Geology topics

E.F. Westrum

Publications and source records attributed to E.F. Westrum.

5 recordsLinked to original sources

USGS1998

Heat capacity and thermodynamic properties for coesite and jadeite, reexamination of the quartz-coesite equilibrium boundary

The heat capacities of synthetic coesite and jadeite were measured between about 15 and 850 K by adiabatic and differential scanning calorimetry. The experimental data were smoothed and estimates were made of heat capacities to 1800 K. The following equations represent our estimate of the heat capacities of coesite and jadeite between 298.15 and 1800 K: [see original article for formula]. Tables of thermodynamic values for coesite and jadeite to 1800 K are presented. The entropies of coesite and jadeite are 40.38 ?? 0.12 and 136.5 ?? 0.32 J/(mol.K), respectively, at 298.15 K. The entropy for coesite derived here confirms the value published earlier by Holm et al. (1967). We have derived an equation to describe the quartz-coesite boundary over the temperature range of 600 to 1500 K, P(GPa) = 1.76 + 0.001T(K). Our results are in agreement with the enthalpy of transition reported by Akaogi and Navrotsky (1984) and yield -907.6 ?? 1.4 kJ/mol for the enthalpy of formation of coesite from the elements at 298.15 K and 1 bar, in agreement with the value recommended by CODATA (Khodakovsky et al. 1995). Several sources of uncertainty remain unacceptably high, including: the heat capacities of coesite at temperatures above about 1000 K; the heat capacities and volumetric properties of ?? quartz at higher pressures and at temperatures above 844 K; the pressure corrections for the piston cylinder apparatus used to determine the quartz-coesite equilibrium boundary.

American Mineralogist↗

USGS1996

Thermodynamic properties of scapolites at temperatures ranging from 10 K to 1000 K

The heat capacities of five mineral samples from the scapolite solid-solution series, Na4Al3Si9O24Cl (marialite) to Ca4Al6Si6O24CO3 (meionite), were measured by the adiabatic method from T=8 K to T=350 K and by the differential scanning calorimetry (d.s.c.) method from T = 300 K to T = 1000 K. The meionite (Me) content in per cent {Me=100 Ca*/(Ca* + Na*)} (where the asterisk indicates that possible substituents are included) and molar heat capacity (Cp,m/R) at T=298.15 K for each sample is: Me28, 82.07; Me44, 82.09; Me55, 83.95; Me69, 85.80; Me88, 84.54. The standard molar entropies, {S,om(298.15 K)-Som(0 K)} R-1 (R=8.31451 J??K-1??mol-1), at T=298.15 K for the respective compositions are: 85.05??0.26, 83.78??0.50, 85.22??0.24, 85.76??0.21, and 84.17??0.59. The calculated standard molar entropies (as above) at T=298.15 K for the end-members marialite and meionite, and for an intermediate composition (mizzonite=Me75) are 84.85, 83.94 and 86.15, respectively. Values of the coefficients in the equation Cp,m/R = a + bT+ cT2 + dT-1/2 + eT-2 (valid from T = 300 K to T =1000 K) are: (Mex, a, b/K, c/K2, d/K-1/2, e/K-2 Me88), 315.580, -0.0795676, 1.52825.10-5, -3954.83, 1808460; Me69, 261.285, -0.0415017, 8.73053.10-7, -3028.28, 1083666; Me55, 232.236, -0.0352222, 6.49875.10-6, 2505.99, 601750; Me44, 276.696, -0.0756614, 2.39722.10-5, -3210.40, 1044363; Me28, 149.917, 0.0229399, -1.23180.10-5, 1208.87, -318470. Smoothed thermodynamic functions for the five samples are also presented. The enthalpies of solution for five natural scapolites were measured in 2PbO??B2O3 melts at T= 973 K by Calvet-type calorimetry. The values of ??solHom/R??K are: Me11, 32.14??0.7; Me28, 32.34??0.4; Me44, 33.66??0.8; Me69, 35.29??0.8; Me88, 32.87??0.3. The calculated enthalpies of formation for stoichiometric scapolites ??fHom/103??R??K at T= 298.15 K are: Me0, -1467.4??1.3; Me11, -1491.2??1.2; Me28, -1527.6??0.9; Me44, -1564.1??1.1; Me55, -1587.4??1.1; Me69, -1619.7??1.1; Me75, -1633.1??1.1; Me88, -1649.1??1.0; Me100, -1664??1.6. The heat capacity, the entropy, and the enthalpy of solution have maximal values near Me75 which may account in part for the relatively common occurrence of that composition in natural assemblages. Earlier measurements on leucite have been extended by the Komada/Westrum phonon dispersion model and corrected to end-member composition. ?? 1996 Academic Press Limited.

