Search USGSSearch

Geology topics

I. K. Brownfield

Publications and source records attributed to I. K. Brownfield.

9 recordsLinked to original sources

Mode of occurrence of arsenic in feed coal and its derivative fly ash, Black Warrior Basin, Alabama

An arsenic-rich (As = 55 ppm) bituminous feed coal from the Black Warrior Basin, Alabama and its derivative fly ash (As = 230 ppm) were selected for detailed investigation of arsenic residence and chemical forms. Analytical techniques included microbeam analysis, selective extraction, and As K-edge X-ray absorption fine-structure (XAFS) spectroscopy. Most As in the coal is contained in a generation of As-bearing pyrite (FeS2) that formed in response to epigenetic introduction of hydrothermal fluids. XAFS results indicate that approximately 50% of the As in the coal sample occurs as the oxidized As(V) species, possibly the result of incipient oxidation of coal and pyrite prior to our analysis. Combustion of pyrite and host coal produced fly ash in which 95% of As is present as As(V). Selective extraction of the fly ash with a carbonate buffer solution (pH = 10) removed 49% of the As. A different extraction with an HCl-NH2OH mixture, which targets amorphous and poorly crystalline iron oxides, dissolved 79% of the As. XAFS spectroscopy of this highly acidic (pH = 3.0) fly ash indicated that As is associated with some combination of iron oxide, oxyhydroxide, or sulfate. In contrast, a highly alkaline (pH = 12.7) fly ash from Turkey shows most As associated with a phase similar to calcium orthoarsenate (Ca3(AsO4)2). The combined XAFS results indicate that fly ash acidity, which is determined by coal composition and combustion conditions, may serve to predict arsenic speciation in fly ash.

Fuel

The 2003 phreatomagmatic eruptions of Anatahan volcano - Textural and petrologic features of deposits at an emergent island volcano

Stratigraphic and field data are used in conjunction with textural and chemical evidence (including data from scanning electron microscope, electron microprobe, X-ray fluorescence, X-ray diffraction, and instrumental neutron activation analysis) to establish that the 2003 eruption of Anatahan volcano was mainly phreatomagmatic, dominated by explosive interaction of homogeneous composition low-viscosity crystal-poor andesite magma with water. The hydromagmatic mode of eruption contributed to the significant height of initial eruptive columns and to the excavation and eruption of altered rock debris from the sub-volcanic hydrothermal system. Volatile contents of glass inclusions in equilibrium phenocrysts less abundances of these constituents in matrix glass times the estimated mass of juvenile magma indicate minimum emissions of 19 kt SO2 and 13 kt Cl. This petrologic estimate of SO2 emission is an order-of-magnitude less than an estimate from TOMS. Similarly, inferred magma volumes from the petrologic data are an order of magnitude greater than those modeled from deformation data. Both discrepancies indicate additional sources of volatiles, likely derived from a separate fluid phase in the magma. The paucity of near-source volcanic-tectonic earthquakes preceding the eruption, and the dominance of sustained long-period tremor are attributed to the ease of ascent of the hot low-viscosity andesite, followed by a shallow phreatomagmatic mode of eruption. Phreatomagmatic eruptions are probably more common at emergent tropical island volcanoes, where shallow fresh-water lenses occur at near-sea-level vents. These relations suggest that phreatomagmatic explosions contributed to the formation of many of the near-sea-level craters and possibly even to the small calderas at the other Mariana islands.

Northern Mariana Islands

Magnetic susceptibilities of minerals

Magnetic separation of minerals is a topic that is seldom reported in the literature for two reasons. First, separation data generally are byproducts of other projects; and second, this study requires a large amount of patience and is unusually tedious. Indeed, we suspect that most minerals probably are never investigated for this property. These data are timesaving for mineralogists who concentrate mono-mineralic fractions for chemical analysis, age dating, and for other purposes. The data can certainly be used in the ore-beneficiation industries. In some instances, magnetic-susceptibility data may help in mineral identification, where other information is insufficient. In past studies of magnetic separation of minerals, (Gaudin and Spedden, 1943; Tille and Kirkpatrick, 1956; Rosenblum, 1958; Rubinstein and others, 1958; Flinter, 1959; Hess, 1959; Baker, 1962; Meric and Peyre, 1963; Rojas and others, 1965; and Duchesne, 1966), the emphasis has been on the ferromagnetic and paramagnetic ranges of extraction. For readers interested in the history of magnetic separation of minerals, Krumbein and Pettijohn (1938, p. 344-346) indicated nine references back to 1848. The primary purpose of this paper is to report the magnetic-susceptibility data on as many minerals as possible, similar to tables of hardness, specific gravity, refractive indices, and other basic physical properties of minerals. A secondary purpose is to demonstrate that the total and best extraction ranges are influenced by the chemistry of the minerals. The following notes are offered to help avoid problems in separating a desired mineral concentrate from mixtures of mineral grains.

