Geology topics

G. Dromart

Publications and source records attributed to G. Dromart.

9 recordsLinked to original sources

USGS2022

In situ recording of Mars soundscape

Prior to the Perseverance rover landing, the acoustic environment of Mars was unknown. Models predicted that: (i) atmospheric turbulence changes at centimeter scales or smaller at the point where molecular viscosity converts kinetic energy into heat 1 , (ii) the speed of sound varies at the surface with frequency 2,3 , and (iii) high frequency waves are strongly attenuated with distance in CO 2 2–4 . However, theoretical models were uncertain because of a lack of experimental data at low pressure, and the difficulty to characterize turbulence or attenuation in a closed environment. Here using Perseverance microphone recordings, we present the first characterization of Mars’ acoustic environment and pressure fluctuations in the audible range and beyond, from 20 Hz to 50 kHz. We find that atmospheric sounds extend measurements of pressure variations down to 1,000 times smaller scales than ever observed before, revealing a dissipative regime extending over 5 orders of magnitude in energy. Using point sources of sound (Ingenuity rotorcraft, laser-induced sparks), we highlight two distinct values for the speed of sound that are ~10 m/s apart below and above 240 Hz, a unique characteristic of low-pressure CO 2 -dominated atmosphere. We also provide the acoustic attenuation with distance above 2 kHz, allowing us to elucidate the large contribution of the CO 2 vibrational relaxation in the audible range. These results establish a ground truth for modelling of acoustic processes, which is critical for studies in atmospheres like Mars and Venus ones.

Nature↗

USGS2020

The mineral diversity of Jezero crater: Evidence for possible lacustrine carbonates on Mars

Noachian-aged Jezero crater is the only known location on Mars where clear orbital detections of carbonates are found in close proximity to clear fluvio-lacustrine features indicating the past presence of a paleolake; however, it is unclear whether or not the carbonates in Jezero are related to the lacustrine activity. This distinction is critical for evaluating the astrobiological potential of the site, as lacustrine carbonates on Earth are capable of preserving biosignatures at scales that may be detectable by a landed mission like the Mars 2020 rover, which is planned to land in Jezero in February 2021. In this study, we conduct a detailed investigation of the mineralogical and morphological properties of geological units within Jezero crater in order to better constrain the origin of carbonates in the basin and their timing relative to fluvio-lacustrine activity. Using orbital visible/near-infrared hyperspectral images from the Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) along with high resolution imagery and digital elevation models, we identify a distinct carbonate-bearing unit, the “Marginal Carbonates,” located along the inner margin of the crater, near the largest inlet valley and the western delta. Based on their strong carbonate signatures, topographic properties, and location in the crater, we propose that this unit may preserve authigenic lacustrine carbonates, precipitated in the near-shore environment of the Jezero paleolake. Comparison to carbonate deposits from terrestrial closed basin lakes suggests that if the Marginal Carbonates are lacustrine in origin, they could preserve macro- and microscopic biosignatures in microbialite rocks like stromatolites, some of which would likely be detectable by Mars 2020. The Marginal Carbonates may represent just one phase of a complex fluvio-lacustrine history in Jezero crater, as we find that the spectral diversity of the fluvio-lacustrine deposits in the crater is consistent with a long-lived lake system cataloging the deposition and erosion of regional geologic units. Thus, Jezero crater may contain a unique record of the evolution of surface environments, climates, and habitability on early Mars.

Icarus↗

USGS2015

Chemical variations in Yellowknife Bay formation sedimentary rocks analyzed by ChemCam on board the Curiosity rover on Mars

