Geology topics

Diego Melgar

Publications and source records attributed to Diego Melgar.

8 recordsLinked to original sources

USGS2026

Detecting earthquakes in noisy real-time GNSS data with deep learning for improved PGD magnitude estimation

To disseminate accurate and useful warnings, earthquake early warning (EEW) systems must quickly determine the size and location of an earthquake to estimate expected shaking. Traditional seismic‐based algorithms tend to underestimate the true magnitudes of large earthquakes, a phenomenon known as magnitude saturation. This limitation motivated the recent inclusion of Global Navigation Satellite Systems (GNSS) data into the U.S. Geological Survey’s ShakeAlert EEW system with the Geodetic First Approximation of Size and Time (GFAST) algorithm because GNSS data do not saturate with large ground motions. However, the noise levels of GNSS data are very high compared with traditional seismic data, which obscures P ‐wave arrivals and can result in less accurate magnitude estimations if displacement amplitudes are low, such as for lower magnitude earthquakes or large source–station distances. In this study, we develop a deep‐learning model that detects earthquakes in GNSS data and use the Ridgecrest, California, earthquake sequence as a case study to demonstrate how the model could act as a filter to reduce the amount of low‐quality data that enters an algorithm like GFAST. To preserve our limited real earthquake data for model inference, we generated a training dataset composed of >700,000 synthetic displacement waveforms. We combined the synthetic waveforms with real‐time GNSS noise to produce realistically noisy training waveforms and then tested our model on additional synthetic data and performed inference using the real data that were held back. We discuss the performance of our trained model on both the unseen synthetic data and real inference data. Our model can be used to selectively filter only high‐quality data where an earthquake signal is observed for input into an algorithm like GFAST (outperforming a simple signal‐to‐noise ratio–based filter) to reduce the error in GFAST’s real‐time earthquake magnitude estimations.

California↗

USGS2026

Cascadia Subduction Zone science: Call for the next generation community seismic velocity model

The Cascadia subduction zone (CSZ) hosts major seismic and tsunami hazards, yet key questions persist about the relationship between margin structure, fluid distribution, episodic tremor and slip, shallow megathrust behavior, shaking and tsunamigenesis, and the resulting hazard estimates. Addressing these problems requires an empirically grounded, three‐dimensional seismic velocity model to illuminate subsurface structure and properties and to provide a basis for geophysical studies such as earthquake simulations and ground‐motion estimation. In May 2024, the National Science Foundation‐funded Cascadia Region Earthquake Science Center (CRESCENT) community velocity model (CVM) working group, with U.S. Geological Survey and regional partners, convened a workshop to identify priorities for such a model. Participants emphasized the features necessary for addressing key science questions, including implementing findability, accessibility, interoperability, and reusability (FAIR) access, capturing along‐strike and along‐dip structural heterogeneity, resolving shallow offshore–onshore structure, constraining elastic properties and quantifying their uncertainties for numerical wave propagation simulations, their validation benchmarks, and supporting associated accurate earthquake ground‐motion simulations and hazard assessments. This article describes the priorities defined in the workshop, and a description of how, guided by these needs, CRESCENT plans to develop multiple generations of a CVM to advance CSZ science and improve seismic and tsunami hazard modeling across the Pacific Northwest. The CVM will span the CSZ from the surface to ∼100 km depth, offshore and east of the Cascades into Idaho (∼132°–110° W) and the southern and northern tectonic regime transitions (∼36°–52° N) to capture the entire tectonic system as well as its surroundings.