Open-File Report

Mineralogy of drill cores from Jabal Sa'id, Kingdom of Saudi Arabia

The mineralogy of three drill cores from the apogranite at Jabal Sa'id was determined principally to identify those minerals containing rare earths, niobium, tantalum, thorium, zirconium, and tin. Heavy mineral studies of two other drill cores indicate that the deposit is enriched in rare earths. The principal rare earth minerals are bastnaesite and doverite; other rare earth minerals include monazite and synchisite. Niobium occurs in pyrochlore; zirconium is present in zircon. Thorium is found principally in thorite and secondarily in thorianite. Autoradiographs show the distribution and relative sizes of several radioactive minerals. Microprobe studies of grains of eight different minerals indicated that significant elemental substitution took place in most of them. The rare earth metals cerium and lanthanum occur in significant amounts in pyrochlore; yttrium is abundant in doverite and is also present in bastnaesite, thorite, and zircon. Niobium substitutes for titanium in anatase and brookite, and some tantalum occurs with the niobium in pyrochlore. Minor amounts of thorium are found in bastnaesite, doverite, and zircon. Small amounts of uranium mostly occur with the thorium in thorite. Tin minerals were not found in any of the samples, but small and variable amounts of this element occur in bastnaesite, doverite, hematite, and zircon. The potential ore minerals in the apogranite commonly occur along the grain boundaries of the larger quartz and feldspar. Most of the ore minerals have diameters in the range 0.020 to 0.20 mm.

Open-File Report

Thorium resources of selected regions in the United States

Thorium resources have been assessed in a previous report entitled 'Principal thorium resources in the United States' (Staatz and others, 1979) for (1) veins in the larger districts, {2) massive carbonatites, {3) disseminated deposits, and {4) stream placers of North and South Carolina. This report is a sequel to that report and assesses thorium resources in {1) Florida beach placers, (2) Idaho stream placers, (3) veins and pipes in the Bokan Mountain district, Alaska, (4) carbonatite dikes, and {5) apatite-bearing iron deposits near Mineville, New York. Thorium resources for each of these categories are divided into reserves and probable potential resources. When data are available, each of these is then divided into the following cost categories: (1) the amount of ThO2 producible at a cost of less than $15/lb (per pound), (2) the amount producible at a cost of between $15 and $30/lb, and (3) the amount producible at a cost of between $30 and $50/1b. Beach placers of northern Florida have reserves of 16,200 short tons of ThO2 and probable potential resources of 5,120 tons of ThO2. These deposits are heavy-mineral placers that are mined for a variety of minerals--principally titanium minerals and zircon. The thorium-bearing mineral in these placers, monazite, makes up only a minor part of the heavy minerals. Therefore, production of ThO2 from these placers is dependent on the markets for other heavy minerals. Assuming the market for other heavy minerals to be the same as in 1978, then 98 percent of the ThO2 could be produced for less than $15/lb. If, however, no other coproducts were produced, then the cost of producing ThO2 would be greater than $50/1b. Stream placers containing thorium are found along many streams that drain the Idaho batholith, but most are too small to add significantly to the thorium resources. The resources of the five largest districts, each of which consists of at least several individual placers, have been tabulated. These districts are (1) Long Valley, (2) Bear Valley, (3) Burgdorf-Warren area, (4) Boise Basin, and (5) Ell City-Newsome area. These five areas have reserves of 10,100 short tons of ThO2 and probable potential resources of 10,300 tons. Long Valley contains about half the reserves--5,680 tons of ThO2--and all the probable potential resources. Monazite is the most important heavy mineral in all except the Bear Valley deposit. Here euxenite, although not quite as abundant as monazite, is a more important mineral, because it contains approximately 14.5 percent U3O8 in addition to 5 percent ThO2. Reserves in this placer amount to 1,605 short tons of ThO2 and 1,475 tons of U3O8. Eighty-two percent of the reserves and all of the probable potential resources can be produced at less than $30/1b of ThO2. The lower cost reserves are concentrated in the Long and Bear Valley areas. Here 64 percent of the ThO2 can be produced for less than $15/1b and another 29 percent of the ThO2 at between $15 and $30/lb. Sixteen veins and pipelike bodies are evaluated in the Bokan Mountain area of southeastern Alaska. The district contains other deposits that are too poorly exposed to make meaningful resource estimates. Reserves estimated in this district are 1,440 short tons of ThO2; probable potential resources amount to 2,320 tons of ThO2. About 99 percent of these resources are in deposits whose grade is at least 0.2 percent ThO2. In addition, these deposits contain reserves of 420 tons of U3O8 and probable potential resources of 820 tons of U3O8. Eighty-two percent of the reserves and probable potential resources can be produced at less than $15/lb. The average grade of this ore is 0.54 percent ThO2 and 0 15 percent U3O8. Some carbonatite dikes, although generally not as high grade as the veins, contain resources of thorium. Carbonatite dikes in the following six districts were investigated: (1) Wet Mountains, Colo.; (2) Powderhorn district, Colorado; (3) Mountain Pass area, California; (4) Bearpaw

