Geology topics

Evelyn Roeloffs

Publications and source records attributed to Evelyn Roeloffs.

6 recordsLinked to original sources

USGS2020

Kinematics of fault slip associated with the July 4-6 2019 Ridgecrest, Californai earthquakes sequence

The 2019 Ridgecrest, California, earthquake sequence produced observable crustal deformation over much of central and southern California, as well as surface rupture over several tens of kilometers. To obtain a detailed picture of the fault slip involved in the 4 July M 6.4 foreshock and 6 July M 7.1 mainshock, we combine strong‐motion seismic waveforms with crustal deformation observations to obtain kinematic and static slip models of both events. We sample the regional seismic wavefield for both the foreshock and mainshock with three‐component records from 31 stations of the California Integrated Seismic Network. The deformation observations include Global Positioning System (GPS), Interferometric Synthetic Aperture Radar (InSAR), and borehole strainmeter recordings of the dynamic strain field. These data collectively constrain the kinematic coseismic slip distributions of the events, with measurements variously observing coseismic slip from one event (e.g., seismic waveforms, kinematic solutions from continuous GPS, and strainmeter time series) or coseismic slip from both events combined (InSAR). We find that the foreshock ruptured two separate faults, one with left‐lateral strike slip on a northeast–southwest‐trending fault and the other with right‐lateral strike slip on an orthogonal fault, with unilateral rupture propagation along both. The mainshock ruptured a series of northwest–southeast‐trending faults with right‐lateral strike slip concentrated in the uppermost 6 km with exceptionally low‐rupture velocity averaging 1.0 – 1.5    km / s ">

California↗

USGS2020

Rapid geodetic observations of spatiotemporally varying postseismic deformation following the Ridgecrest earthquake sequence: The U.S. Geological Survey response

The U.S. Geological Survey’s geodetic response to the 4–5 July 2019 (Pacific time) Ridgecrest earthquake sequence comprised primarily the installation and/or reoccupation of Global Navigation Satellite System (GNSS) monumentation. Our response focused primarily on the United States’ Navy’s China Lake Naval Air Weapons Station base (NAWSCL). This focus was because much of the surface rupture occurred on the NAWSCL and because of NAWSCL access restrictions only permitting Federal and State of California personnel. In total, we measured or are still measuring at 24 sites, 14 of which were on the NAWSCL and, as of this writing, operational. The majority of sites were set up as continuous stations logging at either 1 sample per second or 1 sample per 15 s. Two stations were recording a 200 m cross‐rupture aperture starting ∼10 hr after the M 6.4 event, and they recorded the coseismic displacements of the M 7.1. Approximately, 1 hr after the M 7.1 event, two new stations were recording a ∼200 m cross‐rupture aperture of the surface rupture. In the days following, we established the rest of the stations ranging to a distance of ∼15 km from the M 7.1 principal rupture trace. The lack of differential displacement across the M 6.4 rupture during the M 7.1 event suggests that it did not reactivate the M 6.4 plane. The lack of differential cross‐fault displacement for both events suggests that rapid shallow afterslip did not occur at those two locations. The postseismic time series from these stations shows centimeters of horizontal displacement over periods of a few months. They record a mixture of fault‐parallel and fault‐normal displacements that, in conjunction with analysis of more spatially complete Interferometric Synthetic Aperture Radar displacement fields, suggest that both poroelastic and afterslip phenomena occur along the M 6.4 and 7.1 rupture planes. Using preliminary data from these and other regional stations, we also explore the Ridgecrest sequence’s effect on regional GNSS time series and the differentiation of long‐term postseismic motions and secular deformation rates. We find that redefining a common‐mode noise filter using different GNSS stations that are assumed to be unaffected by the earthquakes results in small but systematic differences in the regional velocity field estimate.

Seismological Research Letters↗

USGS2019

Leakage and increasing fluid pressure detected in Oklahoma's wastewater disposal reservoir

The Arbuckle Group is the principal reservoir used for wastewater disposal in Oklahoma. In Osage County—a seismically quiet part of the state—continuous measurements of fluid pressure reveal that pressure in the reservoir is increasing by at least 5 kPa annually and sometimes at a much higher rate. Tidal analysis reveals that fluid level changes lead the local strain tides, with no apparent influence from transient permeability changes; this indicates a response that is inconsistent with flow in a radially extensive, confined reservoir. We investigate whether this is due to vertical flow to the water table, vertical flow within the Arbuckle, or local distortions from fractures. While none of these alternative models can fully explain both the observed tidal phases and amplitude ratios, the observed response to teleseismic waves supports a mechanism related to leakage rather than fracture effects. At this location fluid influx associated with wastewater disposal is offset by migration into surrounding layers, which include the Precambrian basement below. Thus, our findings suggest the need to monitor for changes in the induced seismicity hazard, while pore pressures increase in a leaky disposal reservoir.

