Geology topics

J.C. Pinkston

Publications and source records attributed to J.C. Pinkston.

5 recordsLinked to original sources

USGS2011

Electrical properties of polycrystalline methane hydrate

Electromagnetic (EM) remote-sensing techniques are demonstrated to be sensitive to gas hydrate concentration and distribution and complement other resource assessment techniques, particularly seismic methods. To fully utilize EM results requires knowledge of the electrical properties of individual phases and mixing relations, yet little is known about the electrical properties of gas hydrates. We developed a pressure cell to synthesize gas hydrate while simultaneously measuring in situ frequency-dependent electrical conductivity (σ). Synthesis of methane (CH 4 ) hydrate was verified by thermal monitoring and by post run cryogenic scanning electron microscope imaging. Impedance spectra (20 Hz to 2 MHz) were collected before and after synthesis of polycrystalline CH 4 hydrate from polycrystalline ice and used to calculate σ. We determined the σ of CH 4 hydrate to be 5 × 10 −5 S/m at 0°C with activation energy (E a ) of 30.6 kJ/mol (−15 to 15°C). After dissociation back into ice, σ measurements of samples increased by a factor of ~4 and E a increased by ~50%, similar to the starting ice samples.

Geophysical Research Letters↗

USGS2006

Methane Hydrate Dissociation Rates at 0.1 MPa and Temperatures above 272 K

We performed rapid depressurization experiments on methane hydrate under isothermal conditions above 272 K to determine the amount and rate of methane evolution. Sample temperatures rapidly drop below 273 K and stabilize near 272.5 K during dissociation. This thermal anomaly and the persistence of methane hydrate are consistent with the reported recovery of partially dissociated methane hydrate from ocean drilling cores.

Annals of the New York Academy of Sciences↗

USGS2006

Laboratory measurements of compressional and shear wave speeds through methane hydrate

Simultaneous measurements of compressional and shear wave speeds through polycrystalline methane hydrate have been made. Methane hydrate, grown directly in a wave speed measurement chamber, was uniaxially compacted to a final porosity below 2%. At 277 K, the compacted material had a compressional wave speed of 3650 ?? 50 m/s. The shear wave speed, measured simultaneously, was 1890 ?? 30 m/s. From these wave speed measurements, we derive V(p)/V(s), Poisson's ratio, bulk, shear, and Young's moduli.

Conference Paper↗

USGS2001

Measurement of gas yields and flow rates using a custom flowmeter

A simple gas collection apparatus based on the principles of a Torricelli tube has been designed and built to measure gas volume yields and flow rates. This instrument is routinely used to monitor and collect methane gas released during methane hydrate dissociation experiments. It is easily and inexpensively built, operates at ambient pressures and temperatures, and measures gas volumes of up to 7 L to a precision of about 15 ml (about 0.0025 mol). It is capable of measuring gas flow rates varying from more than 103 to less than 10-1 ml/min during gas evolution events that span minutes to several days. We have obtained a highly reproducible hydrate number of n=5.891 with a propagated uncertainty of ??0.020 for synthetic methane hydrate. ?? 2001 American Institute of Physics.

Review of Scientific Instruments↗

USGS2000

Methane hydrate dissociation rates at 0.1 MPa and temperatures above 272 K

Conference Paper↗