Cascadia Subduction Zone↗

USGS2026

Wavelet Inversion for SliP (WISP): Open-source earthquake slip modeling software

Models of the spatiotemporal evolution of earthquake slip, termed finite-fault models, are a critical component of rapid earthquake and tsunami response, earthquake forecasting, seismic ground-motion estimates, and studies of earthquake kinematics. Here, we detail a newly released finite-fault modeling software, Wavelet Inversion for SliP (WISP), in use at the U.S. Geological Survey’s National Earthquake Information Center (NEIC) and available to the public. WISP version 1.1.0 allows inversion of teleseismic body and surface waves, as well as local strong-motion, static and dynamic Global Navigation Satellite System, and satellite imagery (e.g., Interferometric Synthetic Aperture Radar) observations on single or multiple planar fault segments. The software is used in NEIC rapid response of earthquakes M w ≥ 7, generally resulting in a published model within the first few hours after the event origin time. The rupture location and dimensions are then used as inputs to downstream products to estimate earthquake shaking, predict loss, and model the likelihood of secondary hazards, namely landslides and liquefaction. WISP is also used in research studies to evaluate the characteristics of complex ruptures including multifault ruptures and earthquake doublets, among others. The WISP version 1.1.0 software release is composed of Python-wrapped FORTRAN code to accomplish the inversion procedure. A simple command line interface facilitates ease of use even for those with only a cursory knowledge of Python scripting. WISP version 1.1.0 includes a Jupyter Notebook tutorial demonstrating use of the software for modeling the 2015 M w 8.3 Illapel, Chile, earthquake. In parallel with the tutorial, we demonstrate the typical usage of the WISP software using the M w 8.3 Illapel earthquake example here.

Seismological Research Letters↗

USGS2025

Slow rupture, long rise times, and multi-fault geometry: The 2020 M6.4 southwestern Puerto Rico mainshock

The M 6.4 mainshock of the southwestern Puerto Rico seismic sequence on 7 January 2020, was one of the most impactful modern earthquakes in the northeastern Caribbean. Due to its offshore location and complex aftershock distribution, its source kinematics remain poorly constrained. This active sequence illuminated a complex set of previously unrecognized structures that indicate multiple causative faults may have slipped during its rupture. Here, we utilize seismic and geodetic observations to enhance model resolution, estimate the finite slip of the mainshock, and test a multi-segment, geologically realistic fault geometry. Our refined model finds a lower rupture velocity and longer rise times than typical for an event of this magnitude. This indicates a slow-evolving rupture process that resembles characteristics of a tsunami earthquake. Although this normal/strike-slip faulting event was not tsunamigenic, these qualities, if pervasive for this region, have important implications for future seismic monitoring and hazards in southwestern Puerto Rico.

Puerto Rico↗

USGS2025

Increased flood exposure in the Pacific Northwest following earthquake-driven subsidence and sea-level rise

Climate-driven sea-level rise is increasing the frequency of coastal flooding worldwide, exacerbated locally by factors like land subsidence from groundwater and resource extraction. However, a process rarely considered in future sea-level rise scenarios is sudden (over minutes) land subsidence associated with great (>M8) earthquakes, which can exceed 1 m. Along the Washington, Oregon, and northern California coasts, the next great Cascadia subduction zone earthquake could cause up to 2 m of sudden coastal subsidence, dramatically raising sea level, expanding floodplains, and increasing the flood risk to local communities. Here, we quantify the potential expansion of the 1% floodplain (i.e., the area with an annual flood risk of 1%) under low (~0.5 m), medium (~1 m), and high (~2 m) earthquake-driven subsidence scenarios at 24 Cascadia estuaries. If a great earthquake occurred today, floodplains could expand by 90 km 2 (low), 160 km 2 (medium), or 300 km 2 (high subsidence), more than doubling the flooding exposure of residents, structures, and roads under the high subsidence scenario. By 2100, when climate-driven sea-level rise will compound the hazard, a great earthquake could expand floodplains by 170 km 2 (low), 240 km 2 (medium), or 370 km 2 (high subsidence), more than tripling the flooding exposure of residents, structures, and roads under the high subsidence scenario compared to the 2023 floodplain. Our findings can support decision-makers and coastal communities along the Cascadia subduction zone as they prepare for compound hazards from the earthquake cycle and climate-driven sea-level rise and provide critical insights for tectonically active coastlines globally.

California, Oregon, Washington↗

USGS2025

An unexplained tsunami: Was there megathrust slip during the 2020 Mw7.6 Sand Point, Alaska, earthquake?

