Search USGS⌕ Search

Geology topics

David M. Perkins

Publications and source records attributed to David M. Perkins.

At least 19 recordsLinked to original sources
USGS2017

Aftershocks, earthquake effects, and the location of the large 14 December 1872 earthquake near Entiat, central Washington

Reported aftershock durations, earthquake effects, and other observations from the large 14 December 1872 earthquake in central Washington are consistent with an epicenter near Entiat, Washington. Aftershocks were reported for more than 3 months only near Entiat. Modal intensity data described in this article are consistent with an Entiat area epicenter, where the largest modified Mercalli intensities, VIII, were assigned between Lake Chelan and Wenatchee. Although ground failures and water effects were widespread, there is a concentration of these features along the Columbia River and its tributaries in the Entiat area. Assuming linear ray paths, misfits from 23 reports of the directions of horizontal shaking have a local minima at Entiat, assuming the reports are describing surface waves, but the region having comparable misfit is large. Broadband seismograms recorded for comparable ray paths provide insight into the reasons why possible S – P times estimated from felt reports at two locations are several seconds too small to be consistent with an Entiat area epicenter.

Washington↗
USGS2011

Seismic-Hazard Maps for the Conterminous United States, 2008

Probabilistic seismic-hazard maps were prepared for the conterminous United States portraying peak horizontal acceleration and horizontal spectral response acceleration for 0.2- and 1.0-second periods with probabilities of exceedance of 10 percent in 50 years and 2 percent in 50 years. All of the maps were prepared by combining the hazard derived from spatially smoothed historic seismicity with the hazard from fault-specific sources. The acceleration values contoured are the random horizontal component. The reference site condition is firm rock, defined as having an average shear-wave velocity of 760 m/s in the top 30 meters corresponding to the boundary between NEHRP (National Earthquake Hazards Reduction program) site classes B and C. This data set represents the results of calculations of hazard curves for a grid of points with a spacing of 0.05 degrees in latitude and longitude. The grid of points were contoured to produce the final representation of the seismic-hazard. These maps are intended to summarize the available quantitative information about seismic ground motion hazard for the conterminous United States from geologic and geophysical source.

Scientific Investigations Map↗
USGS2009

Direct calculation of the probability distribution for earthquake losses to a portfolio

We demonstrate a direct method for the calculation of the annual frequency of exceedance for earthquake losses (or the probability distribution for annual losses) to a portfolio. This method parallels the classic method of probabilistic seismic hazard analysis for the calculation of the annual frequency of exceedance for earthquake ground motions. The method assumes conditional independence of the random component of ground motions and losses at different sites for each earthquake, given magnitude, distance to the sites, and so-called interevent epsilon. Examples show that the method is realizable, and can take into account different loss functions and site conditions in the portfolio. The main advantage of this method is that it does not require a separate set of scenario earthquakes, as do Monte Carlo-based approaches, but can be calculated directly from the inputs used for hazard maps.

Earthquake Spectra↗
USGS2008

Documentation for the 2008 update of the United States National Seismic Hazard Maps

The 2008 U.S. Geological Survey (USGS) National Seismic Hazard Maps display earthquake ground motions for various probability levels across the United States and are applied in seismic provisions of building codes, insurance rate structures, risk assessments, and other public policy. This update of the maps incorporates new findings on earthquake ground shaking, faults, seismicity, and geodesy. The resulting maps are derived from seismic hazard curves calculated on a grid of sites across the United States that describe the frequency of exceeding a set of ground motions. The USGS National Seismic Hazard Mapping Project developed these maps by incorporating information on potential earthquakes and associated ground shaking obtained from interaction in science and engineering workshops involving hundreds of participants, review by several science organizations and State surveys, and advice from two expert panels. The new probabilistic hazard maps represent an update of the 2002 seismic hazard maps developed by Frankel and others (2002), which used the methodology developed for the 1996 version of the maps (Frankel and others, 1996). Algermissen and Perkins (1976) published the first probabilistic seismic hazard map of the United States which was updated in Algermissen and others (1990). The National Seismic Hazard Maps represent our assessment of the “best available science” in earthquake hazards estimation for the United States (maps of Alaska and Hawaii as well as further information on hazard across the United States are available on our Web site at http://earthquake.usgs.gov/research/hazmaps/ ).

Open-File Report↗
USGS2007

Statistical modeling of storm level Kp occurrences: Solar cycle modulation

We consider the nonstationary, statistical modeling of the occurrence in time of large Kp geomagnetic storms over the course of multiple solar cycles. Previous work showed that wait times between storms can be represented by an exponential density function, consistent with the realization of a Poisson process. Here we also assume a Poisson process, but to account for solar cycle modulation of storm likelihood, we assume an occurrence rate given by a parametric constant plus a simple sinusoidal function of time. Parameter estimation is accomplished using maximum likelihood, yielding good fits to the Kp data. We find that the relative phase between storms and sunspots depends on storm size. We quantify previous observations that small storms tend to occur during the declining phase of the solar cycle, while large storms tend to occur very close to solar maximum. We predict average wait time between storms and the storm occurrence rate up through the year 2018.