Oklahoma↗

USGS2010

Tidal calibration of Plate Boundary Observatory borehole strainmeters: Roles of vertical and shear coupling

A multicomponent borehole strainmeter directly measures changes in the diameter of its cylindrical housing at several azimuths. To transform these measurements to formation strains requires a calibration matrix, which must be estimated by analyzing the installed strainmeter's response to known strains. Typically, theoretical calculations of Earth tidal strains serve as the known strains. This paper carries out such an analysis for 12 Plate Boundary Observatory (PBO) borehole strainmeters, postulating that each of the strainmeters' four gauges responds ("couples") to all three horizontal components of the formation strain tensor, as well as to vertical strain. Orientation corrections are also estimated. The fourth extensometer in each PBO strainmeter provides redundant information used to reduce the chance that coupling coefficients could be misleadingly fit to inappropriate theoretical tides. Satisfactory fits between observed and theoretically calculated tides were obtained for three PBO strainmeters in California, where the calculated tides are corroborated by other instrumentation, as well as for six strainmeters in Oregon and Washington, where no other instruments have ever recorded Earth tidal strain. Several strainmeters have unexpectedly large coupling coefficients for vertical strain, which increases the strainmeter's response to atmospheric pressure. Vertical coupling diminishes, or even changes the sign of, the apparent response to areal strain caused by Earth tides or deep Earth processes because near the free surface, vertical strains are opposite in sign to areal strain. Vertical coupling does not impair the shear strain response, however. PBO borehole strainmeters can provide calibrated shear strain time series of transient strain associated with tectonic or magmatic processes.

Journal of Geophysical Research↗

USGS2008

Report on the Aseismic Slip, Tremor, and Earthquakes Workshop

This report summarizes the discussions and information presented during the workshop on Aseismic Slip, Tremor, and Earthquakes. Workshop goals included improving coordination among those involved in conducting research related to these phenomena, assessing the implications for earthquake hazard assessment, and identifying ways to capitalize on the education and outreach opportunities presented by these phenomena. Research activities of focus included making, disseminating, and analyzing relevant measurements; the relationships among tremor, aseismic or 'slow-slip', and earthquakes; and discovering the underlying causative physical processes. More than 52 participants contributed to the workshop, held February 25-28, 2008 in Sidney, British Columbia. The workshop was sponsored by the U.S. Geological Survey, the National Science Foundation?s Earthscope Program and UNAVCO Consortium, and the Geological Survey of Canada. This report has five parts. In the first part, we integrate the information exchanged at the workshop as it relates to advancing our understanding of earthquake generation and hazard. In the second part, we summarize the ideas and concerns discussed in workshop working groups on Opportunities for Education and Outreach, Data and Instrumentation, User and Public Needs, and Research Coordination. The third part presents summaries of the oral presentations. The oral presentations are grouped as they were at the workshop in the categories of phenomenology, underlying physical processes, and implications for earthquake hazards. The fourth part contains the meeting program and the fifth part lists the workshop participants. References noted in parentheses refer to the authors of presentations made at the workshop, and published references are noted in square brackets and listed in the Reference section. Appendix A contains abstracts of all participant presentations and posters, which also have been posted online, along with presentations and author contact information at http://www.earthscope.org/science/cascadia.

Open-File Report↗

USGS2008

Constraints on the size, overpressure, and volatile content of the Mount St. Helens magma system from geodetic and dome-growth measurements during the 2004-2006+ eruption

During the ongoing eruption at Mount St. Helens, Washington, lava has extruded continuously at a rate that decreased from ~7-9 m 3 /s in October 2004 to 1-2 m 3 /s by December 2005. The volume loss in the magma reservoir estimated from the geodetic data, 1.6-2.7×10 7 m3 , is only a few tens of percent of the 7.5×10 7 m 3 volume that had erupted by the end of 2005.

Washington↗