On October 19, 2020, the M w 7.6 Sand Point earthquake struck south of the Shumagin Islands in Alaska. Moment tensors indicate the earthquake was primarily strike-slip, yet the event produced an enigmatic tsunami that was larger and more widespread than expected for an earthquake of that magnitude and mechanism. Using a suite of hydrodynamic, seismic, and geodetic modeling techniques, we explore plausible causes of the tsunami. We find that strike-slip models consistent with the moment tensor orientation cannot produce the observed tsunami. Hydrodynamic inversion of sea surface deformation from deep ocean and tide gauge data suggest seafloor deformation more closely matches a megathrust, rather than a strike-slip, source. Static slip inversions, using sea level and Global Navigation Satellite System data, allow for a portion of co-seismic megathrust slip that can explain tsunamigenesis. Combining all available geophysical datasets to model the kinematic rupture, we show that considerable, relatively slow, megathrust slip is allowable in the Shumagin segment, concurrent with strike-slip faulting. We hypothesize that the slow megathrust rupture does not contribute much seismic radiation allowing it to previously go unnoticed with traditional seismic monitoring.

Alaska↗

USGS2025

Combining multisite tsunami and deformation modeling to constrain slip distributions for the 1700 C.E. Cascadia earthquake

A major earthquake ruptured the Cascadia subduction zone (CSZ) on 26 January 1700. Key paleoseismic evidence associated with this event include tsunami deposits, stratigraphic evidence of coastal coseismic subsidence, written Japanese records of a tsunami unaccompanied by earthquake shaking, and margin‐wide turbidites found offshore and in lacustrine environments. Despite this wealth of independent clues, important details about this event remain unresolved. Dating uncertainties do not conclusively establish whether the proxies are from one earthquake or a sequence of them, and we have limited knowledge of the likely slip distributions of the event or events. Here, we use a catalog of 37,500 candidate synthetic ruptures between M w 7.8 and 9.2 and simulate their resulting coseismic deformation and tsunami inundation. Each model is then compared against estimated Japan tsunami arrivals, regional coastal subsidence records, and local paleotsunami deposits mapped at six different coastal marshes and one coastal lake along the CSZ. We find that seven full‐margin ruptures with a median magnitude of M w 9.1 satisfy all three constraints. We favor one M w 9.11 model that best matches all site paleoseismic observations and suggests that the Cascadia megathrust slipped up to ∼30 m and must have shallow geodetic coupling. We also find that some sequences composed of three or four ruptures can still satisfy the observations, yet no sequences of two ruptures can. Sequences are differentiated into three groups based on whether they contain a mainshock rupture located in the south (>44° N) or further north. All sequences contain unruptured portions of the megathrust and most contain mainshocks with peak slip above 40 m. The fit of the geologic evidence from sequences is poor in comparison to single‐event models. Therefore, sequences are generally less favored compared to full‐margin events.

British Columbia, California, Oregon, Washington↗

USGS2024

Evaluation of an open earthquake early warning system in Mexico, and laboratory tests of their sensors

Microelectromechanical system (MEMS) accelerometers are useful for seismological and engineering applications because of their ability to record unsaturated large seismic signals. Recent advances in MEMS technologies enable the design of instruments with improved capabilities that also allow the recording of small signals. As a result, MEMS can be useful across a broad dynamic range and for both major earthquakes and smaller magnitude events. Here, we analyze the performance of a MEMS‐based accelerometer with the capability of real‐time data transmission. We discuss the self‐noise level, dynamic range, and sensitivity, along with the timing precision and data transmission latency, and compare these parameters to other MEMS‐based instruments. We also summarize observations from a regional network deployed in southern Mexico over a period of 3+ yr for the purpose of earthquake early warning. In addition to the sensor evaluation, we present a large, openly available data set of strong motion data from the Mexican network that comprises continuous ground‐motion records from 24 accelerometers in the period between 2017 and 2022.

Seismological Research Letters↗