The Yellowknife Bay formation represents a ~5 m thick stratigraphic section of lithified fluvial and lacustrine sediments analyzed by the Curiosity rover in Gale crater, Mars. Previous works have mainly focused on the mudstones that were drilled by the rover at two locations. The present study focuses on the sedimentary rocks stratigraphically above the mudstones by studying their chemical variations in parallel with rock textures. Results show that differences in composition correlate with textures and both manifest subtle but significant variations through the stratigraphic column. Though the chemistry of the sediments does not vary much in the lower part of the stratigraphy, the variations in alkali elements indicate variations in the source material and/or physical sorting, as shown by the identification of alkali feldspars. The sandstones contain similar relative proportions of hydrogen to the mudstones below, suggesting the presence of hydrous minerals that may have contributed to their cementation. Slight variations in magnesium correlate with changes in textures suggesting that diagenesis through cementation and dissolution modified the initial rock composition and texture simultaneously. The upper part of the stratigraphy (~1 m thick) displays rocks with different compositions suggesting a strong change in the depositional system. The presence of float rocks with similar compositions found along the rover traverse suggests that some of these outcrops extend further away in the nearby hummocky plains.

Journal of Geophysical Research E: Planets↗

USGS2015

ChemCam results from the Shaler outcrop in Gale crater, Mars

The ChemCam campaign at the fluvial sedimentary outcrop “Shaler” resulted in observations of 28 non-soil targets, 26 of which included active laser induced breakdown spectroscopy (LIBS), and all of which included Remote Micro-Imager (RMI) images. The Shaler outcrop can be divided into seven facies based on grain size, texture, color, resistance to erosion, and sedimentary structures. The ChemCam observations cover Facies 3 through 7. For all targets, the majority of the grains were below the limit of the RMI resolution, but many targets had a portion of resolvable grains coarser than &sim;0.5 mm. The Shaler facies show significant scatter in LIBS spectra and compositions from point to point, but several key compositional trends are apparent, most notably in the average K 2 O content of the observed facies. Facies 3 is lower in K 2 O than the other facies and is similar in composition to the “snake,” a clastic dike that occurs lower in the Yellowknife Bay stratigraphic section. Facies 7 is enriched in K 2 O relative to the other facies and shows some compositional and textural similarities to float rocks near Yellowknife Bay. The remaining facies (4, 5, and 6) are similar in composition to the Sheepbed and Gillespie Lake members, although the Shaler facies have slightly elevated K 2 O and FeO T . Several analysis points within Shaler suggest the presence of feldspars, though these points have excess FeO T which suggests the presence of Fe oxide cement or inclusions. The majority of LIBS analyses have compositions which indicate that they are mixtures of pyroxene and feldspar. The Shaler feldspathic compositions are more alkaline than typical feldspars from shergottites, suggesting an alkaline basaltic source region, particularly for the K 2 O-enriched Facies 7. Apart from possible iron-oxide cement, there is little evidence for chemical alteration at Shaler, although calcium-sulfate veins comparable to those observed lower in the stratigraphic section are present. The differing compositions, and inferred provenances at Shaler, suggest compositionally heterogeneous terrain in the Gale crater rim and surroundings, and intermittent periods of deposition.

Icarus↗

USGS2015

Deposition, exhumation, and paleoclimate of an ancient lake deposit, Gale crater, Mars

The landforms of northern Gale crater on Mars expose thick sequences of sedimentary rocks. Based on images obtained by the Curiosity rover, we interpret these outcrops as evidence for past fluvial, deltaic, and lacustrine environments. Degradation of the crater wall and rim probably supplied these sediments, which advanced inward from the wall, infilling both the crater and an internal lake basin to a thickness of at least 75 meters. This intracrater lake system probably existed intermittently for thousands to millions of years, implying a relatively wet climate that supplied moisture to the crater rim and transported sediment via streams into the lake basin. The deposits in Gale crater were then exhumed, probably by wind-driven erosion, creating Aeolis Mons (Mount Sharp).

Science↗

USGS2014

ChemCam results from the Shaler Outcrop in Gale Crater, Mars

The "Shaler" outcrop in Gale crater is approximately 0.7 m thick and >20 m long, and exhibits multiple well-exposed platy and cross-stratified facies [1] interpreted to be primarily fluvial sandstone deposits. The outcrop is a part of the upper Glenelg member in the Yellowknife Bay (YKB) stratigraphic section [2]. Curiosity first encountered the "Shaler" outcrop on sol 121 of the mission, and returned to the outcrop on sols 309- 324. The rugged nature of the outcrop and short time available for analysis limited opportunities for contact science, but ChemCam’s ability to remotely collect compositional and textural observations resulted in a large data set from Shaler. ChemCam conducted analyses of 29 non-soil targets at Shaler, 26 of which used laser-induced breakdown spectroscopy (LIBS) for a total of 9,180 spectra. Three observations used only the remote micro-imager (RMI). Each of the 26 LIBS targets were analyzed at between 5 and 25 points, providing a measure of the target homogeneity and in some cases transecting fine strata.