Journal of Chemical Thermodynamics↗

USGS1987

Heat capacity measurements for cryolite (Na3AlF6) and reactions in the system NaFeAlSiOF

The heat capacity of cryolite (Na 3 AlF 6 ) has been measured from 7 to 1000 K by low-temperature adiabatic and high-temperature differential scanning calorimetry. Low-temperature data were obtained on material from the same hand specimen in the calorimetric laboratories of the University of Michigan and U.S. Geological Survey. The results obtained are in good agreement, and yield average values for the entropy of cryolite of: S 0 298 = 238.5 J / mol K "> S 0 298 = 238.5J/mol K S 0 T − S 0 298 = 145.114 ln T+ 193.009∗10 −3 T− 10.366∗ 10 5 T 2 − 872.89 J / mol K (273−836.5 K ) "> S 0 T −S 0 298 = 145.114lnT+ 193.009∗10 −3 T−10.366∗ 10 5 T 2 − 872.89J/mol K(273−836.5K) Δ S Trans = 9.9 J / mol K "> ΔS Trans = 9.9J/mol K S 0 T − S 0 298 =198.414 ln T+73.203∗ 10 −3 T−63.814∗ 10 5 T 2 −1113.11 J / mol K (836.5−1153 K ) "> S 0 T −S 0 298 =198.414 ln T+73.203∗ 10 −3 T−63.814∗10 5 T 2 −1113.11J/mol K(836.5−1153K) with the transition temperature between α- and β-cryolite taken at 836.5 K. These data have been combined with data in the literature to calculate phase equilibria for the system Na Fe Al Si O F. The resultant phase diagrams allow constraints to be placed on the f O 2 , f F 2 , a SiO 2 and T conditions of formation for assemblages in alkalic rocks. A sample application suggests that log f O 2 is approximately −19.2, log f F 2 is −31.9 to −33.2, and a SiO 2 is −1.06 at assumed P T "> PT conditions of 1000 K, 1 bar for the villiaumite-bearing Ilimaussaq intrusion in southwestern Greenland.

Geochimica et Cosmochimica Acta↗

USGS1985

The heat-capacity of ilmenite and phase equilibria in the system Fe-T-O

Low temperature adiabatic calorimetry and high temperature differential scanning calorimetry have been used to measure the heat-capacity of ilmenite (FeTiO 3 ) from 5 to 1000 K. These measurements yield S 298 0 = 108.9 J /( mol · K ). Calculations from published experimental data on the reduction of ilmenite yield Δ 298 0 ( I 1) = −1153.9 kJ /( mol · K ). These new data, combined with available experimental and thermodynamic data for other phases, have been used to calculate phase equilibria in the system Fe-Ti-O. Calculations for the subsystem Ti-O show that extremely low values of ƒO 2 ">ƒ ƒO2 are necessary to stabilize TiO, the mineral hongquiite reported from the Tao district in China. This mineral may not be TiO, and it should be re-examined for substitution of other elements such as N or C. Consideration of solid-solution models for phases in the system Fe-Ti-O allows derivation of a new thermometer/oxybarometer for assemblages of ferropseudobrookite-pseudobrookite ss and hematite-ilmenite ss . Preliminary application of this new thermometer/oxybarometer to lunar and terrestrial lavas gives reasonable estimates of oxygen fugacities, but generally yields subsolidus temperatures, suggesting re-equilibration of one or more phases during cooling.

Geochimica et Cosmochimica Acta↗

USGS1976

Thermodynamics of Fe(II)Fe(III) oxide systems I. Hydrothermal Fe3O4

The heat capacity of a hydrothermally-prepared polycrystalline sample of Fe3O4 was measured from 53 to 350 K, primarily to study the thermophysics of the Verwey transitions. Although the bifurcation of the transition was confirmed, the sample was found to contain traces of manganese. The observed transition temperatures of 117.0 and 123.0 K are 3.7 and 4.2 K higher respectively than those found in pure Fe3O4. Ancillary analytical results are consistent and indicate a stoichiometry of Mn0.008Fe2.992O4 for this material. Characteristics in the transition region are ascribed to dopant effects. ?? 1976.

Journal of Chemical Thermodynamics↗