Hao Guo | Search USGS

USGS2025

Three-dimensional seismic velocity models for the San Francisco Bay region, California from joint body-wave and surface-wave tomography validated by waveform simulation

A high-resolution seismic velocity model for both P and S waves is essential for the San Francisco Bay (SFB) region to accurately simulate earthquake ground motions and assess seismic hazards in this high-risk region. We present new three-dimensional P-wave and S-wave velocity (Vp and Vs) models of the SFB region developed using joint tomographic inversion with a rich set of earthquake and active-source body-wave data and ambient-noise surface-wave data. We designed a dynamic balance strategy to effectively balance the contributions of body-wave and surface-wave data during each iteration of the inversion. Owing to the complementary resolution of body-wave and surface-wave data, our new models are significantly improved compared to previous tomographic models. Major geologic features in the SFB region, including low-velocity basins, high-velocity Franciscan Complex, granite, and gabbro rocks, and across-fault velocity contrasts, are imaged in our Vp and Vs models. Compared to the geology-based U.S. Geological Survey velocity model, our new model has better defined structures for some important areas that are of great concern for seismic hazard assessment, such as the Sacramento-San Joaquin Delta, and the 2014 magnitude 6.0 South Napa earthquake area. We validated our model by simulating waveforms for a set of moderate-magnitude earthquakes. The good performance of our model in waveform simulation indicates its potential for improving ground motion simulation and seismic hazard assessment in the SFB region.

California↗

USGS2024

Evidence for low effective stress within the crust of the subducted Gorda plate from the 2022 December Mw 6.4 Ferndale earthquake sequence

Stress levels on and adjacent to megathrust faults at seismogenic depths remain a key but difficult to constrain parameter for assessing seismic hazard in subduction zones. Although strong ground motions have been observed to be generated from distinct, high-stress regions on the downdip end of the megathrust rupture areas in many great earthquakes, we lack direct constraints on the stress level in the lower seismogenic portion of the Cascadia megathrust. On 2022 December 20, a M w 6.4 strike-slip earthquake occurred near Ferndale, California in southern Cascadia and likely ruptured the Gorda slab crust in the lower seismogenic portion, providing an opportunity to assess the stress level in this region. Here, we relocate the Ferndale mainshock and the first two weeks of aftershocks using a high-resolution 3-D velocity model and estimate rupture dimensions, directivity, and stress drop for several M w 4-5 aftershocks and recent earthquakes. The aftershocks define a strike-slip fault in the slab crust striking ENE, consistent with the mainshock focal mechanism. The orientation of this fault is about 45 ° off the ideally oriented fault plane given the stress state in the slab. The aftershock zone is extensive and broad in the forward direction of the mainshock rupture but still constrained within the volume of high Vp/Vs within the slab crust. Our stress drop estimates are generally lower for M w 4-5 earthquakes located within the slab crust compared to those a few km deeper in the slab mantle. Combined, our results support a relatively low effective stress level in the vicinity of the megathrust in the lower portion of the seismogenic zone in southern Cascadia, likely due to elevated fluid pressures. Consequently, the ground motion in the onshore region above this low-stress seismogenic portion in southern Cascadia may not be as intense as that observed during great earthquakes in other subduction zones.

California↗