Search USGS⌕ Search

Geology topics

Eugene C. Robertson

Publications and source records attributed to Eugene C. Robertson.

7 recordsLinked to original sources
USGS1995

Estimating heat capacity and heat content of rocks

New heat-capacity measurements are reported for four rock types; Westerly granite from Bradford, RI, andesite from Lake County, OR, peridotite from Sonoma County, CA, and basalt from the Columbia River Group. Measurements were made on powders of the rocks in the temperature range of 340 to about 1000 K. Our measured heat-capacity values for rocks and other measurements of heat capacity or heat content of rocks found in the literature have been compared with estimated rock heat capacities calculated from the summation of heat capacities of both minerals and oxide components. The validity of calculating the heat content or heat capacity of rocks to better than about ± 3% from its mineral or chemical composition is well demonstrated by the data presented here.

Open-File Report↗
USGS1975

The interior of the earth

The center of the Earth lies nearly 4,000 miles beneath our feet. At present the nature of the Earth's interior is known only from indirect evidence collected from studies of rocks and minerals, seismic waves, heat flow from the interior, and the Earth's gravity and magnetic field and through comparisons of the Earth with other planets, with meteorites, and with the Sun and other stars.

General Interest Publication↗
USGS1962

Physical properties of evaporite minerals

The data in the following tables were abstracted from measurements of physical properties of evaporite minerals or of equivalent synthetic compounds. The compounds considered are the halide and sulfate salts which supposedly precipitated from evaporating ocean water and which form very extensive and thick "rock salt" beds. These beds are composed almost entirely of NaCl. In places where the beds are deeply buried and where fractures occur in the overlying rocks, the salt is plastically extruded upward as in a pipe to form the "salt domes". Most of the tables are for NaCl, both the natural (halite) and the synthetic salt, polycrystalline and single crystals. These measurements have been collected for use 1) in studies on storage of radioactive wastes in salt domes or beds, 2) in calculations concerned with nuclear tests in salt domes and beds, and 3) in studies of phenomena in salt of geologic interest. Rather than an exhaustive compilation of physical property measurements, there tables represent a summary of data from accessible sources. As limitations of time have presented making a more systematic and comprehensive selection, the data given may seem arbitrarily chosen. Some of the data listed are old, and newer, more accurate data are undoubtedly available. Halite (an synthetic NaCl) has been very thoroughly studied because of its relatively simple and highly symmetrical crystal structure, its easy availability naturally or synthetically, both in single crystals and polycrystalline, its useful and scientifically interesting properties, and its role as a compound of almost purely ionic bonding. The measurements of NaCl in the tables, however, represent only a small part of the total number of observations; discrimination was necessary to keep the size of the tabulations manageable. The physical properties of the evaporite minerals other than halite and sylvite have received only desultory attention of experiementalists, and appear in only a few tables. The effects of temperature, hydrostatic pressure, stress difference, and other mechanical, eletrical, and optical conditions on the physical properties have probably been observed more completely on NaCl than on any other solid substance, which makes it a unique and important substance. Several new and important phenomena have been observed first on it. The mechanical properties of NaCl, for example, depend very strongly on the condition and the composition of the gas or liquid in contact with the sample surface; the data are sparse as yet and are not reported here.

Trace Elements Investigations↗
USGS1958

Physical properties of salt, anhydrite and gypsum : preliminary report

This summary is the result of a search of the available literature. Emphasis is placed on the mechanical and calorimetric properties of salt; the measurements of elastic, thermal, magnetic, and mass properties of salt are merely tabulated. Under hydrostatic pressure < 1,000 kg/cm2 at room temperature, salt deforms plastically to strains > 100 percent at a nearly constant stress difference of about 300 kg/cm2. Similarily, under temperatures > 400?C at one atmosphere, salt deforms plastically to strains > 100 percent under stress differences of about 100 kg/cm2. Entha1pies were calculated for various temperatures to 2,000? C from the low temperature and high temperature heat capacities and the heats of solution of the following minerals: salt (or halite), NaCl; anhydrite, CaS04; quartz, Si02; and calcite, CaC03. Three combinations of these minerals were assumed to represent three possible natural salt beds, and the heats required to raise the temperature of each to 1,500?C and to 2,000?C were calculated. For a half and half mixture of salt and anhydrite, 1,300 cal/gm were required to raise the temperature to 2,000?C. For an evaporite containing 60 percent salt and about equal amounts of anhydrite, calcite, and quartz, 1,100 cal/gm are required to raise the temperature to 2,OOO?C. Most of the measurements of the elastic moduli were made on single crystals of salt, anhydrite, and gypsum. For the most part, the measurements of density, magnetic susceptibility, and other properties were made on natural salt samples.

Trace Elements Memorandum↗
USGS1956

Magnetite deposits near Klukwan and Haines, southeastern Alaska

Low-grade iron ore is found in magnetite-bearing pyroxenite bodies near Klukwan and Haines in Southeastern Alaska. An alluvial fan at Haines also contains magnetite-bearing rock of possible economic significance. The Haines-Klukwan area is underlain by rocks of Mesozoic Including epidote diorite, quartz diorite, and alaskite of the Coast Range batholith, metabasalt (recrystallized lava flows and pyroclastic rocks), and, in the southern part, interbedded slate and limestone. Layering and foliation, where perceptible, generally strike northwest and dip steeply northeast. The iron deposits are found at or near the contact between the metabasalt and epidote diorite; they appear to represent highly-altered lava flows that were metamorphosed during the emplacement of the batholith. Several billion tens of rock containing about 13 percent magnetic iron are included in the pyroxenite body at Klukwan. Sampling and dip-needle data suggest the presence there of two or three tabular aches in which the rock has an average magnetic iron content of 20 percent or more. Pyroxenite bodies outcropping in three areas near Haines apparently are lower in grade than the Klukwan deposit; lack of exposures prevented thorough sampling but reconnaissance traverses with a dip needle failed to reveal important zones of high-grade iron ore. An alluvial fan adjoining the pyroxenite body at Klukwan contains several hundred million tons of broken rock having a magneticiron content of about 10 percent.

Open-File Report↗