Circular

Principal thorium resources in the United States

Resources were assessed for thorium in the higher grade and better known deposits in the United States in: (1) veins, (2) massive carbonatites, (3) stream placers of North and South Carolina, and (4) disseminated deposits. Thorium resources for the first three categories were divided into reserves and probable potential resources. Each of these then were separated into the following cost categories: (1) the amount of ThO2 producible at less than $15 per pound, (2) the amount producible at between $15 and $30 per pound, and (3) the amount producible at more than $50 per pound. The type of mining and milling needed at each deposit determines the capital, operating, and fixed costs of both mining and milling. Costs start with the clearing of land and are carried through to the final product, which for all deposits is ThO2. Capital costs of mining are affected most by the type of mining and the size of the mine. Those of milling are affected most by the kind of mill, its size, and whether or not extra circuits are needed for the separation of rare earths or some other byproduct. Veins, massive carbonatites, and stream placers of North and South Carolina have reserves of 188,000 short tons of ThO2 and probable potential resources of 505,000 tons of ThO2. Approximately half of the reserves and probable potential resources can be produced at less than $30 per pound of ThO2. Veins are the highest grade source in the United States and have total reserves of 142,000 tons of ThO2 and probable potential resources of 343,000 tons. About 90 percent of the reserves and 91 percent of the probable potential resources can be produced at less than $15 per pound of ThO2. Seven vein districts were evaluated: (1) Lemhi Pass, Mont.-Idaho, (2) Wet Mountains, Colo., (3) Powderhorn, Colo., (4) Hall Mountain, Idaho, (5) Diamond Creek, Idaho, (6) Bear Lodge Mountains, Wyo. and (7) Mountain Pass, Calif. Eighty-seven percent of the total reserves and probable potential resources are in the Lemhi Pass and Wet Mountains Districts. The first district has reserves of 68,000 tons of ThO2 and probable potential resources of 124,000 tons that can be produced at less than $15 per pound; the second district has 54,000 tons of reserves and 141,000 tons of probable potential resources producible at less than $15 per pound. Rare earths are a common byproduct, and in many veins they are from one-half to several times as abundant as thorium. Massive carbonatite bodies are large-tonnage low-grade deposits. Thorium in these deposits would be a byproduct either of rare earth or of niobium mining. The Iron Hill carbonatite body in the Powderhorn district, Colorado, and the Sulfide Queen carbonatite body in the Mountain Pass district, California, were evaluated. These two deposits contain 40,800 tons of ThO2 in reserves and 125,000 tons of ThO2 in probable potential resources. More than 80 percent of this total is in the Iron Hill carbonatite. This thorium is entirely a byproduct and is producible at less than $15 per pound of ThO2. The Sulphide Queen massive carbonatite deposit was being mined in 1977 for rare earths, and thorium could be recovered by adding an extra circuit to the existing mill. Stream placers in North and South Carolina occur both in the Piedmont and just east of the Fall Line. The reserves of these deposits total 5,270 tons of ThO2, and the probable potential resources are 36,800 tons of ThO2. The Piedmont placers are all too small to produce ThO2 at a cost of less than $50 per pound. One placer on Hollow Creek, S.C., just east of the Fall Line had reserves of 2,040 tons of ThO2 that is producible at between $15 and $30 per pound. Thorium occurs in monazite in these placers. Other heavy minerals that would be recovered with the monazite include rutile, zircon, and ilmenite. In addition to thorium, monazite contains large amounts of rare earths and small amounts of uranium; both can be recovered during the process that separates thorium fr

Circular