Geology topics

Jodi N. Harney

Publications and source records attributed to Jodi N. Harney.

5 recordsLinked to original sources

USGS2008

Geology of Hawaii reefs

The Hawaii hot spot lies in the mantle under, or just to the south of, the Big Island of Hawaii. Two active subaerial volcanoes and one active submarine volcano reveal its productivity. Centrally located on the Pacific Plate, the hot spot is the source of the Hawaii Island Archipelago and its northern arm, the Emperor Seamount Chain (Fig. 11.1). This system of high volcanic islands and associated reefs, banks, atolls, sandy shoals, and seamounts spans over 30° of latitude across the Central and North Pacific Ocean to the Aleutian Trench, and contains at least 107 separate shield volcanoes (Clague and Dalrymple 1987). The trail of islands increases in age with distance from the hot spot (Fig. 11.2) and reflects the dynamic nature of the Pacific Plate, serving as a record of its speed and direction over the Hawaii hot spot for the last 75–80 MY (Clague and Dalrymple 1987). A major change in plate direction is marked by a northward kink in the chain at the end of the Hawaii Ridge approximately 3,500 km from the site of active volcanism (Moore 1987). On the basis of dredged basalts, Sharp and Clague (2006) assign an age of 50 Ma to this shift from northern to northwestern plate motion, thought to be a result of changes in the movement of neighboring plates to the west. Today the Pacific Plate migrates northwest at a rate of about 10 cm/year (Moore 1987).

Hawaii↗

USGS2007

Underwater microscope for measuring spatial and temporal changes in bed-sediment grain size

For more than a century, studies of sedimentology and sediment transport have measured bed-sediment grain size by collecting samples and transporting them back to the laboratory for grain-size analysis. This process is slow and expensive. Moreover, most sampling systems are not selective enough to sample only the surficial grains that interact with the flow; samples typically include sediment from at least a few centimeters beneath the bed surface. New hardware and software are available for in situ measurement of grain size. The new technology permits rapid measurement of surficial bed sediment. Here we describe several systems we have deployed by boat, by hand, and by tripod in rivers, oceans, and on beaches.

Sedimentary Geology↗

USGS2007

Seabed ripple morphology and surficial sediment size at the SAX04 experiments near Fort Walton Beach, Florida, fall 2004

Data presented in this report originates from measurements obtained off the Florida coast (fig. 1) as part of the Sediment Acoustics Experiment (SAX04) and Ripples Department Research Initiative (DRI) (Office of Naval Research (ONR), Critical Benthic Environmental Processes and Modeling, Long Range BAA 04-001, Sept. 10, 2003). The aim of this document is to present methods employed to extract data and the resulting measured ripple characteristics (ripple height, wavelength, and orientation) and seabed grain sizes. Application and analysis of the data with respect to hydro- and morphodynamics will be addressed in subsequent reports. Sediment transport in the coastal region is a complex process involving interactions between flow dynamics, sediments, and bedforms. Sediment type and bed geometry directly influence entrainment of sediments into suspension, and at sites where ripples occur (sand formations on the order of several cm high and less than two meter long wavelengths), the understanding of ripple dynamics is an essential component in improving sediment transport models. To gain a better understanding and ability to predict sediment transport, a field study was undertaken to investigate morphology, orientation, and dynamics of ripples on the seafloor. The data obtained from the field campaign also supports an on-going effort to study the effects of ripples on low grazing acoustic penetration into sandy marine sediments for the detection of objects, such as mines (Jackson and others, 2002).

Florida↗

USGS2006

Geologic characteristics of benthic habitats in Glacier Bay, southeast Alaska

In April 2004, more than 40 hours of georeferenced submarine digital video was collected in water depths of 15-370 m in Glacier Bay to (1) ground-truth existing geophysical data (bathymetry and acoustic reflectance), (2) examine and record geologic characteristics of the sea floor, and (3) investigate the relation between substrate types and benthic communities, and (4) construct predictive maps of seafloor geomorphology and habitat distribution. Common substrates observed include rock, boulders, cobbles, rippled sand, bioturbated mud, and extensive beds of living horse mussels and scallops. Four principal sea-floor geomorphic types are distinguished by using video observations. Their distribution in lower and central Glacier Bay is predicted using a supervised, hierarchical decision-tree statistical classification of geophysical data.

Open-File Report↗

USGS2006

Underwater Microscope for Measuring Spatial and Temporal Changes in Bed-Sediment Grain Size

For more than a century, studies of sedimentology and sediment transport have measured bed-sediment grain size by collecting samples and transporting them back to the lab for grain-size analysis. This process is slow and expensive. Moreover, most sampling systems are not selective enough to sample only the surficial grains that interact with the flow; samples typically include sediment from at least a few centimeters beneath the bed surface. New hardware and software are available for in-situ measurement of grain size. The new technology permits rapid measurement of surficial bed sediment. Here we describe several systems we have deployed by boat, by hand, and by tripod in rivers, oceans, and on beaches.

Open-File Report↗