Space Weather↗
USGS2005

Seismic-hazard maps for the conterminous United States

This publication consists of six map sheets (titles and text included in this document, below), geospatial datasets, and metadata. The geospatial datasets consist of ArcInfo export files for the seismic-hazard point and polygon data shown on the sheets. Probabilistic seismic-hazard maps were prepared for the conterminous United States portraying peak horizontal acceleration and horizontal spectral response acceleration for 0.2- and 1.0-second periods with probabilities of exceedance of 10 percent in 50 years and 2 percent in 50 years. All of the maps were prepared by combining the hazard derived from spatially smoothed historic seismicity with the hazard from fault-specific sources. The acceleration values contoured are the random horizontal component. The reference site condition is firm rock, defined as having an average shear-wave velocity of 760 m/sec in the top 30 meters corresponding to the boundary between NEHRP (National Earthquake Hazards Reduction program) site classes B and C. This data set represents the results of calculations of hazard curves for a grid of points with a spacing of 0.05 degrees in latitude and longitude. The points were contoured to produce the final representation of the seismic hazard.

Scientific Investigations Map↗
USGS2000

Research, methodology, and applications of probabilistic seismic-hazard mapping of the Central and Eastern United States; minutes of a workshop on June 13-14, 2000, at Saint Louis University

The U.S. Geological Survey (USGS) is updating and revising its 1996 national seismic-hazard maps for release in 2001. Part of this process is the convening of four regional workshops with earth scientists and other users of the maps. The second of these workshops was sponsored by the USGS and the Mid-America Earthquake Center, and was hosted by Saint Louis University on June 13-14, 2000. The workshop concentrated on the central and eastern U.S. (CEUS) east of the Rocky Mountains. The tasks of the workshop were to (1) evaluate new research findings that are relevant to seismic hazard mapping, (2) discuss modifications in the inputs and methodology used in the national maps, (3) discuss concerns by engineers and other users about the scientific input to the maps and the use of the hazard maps in building codes, and (4) identify needed research in the CEUS that can improve the seismic hazard maps and reduce their uncertainties. These minutes summarize the workshop discussions. This is not a transcript; some individual remarks and short discussions of side issues and logistics were omitted. Named speakers were sent a draft of the minutes with a request for corrections of any errors in remarks attributed to them. Nine people returned corrections, amplifications, or approvals of their remarks as reported. The rest of this document consists of the meeting agenda, discussion summaries, and a list of the 60 attendees.

Open-File Report↗
USGS1996

National Seismic-Hazard Maps: Documentation June 1996

In this release of hazard maps we present numerous maps and data with varying parameters. The computations for these maps and data used 50 year return periods on firm rock at 760 m/sec. All of the maps were prepared by combining hazard derived from spatially- smoothed historic seismicity with hazard from fault-specific sources. For more information please read our full documentation. Although these maps have been used by the U.S. Geological Survey, no warranty, expressed or implied is made by the USGS as to the accuracy of the maps and related material nor shall the fact of distribution constitute any such warranty, and no responsibility is assumed by the USGS in connection therewith.

Open-File Report↗
USGS1995

Seismic Sources and Recurrence Rates as Adopted by USGS Staff for the Production of the 1982 and 1990 Probabilistic Ground Motion Maps for Alaska and the Conterminous United States

The construction of a probabilistic ground-motion hazard map for a region follows a sequence of analyses beginning with the selection of an earthquake catalog and ending with the mapping of calculated probabilistic ground-motion values (Hanson and others, 1992). An integral part of this process is the creation of sources used for the calculation of earthquake recurrence rates and ground motions. These sources consist of areas and lines that are representative of geologic or tectonic features and faults. After the design of the sources, it is necessary to arrange the coordinate points in a particular order compatible with the input format for the SEISRISK-III program (Bender and Perkins, 1987). Source zones are usually modeled as a point-rupture source. Where applicable, linear rupture sources are modeled with articulated lines, representing known faults, or a field of parallel lines, representing a generalized distribution of hypothetical faults. Based on the distribution of earthquakes throughout the individual source zones (or a collection of several sources), earthquake recurrence rates are computed for each of the sources, and a minimum and maximum magnitude is assigned. Over a period of time from 1978 to 1980 several conferences were held by the USGS to solicit information on regions of the United States for the purpose of creating source zones for computation of probabilistic ground motions (Thenhaus, 1983). As a result of these regional meetings and previous work in the Pacific Northwest, (Perkins and others, 1980), California continental shelf, (Thenhaus and others, 1980), and the Eastern outer continental shelf, (Perkins and others, 1979) a consensus set of source zones was agreed upon and subsequently used to produce a national ground motion hazard map for the United States (Algermissen and others, 1982). In this report and on the accompanying disk we provide a complete list of source areas and line sources as used for the 1982 and later 1990 seismic hazard maps for the conterminous U.S. and Alaska. These source zones are represented in the input form required for the hazard program SEISRISK-III, and they include the attenuation table and several other input parameter lines normally found at the beginning of an input data set for SEISRISK-III.

Open-File Report↗