterogeneous rock and the utility of the coordinated use of directional borehole radar and hole-to-hole radar tomography.
Cross‐hole radar attenuation tomography using a frequency centroid down‐shift method: Consideration of non‐linear frequency dependence of EM wave attenuation
This paper presents a cross-hole radar attenuation tomography method based on analysis of the down-shift in the spectrum centroid frequency, and spectral broadening of the received radar signals. The method uses a parameter that combines centroid frequency down shift and variance increase for the projection function to construct the tomography algorithm. In comparison with other methods for estimating attenuation, the frequency down shift method is relatively insensitive to the effects of geometric spreading, antenna coupling, antenna radiation pattern,and instrument response, but the method requires the data to be broad-band so the frequency shift is easily measured. This method is well suited for difference tomography when electrically conductive tracers are used. The method was tested using cross-hole radar data acquired before and during a saline tracer injection experiment at the U.S.Geological Survey’s Fractured Rock Research Site at Mirror Lake, in Grafton County, New Hampshire. The attenuation-difference tomogram clearly outlines the location of the saline tracer within the tomography plane.
Radar tomograms at Mirror Lake, New Hampshire--3D visualization and a brine tracer experiment
No abstract available.
Application of adaptive of noise-canceling methods to ground-penetrating radar data
No abstract available.
Use of borehole-radar methods to detect a saline tracer in fractured crystalline bedrock at Mirror Lake, Grafton County, New Hampshire, USA
No abstract available.
Use of directional borehole radar and azimuthal square-array D.C. resistivity methods to characterize a crystalline-bedrock aquifer
No abstract available.
Geohydrology of the Gallup's Quarry area, Plainfield, Connecticut
The geohydrology of the Gallup's Quarry area in Plainfield, Connecticut was characterized by the U.S. Geological Survey, in cooperation with the U.S. Environmental Protection Agency, to provide a preliminary framework for future remedial efforts. Gallup's Quarry, an inactive sand and gravel pit, was the site of unregulated disposal of an unknown volume of chemical wastes from at least the summer of 1977 until January 1978. Existing information collected for the Connecticut Department of Environmental Protection during 1978-82 showed that ground water beneath Gallup's Quarry and adjacent land to the northwest was contaminated by organic and inorganic compounds. There is also some evidence for contamination of Mill Brook, which is located north and northwest of the disposal areas. Geologic mapping and subsurface data show that unconsolidated surficial materials up to 90 feet thick overlie fractured crystalline bedrock in most of the Gallup's Quarry area. The surficial materials consist primarily of stratified drift and till. Texture changes vertically and laterally within the stratified drift; grain size ranges from very coarse to fine. Till blankets the bedrock surface beneath the stratified drift and is a few feet to as much as 25 feet thick. Bedrock is exposed at land surface in a hill in the southeastern part of the quarry and slopes to depths of up to 90 feet beneath the area west and north of the disposal sites. The bedrock is a dark, fine-grained, fractured and jointed blastomylonite and hornblende gneiss of the Quinebaug Formation. It is likely that a west- northwest-trending fault is present in the bedrock beneath Gallup's Quarry; this fault, if present, may provide a preferential pathway for ground-water flow and contaminant transport. The principal horizontal direction of ground-water flow and movement of dissolved contaminants in the stratified drift was to the northwest of the waste-disposal areas toward Mill Brook in 1978. Estimates of average annual recharge based on regional analyses for 1978-91 are 30 inches in areas where stratified drift are exposed and 9.6 inches in areas where till and crystalline bedrock are exposed. The hydraulic conductivity of the coarse-grained stratified drift, identified in earlier U.S. Geological Survey studies as part of an aquifer capable of yielding large quantities of water, may be several hundred feet per day. The hydraulic conductivity of the till, based on regional information, is likely 0.04 to 24 feet per day. More detailed geohydrologic information is required to develop effective remedial programs at Gallup's Quarry, particularly in the areas north and west of the waste-disposal areas. Detailed subsurface geologic mapping and definition of head distribution and other hydraulic properties of each geohydrologic unit would indicate directions and rates of ground-water flow. Most importantly, the present extent of contamination of water and sediments throughout the area will have to be determined.
Detection of bedrock fractures and lithologic changes using borehole radar at selected sites
No abstract available.
Results of integrated surface-geophysical studies for shallow subsurface fracture detection at three New Hampshire sites
No abstract available.