Geology topics

Daniel Moos

Publications and source records attributed to Daniel Moos.

4 recordsLinked to original sources

USGS2012

In situ studies of velocity in fractured crystalline rocks

A study of the effects of macroscopic fractures on P and S wave velocities has been conducted in four wells drilled in granitic rock to depths between 0.6 and 1.2 km. The effect of macroscopic fractures is to decrease both V p and V s and increase V p / V s . In wells with a relatively low density of macroscopic fractures, the in situ velocity is similar to that of saturated core samples under confining pressure in the laboratory, and there is a clear correlation between zones with macroscopic fractures and anomalously low velocities. In wells with numerous macroscopic fractures, the in situ velocity is lower than that of intact samples under pressure, and there is a correlation between the rate at which in situ velocity increases with depth and the rate at which the velocity of laboratory samples increases with pressure. Differences in in situ P wave velocity between wells cannot be explained solely by differences in the degree of macroscopic fracturing, thus emphasizing the importance of composition and microcracks on velocity. In one highly fractured well the in situ P wave velocity is essentially the same for frequencies ranging from 10 Hz to 20 kHz; this suggests that the macrofractures affect velocity similarly over a broad frequency range. Chemical alteration of rock adjacent to macroscopic fractures appears to play an important role in reducing in situ velocities. Synthetic reflection seismograms generated from the velocity logs suggest that fracture zones are one possible source of deep-crustal reflectors observed on seismic reflection profiles.

Journal of Geophysical Research Solid Earth↗

USGS2012

Well bore breakouts and in situ stress

The detailed cross-sectional shape of stress induced well bore breakouts has been studied using specially processed ultrasonic borehole televiewer data. Breakout shapes are shown for a variety of rock types and introduce a simple elastic failure model which explains many features of the observations. Both the observations and calculations indicate that the breakouts define relatively broad and flat curvilinear surfaces which enlarge the borehole in the direction of minimum horizontal compression. Refs.

Journal of Geophysical Research↗

USGS1997

Analysis of borehole televiewer measurements in the Vorotilov drillhole, Russia - First results

In the Eurasian part of the World Stress Map almost the whole region east of the Tornquist-Teisseyre line is terra incognita. The closure of this information gap is of fundamental importance to the understanding of the geodynamics of the Eurasian continent. A detailed analysis of stress-induced wellbore breakouts has been performed over a 4.1-km-long depth interval in the Vorotilov drillhole (VGS). The borehole is located in the central part of the Russian platform, right in the center of the Vorotilov meteorite impact crater 60 km to the NNE of the city of Nizni Novgorod. An ultrasonic borehole televiewer (BHTV) was used to obtain high-resolution acoustical images from the borehole wall. With an interactive system for analyzing BHTV data the azimuth and shape of borehole breakouts occurring in the depth range of 1.3–4.8 km were analyzed. A statistical analysis of the resulting orientation profile of the breakout azimuths yields an overall direction of the maximum horizontal principal stress S H of N 137°E ± 15°. Variations of breakout orientation with depth ranging from a few degrees up to more than 90° are seen on various depth scales. The observed stress direction of N 137°E agrees very well with the average S H orientation of N 145°E in Central Europe. If this measurement is taken as representative for the Russian platform, the stress field in Russia is only slightly rotated in comparison to Central Europe. This can possibly be interpreted as indicative for the stress field to be governed by broad scale tectonic forces, such as a strong contribution from the forces exerted by the collision zone in the Alpine-Himalayan belt and by the Mid-Atlantic ridge.

Vorotilov drillhole↗

USGS1985

Structure, porosity and stress regime of the upper oceanic crust: Sonic and ultrasonic logging of DSDP Hole 504B

The layered structure of the oceanic crust is characterized by changes in geophysical gradients rather than by abrupt layer boundaries. Correlation of geophysical logs and cores recovered from DSDP Hole 504B provides some insight into the physical properties which control these gradient changes. Borehole televiewer logging in Hole 504B provides a continuous image of wellbore reflectivity into the oceanic crust, revealing detailed structures not apparent otherwise, due to the low percentage of core recovery. Physical characteristics of the crustal layers 2A, 2B and 2C such as the detailed sonic velocity and lithostratigraphic structure are obtained through analysis of the sonic, borehole televiewer and electrical resistivity logs. A prediction of bulk hydrated mineral content, consistent with comparison to the recovered material, suggests a change in the nature of the alteration with depth. Data from the sonic, borehole televiewer, electrical resistivity and other porosity-sensitive logs are used to calculate the variation of porosity in the crustal layers 2A, 2B and 2C. Several of the well logs which are sensitive to the presence of fractures and open porosity in the formation indicate many zones of intense fracturing. Interpretation of these observations suggests that there may be a fundamental pattern of cooling-induced structure in the oceanic crust.

Tectonophysics↗