Conference Paper↗

USGS2013

Martian fluvial conglomerates at Gale Crater

Observations by the Mars Science Laboratory Mast Camera (Mastcam) in Gale crater reveal isolated outcrops of cemented pebbles (2 to 40 millimeters in diameter) and sand grains with textures typical of fluvial sedimentary conglomerates. Rounded pebbles in the conglomerates indicate substantial fluvial abrasion. ChemCam emission spectra at one outcrop show a predominantly feldspathic composition, consistent with minimal aqueous alteration of sediments. Sediment was mobilized in ancient water flows that likely exceeded the threshold conditions (depth 0.03 to 0.9 meter, average velocity 0.20 to 0.75 meter per second) required to transport the pebbles. Climate conditions at the time sediment was transported must have differed substantially from the cold, hyper-arid modern environment to permit aqueous flows across several kilometers.

Science↗

USGS2013

Soil diversity and hydration as observed by ChemCam at Gale crater, Mars

The ChemCam instrument, which provides insight into martian soil chemistry at the submillimeter scale, identified two principal soil types along the Curiosity rover traverse: a fine-grained mafic type and a locally derived, coarse-grained felsic type. The mafic soil component is representative of widespread martian soils and is similar in composition to the martian dust. It possesses a ubiquitous hydrogen signature in ChemCam spectra, corresponding to the hydration of the amorphous phases found in the soil by the CheMin instrument. This hydration likely accounts for an important fraction of the global hydration of the surface seen by previous orbital measurements. ChemCam analyses did not reveal any significant exchange of water vapor between the regolith and the atmosphere. These observations provide constraints on the nature of the amorphous phases and their hydration.

Science↗

USGS2012

The ChemCam Instrument Suite on the Mars Science Laboratory (MSL) Rover: Science objectives and mast unit description

ChemCam is a remote sensing instrument suite on board the "Curiosity" rover (NASA) that uses Laser-Induced Breakdown Spectroscopy (LIBS) to provide the elemental composition of soils and rocks at the surface of Mars from a distance of 1.3 to 7 m, and a telescopic imager to return high resolution context and micro-images at distances greater than 1.16 m. We describe five analytical capabilities: rock classification, quantitative composition, depth profiling, context imaging, and passive spectroscopy. They serve as a toolbox to address most of the science questions at Gale crater. ChemCam consists of a Mast-Unit (laser, telescope, camera, and electronics) and a Body-Unit (spectrometers, digital processing unit, and optical demultiplexer), which are connected by an optical fiber and an electrical interface. We then report on the development, integration, and testing of the Mast-Unit, and summarize some key characteristics of ChemCam. This confirmed that nominal or better than nominal performances were achieved for critical parameters, in particular power density (>1 GW/cm 2 ). The analysis spot diameter varies from 350 μm at 2 m to 550 μm at 7 m distance. For remote imaging, the camera field of view is 20 mrad for 1024×1024 pixels. Field tests demonstrated that the resolution (˜90 μrad) made it possible to identify laser shots on a wide variety of images. This is sufficient for visualizing laser shot pits and textures of rocks and soils. An auto-exposure capability optimizes the dynamical range of the images. Dedicated hardware and software focus the telescope, with precision that is appropriate for the LIBS and imaging depths-of-field. The light emitted by the plasma is collected and sent to the Body-Unit via a 6 m optical fiber. The companion to this paper (Wiens et al. this issue) reports on the development of the Body-Unit, on the analysis of the emitted light, and on the good match between instrument performance and science specifications.

Space Science Reviews↗