Search USGSSearch

Geology topics

J. Baraza

Publications and source records attributed to J. Baraza.

3 recordsLinked to original sources

Mediterranean undercurrent sandy contourites, Gulf of Cadiz, Spain

The Pliocene—Quaternary pattern of contourite deposits on the eastern Gulf of Cadiz continental slope results from an interaction between linear diapiric ridges that are perpendicular to slope contours and the Mediterranean undercurrent that has flowed northwestward parallel to the slope contours and down valleys between the ridges since the late Miocene opening of the Strait of Gibraltar. Coincident with the northwestward decrease in undercurrent speeds from the Strait there is the following northwestward gradation of sediment facies associations: (1) upper slope facies, (2) sand dune facies on the upstream mid-slope terrace, (3) large mud wave facies on the lower slope, (4) sediment drift facies banked against the diapiric ridges, and (5) valley facies between the ridges. The southeastern sediment drift facies closest to Gibraltar contains medium-fine sand beds interbedded with mud. The adjacent valley floor facies is composed of gravelly, shelly coarse to medium sand lags and large sand dunes on the valley margins. Compared to this, the northwestern drift contains coarse silt interbeds and the adjacent valley floors exhibit small to medium sand dunes of fine sand. Further northwestward, sediment drift grades to biogenous silt near the Faro Drift at the Portuguese border. Because of the complex pattern of contour-parallel and valley-perpendicular flow paths of the Mediterranean undercurrent, the larger-scale bedforms and coarser-grained sediment of valley facies trend perpendicular to the smaller-scale bedforms and finer-grained contourite deposits of adjacent sediment drift facies. The bottom-current deposits of valleys and the contourites of the Cadiz slope intervalley areas are distinct from turbidite systems. The valley sequences are not aggradational like turbidite channel—levee complexes, but typically exhibit bedrock walls against ridges, extensive scour and fill into adjacent contourites, transverse bedform fields and bioclastic lag deposits. Both valley and contourite deposits exhibit reverse graded bedding and sharp upper bed contacts in coarse-grained layers, low deposition rates, and a regional pattern of bedform zones, textural variation, and compositional gradation. The surface sandy contourite layer of 0.2–1.2 m thickness that covers the Gulf of Cadiz slope has formed during the present Holocene high sea level because high sea level results in maximum water depth over the Gibraltar sill and full development of the Mediterranean undercurrent. The late Pleistocene age of the mud underlying the surface sand sheet correlates with the age of the last sea-level lowstand and apparent weak Mediterranean undercurrent development. Thus, the cyclic deposition of sand or mud layers and contourite or drape sequences appear to be related to late Pliocene and Quaternary sea-level changes and Mediterranean water circulation patterns. Since its Pliocene origin, the contourite sequence has had low deposition rates of < 5 cm/1000y on the upper slope and < 13 cm/1000y in the middle slope sediment drift.

Gulf of Cadiz

Geotechnical properties and preliminary assessment of sediment stability on the continental slope of the northwestern Alboran Sea

Laboratory analysis of core samples from the western Alboran Sea slope reveal a large variability in texture and geotechnical properties. Stability analysis suggests that the sediment is stable under static gravitational loading but potentially unstable under seismic loading. Slope failures may occur if horizontal ground accelerations greater than 0.16 g are seismically induced. The, Alboran Sea is an active region, on which earthquakes inducing accelerations big enough to exceed the shear strength of the soft soil may occur. Test results contrast with the apparent stability deduced from seismic profiles. ?? 1992 Springer-Verlag New York Inc.

Geo-Marine Letters

Geotechnical characteristics and slope stability on the Ebro margin, western Mediterranean

Sedimentological and geotechnical analyses of core samples from the Ebro continental slope define two distinct areas on the basis of sediment type, physical properties and geotechnical behavior. The first area is the upper slope area (water depths of 200–500 m), which consists of upper Pleistocene prodeltaic silty clay with a low water content (34% dry weight average), low plasticity, and high overconsolidation near the seafloor. The second area, the middle and lower slope (water depths greater than 500 m), contains clay- and silt-size hemipelagic deposits with a high water content (90% average), high plasticity, and a low to moderate degree of overconsolidation near the sediment surface. Results from geotechnical tests show that the upper slope has a relatively high degree of stability under relatively rapid (undrained) static loading conditions, compared with the middle and lower slopes, which have a higher degree of stability under long-term (drained) static loading conditions. Under cyclic loading, which occurs during earthquakes, the upper slope has a higher degree of stability than the middle and lower slopes. For the surface of the seafloor, calculated critical earthquake accelerations that can trigger slope failures range from 0.73 g on the upper slope to 0.23 g on the lower slope. Sediment buried well below the seafloor may have a critical acceleration as low as 0.09 g on the upper slope and 0.17 g on the lower slope. Seismically induced instability of most of the Ebro slope seems unlikely given that an earthquake shaking of at least intensity VI would be needed, and such strong intensities have never been recorded in the last 70 years. Other cyclic loading events, such as storms or internal waves, do not appear to be direct causes of instability at present. Infrequent, particularly strong earthquakes could cause landslides on the Ebro margin slope. The Columbretes slide on the southwestern Ebro margin may have been caused by intense earthquake shaking associated with volcanic emplacement of the Columbretes Islands. Localized sediment slides on steep canyon and levee slopes could have been caused by less intense shaking. In general, the slope is stable under present environmental loading conditions and is fundamentally constructional. Nevertheless, rapid progradation caused by high sedimentation rates and other processes acting during low sea-level periods, such as more intense wave loading near the shelfbreak, may have caused major instability in the past.

Marine Geology