Harry R. Hill | Search USGS

USGS1983

Sea-floor-mounted rotating side-scan sonar for making time-lapse sonographs

A rotating side-scan sonar system was designed to make time-lapse sonographs of a circular area of the sea floor. To construct the system, the transducers of a commercial side-scan system (frequency 105 kHz; pulse length 0.1 ms; horizontal beam width 1°; vertical beam width 20°; beam depressed 10° with respect to horizontal) were mounted 2 m above the sea floor on a vertical shaft that had a rotation speed of 0.5 rpm. The radially collected sonar images are recorded linearly on a standard side-scan recorder. To convert the linear record to a radial record, the original moving record is photographed through a slit by a rotating camera, exposing a circular image on film. Records that are collected with this system offer several advantages over records that are collected with towed systems. Bottom features are presented in nearly true plan geometry, and transducer yaw, pitch, and roll are eliminated. Most importantly, repeated observations can be made from a single point, and bedform movements of <50 cm can be measured. In quiet seas the maximum useful range of the system varies from 30 m (for mapping ripples) to 200 m (for mapping 10-m wavelength sand waves) to 450 m or more (for mapping gravel patches).

Continental Shelf Research↗

USGS1979

Fast-ice thickness and snow depth in relation to oil entrapment potential, Prudhoe Bay, Alaska

In winter, the undersurface of the sea ice on shallow arctic shelves acts upon the sea bed directly by contact and indirectly by influencing currents and turbulence. The under-ice surface would serve as a trap for pollutants such as oil and gas released from the sea bed. A knowledge of the morphology of the undersurface of the ice is a first step in understanding the sea-bed interactions and in evaluating the quantities, configuration, and dispersal patterns of sub-ice pollutants. Investigations show thicker sea-ice correlates with a thin snow cover and thin sea-ice underlies elongate snow ridges. In early May, 1978, the relationships between under-ice morphology, sea bed morphology, tidal currents, and variations in snow thickness were studied. At three sites representing three different environments--protected bay, deep, open lagoon, and narrow tidal channel--trenches were cut through the ice. The trenches were parallel and perpendicular to the sastrugi-sculptured northeast-southwest trending snow ridge pattern. Snow depth, ice thickness, and ice drafts were measured and an upward-directed side-scanning sonar was towed to examine the morphology of the under-ice surface in an area 100 m square. Snow depth and ice thickness vary about 30-40 cm and exhibit a negative correlation--thin ice coinciding with a thicker insulating snow cover. The areal snow and ice morphology patterns reinforced the correlation. Elongate ridge and trough patterns on the under-ice surface parallel the surface snow ridge patterns on wavelengths typically 10 m wide, yielding sub-ice voids of 25 to 47 x 10 3 m 3 /km 2 (600-1200 barrels per acre). Diving observations indicate a smaller set of depressions 5 cm or less in depth, oriented parallel to the ice crystal fabric, and an escape of sub-ice released air to the snow-ice interface. The results imply that there is a seasonal stability to the snow ridge pattern and that oil concentrations under the ice would be indicated by surficial snow morphology in the fast ice zone. Spreading directions would be enhanced in the elongate dimensions of the under-ice ridges and troughs, that is, upwind and downwind. In spring, gases will leak to the surface.

Alaska↗