Geology topics

Christopher J Ottley

Publications and source records attributed to Christopher J Ottley.

3 recordsLinked to original sources

USGS2021

Development of a simulated lung fluid leaching method to assess the release of potentially toxic elements from volcanic ash

Freshly erupted volcanic ash contains a range of soluble elements, some of which can generate harmful effects in living cells and are considered potentially toxic elements (PTEs). This work investigates the leaching dynamics of ash-associated PTEs in order to optimize a method for volcanic ash respiratory hazard assessment. Using three pristine (unaffected by precipitation) ash samples, we quantify the release of PTEs (Al, Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, V, Zn) and major cations typical of ash leachates (Mg, Na, Ca, K) in multiple simulated lung fluid (SLF) preparations and under varying experimental parameters (contact time and solid to liquid ratio). Data are compared to a standard water leach (WL) to ascertain whether the WL can be used as a simple proxy for SLF leaching. The main findings are: PTE concentrations reach steady-state dissolution by 24 h, and a relatively short contact time (10 min) approximates maximum dissolution; PTE dissolution is comparatively stable at low solid to liquid ratios (1:100 to 1:1000); inclusion of commonly used macromolecules has element-specific effects, and addition of a lung surfactant has little impact on extraction efficiency. These observations indicate that a WL can be used to approximate lung bioaccessible PTEs in an eruption response situation. This is a useful step towards standardizing in vitro methods to determine the soluble-element hazard from inhaled ash.

Chemosphere↗

USGS2020

Assessment of leachable elements in volcanic ashfall: A review and evaluation of a standardized protocol for ash hazard characterization

Volcanic ash presents a widespread and common hazard during and after eruptions. Complex interactions between solid ash surfaces and volcanic gases lead to the formation of soluble salts that may be mobilized in aqueous environments. A variety of stakeholders may be concerned about the effects of ash on human and animal health, drinking water supplies, crops, soils and surface runoff. As part of the immediate emergency response, rapid dissemination of information regarding potentially hazardous concentrations of soluble species is critical. However, substantial variability in the methods used to characterize leachable elements makes it challenging to compare datasets and eruption impacts. To address these challenges, the International Volcanic Health Hazard Network ( www.ivhhn.org ) organized a two-day workshop to define appropriate methods for hazard assessment. The outcome of this workshop was a ‘consensus protocol’ for analysis of volcanic ash samples for rapid assessment of hazards from leachable elements, which was subsequently ratified by leading volcanological organizations. The purpose of this protocol is to recommend clear, standard and reliable methods applicable to a range of purposes during eruption response, such as assessing impacts on drinking-water supplies and ingestion hazards to livestock, and also applicable to research purposes. Where possible, it is intended that the methods make use of commonly available equipment and require little training. To evaluate method transferability, an interlaboratory comparison exercise was organized among six laboratories worldwide. Each laboratory received a split of pristine ash, and independently analyzed it according to the protocol for a wide range of elements. Collated results indicate good repeatability and reproducibility for most elements, thus indicating that the development of this protocol is a useful step towards providing standardized and reliable methods for ash hazard characterization. In this article, we review recent ash leachate studies, report the outcomes of the comparison exercise and present a revised and updated protocol based on the experiences and recommendations of the exercise participants. The adoption of standardized methods will improve and facilitate the comparability of results among studies and enable the ongoing development of a global database of leachate information relevant for informing volcanic health hazards assessment.

Journal of Volcanology and Geothermal Research↗

USGS2019

Assessment of the potential for in-plume sulphur dioxide gas-ash interactions to influence the respiratory toxicity of volcanic ash

Background Volcanic plumes are complex environments composed of gases and ash particles, where chemical and physical processes occur at different temperature and compositional regimes. Commonly, soluble sulphate- and chloride-bearing salts are formed on ash as gases interact with ash surfaces. Exposure to respirable volcanic ash following an eruption is potentially a significant health concern. The impact of such gas-ash interactions on ash toxicity is wholly un-investigated. Here, we study, for the first time, whether the interaction of volcanic particles with sulphur dioxide (SO 2 ) gas, and the resulting presence of sulphate salt deposits on particle surfaces, influences toxicity to the respiratory system, using an advanced in vitro approach. Methods To emplace surface sulphate salts on particles, via replication of the physicochemical reactions that occur between pristine ash surfaces and volcanic gas, analogue substrates (powdered synthetic volcanic glass and natural pumice) were exposed to SO 2 at 500 °C, in a novel Advanced Gas-Ash Reactor, resulting in salt-laden particles. The solubility of surface salt deposits was then assessed by leaching in water and geochemical modelling. A human multicellular lung model was exposed to aerosolised salt-laden and pristine (salt-free) particles, and incubated for 24 h. Cell cultures were subsequently assessed for biological endpoints, including cytotoxicity (lactate dehydrogenase release), oxidative stress (oxidative stress-related gene expression; heme oxygenase 1 and NAD(P)H dehydrogenase [quinone] 1) and its (pro-)inflammatory response (tumour necrosis factor α, interleukin 8 and interleukin 1β at gene and protein levels). Results In the lung cell model no significant effects were observed between the pristine and SO 2 -exposed particles, indicating that the surface salt deposits, and the underlying alterations to the substrate, do not cause acute adverse effects in vitro . Based on the leachate data, the majority of the sulphate salts from the ash surfaces are likely to dissolve in the lungs prior to cellular uptake. Conclusions The findings of this study indicate that interaction of volcanic ash with SO 2 during ash generation and transport does not significantly affect the respiratory toxicity of volcanic ash in vitro . Therefore, sulphate salts are unlikely a dominant factor controlling variability in in vitro toxicity assessments observed during previous eruption response efforts.

Environmental Research↗