Geology topics

Carlos Mendoza

Publications and source records attributed to Carlos Mendoza.

8 recordsLinked to original sources

USGS2025

Site response and wave propagation effects in the eastern United States

Fourier amplitude spectra from regional earthquakes in the eastern United States are used in a parametric inversion for source, path, and site effects. Five earthquakes are selected for analysis during the installation of the United States National Seismic Network (US), Earthscope’s USArray Transportable Array (TA), and other temporary arrays to maximize station coverage. A global search algorithm is used to solve for site response from 0.1 to 15 Hz, corner frequency, geometrical spreading ( r - γ ), and frequency dependent anelastic attenuation in the form Q(f) = Q o f α . Tradeoff between moment and geometric spreading is handled by fixing the moment. The tradeoff between corner frequency and Q(f) is solved by selecting the value of corner frequency that minimizes an objective function defined over all stations. Values of site response and attenuation parameters show a strong spatial correlation with the physiographic provinces of the eastern United States. Site response for the Atlantic Coastal Plain is consistent with previous work using spectral ratios relative to a reference site, defined by strong resonance peaks correlated with the thickness of sediments. Site response for the other physiographic provinces is markedly different from the coastal plain, with a lack of distinct resonance peaks and a broad moderate high at frequences from 0.1 to 0.5 Hz consistent with the hard-rock geology of the regions. Like site response, Q(f) has a strong correlation with physiographic province, showing lower values on the coastal plain and higher values inland. Geometric spreading exponent, γ, decreases with increasing hypocenter distance from just above 1 at a few tens of kilometers to 0.9 at 500 km. The limited range in geometric spreading values is attributed to starting the Fourier transform window at the S ‐wave arrival for all distances and averaging over multiple wave types.

eastern United States↗

USGS2024

Prediction of regional broadband strong ground motions using a teleseismic source model of the 18 April 2014 Mw 7.3 Papanoa, Mexico, earthquake

To estimate predicted ground motion from a teleseismic slip model, we use a low‐ and high‐frequency hybrid method to simulate the regional, strong ground motions observed following the 18 April 2014 moment magnitude ( ⁠M w ⁠ ) 7.3 Papanoa, Mexico, earthquake. To generate the regional ground motion at low frequencies (<1 Hz), a teleseismically derived, finite‐fault, kinematic model is used to define the earthquake source, taking into account slip‐model variations identified with a parameter sampling approach that considers possible errors in the fault geometry, the hypocenter depth, and the rupture velocity. A 3D crustal model is used to calculate the low‐frequency ground motions using a finite‐element calculation that includes topography and considers variations in the source model to estimate the uncertainty in the calculations. High frequencies (>1 Hz) are added using a 1D full‐wave propagation code that estimates uncertainties by considering multiple random distributions of slip with different spatial correlation lengths. The synthetic, broadband (0.05–10.0 Hz) ground motions are obtained by combining the low‐ and high‐frequency portions match filtered at 1 Hz. These synthetic ground motions are compared with the regional observations using velocity records, peak ground acceleration, and medians of the orientation‐independent response spectra of the horizontal components (RotD50) calculated at periods of 0.2, 0.3, 0.5, 1.0, 2.0, 3.0, 5.0, 7.5, and 10.0 s. The results indicate that ground motions estimated at these periods using our hybrid approach based primarily on a teleseismically derived source model are comparable to the values observed for the 2014 Papanoa earthquake at regional distances. The approach could be used to estimate strong‐motion spectral levels expected for regions with limited local and regional recordings and could also fill in magnitude or distance gaps in ground‐motion prediction relations utilized in the assessment of seismic hazard.

Papanoa↗

USGS2016

Simulation of earthquake ground motions in the eastern United States using deterministic physics‐based and site‐based stochastic approaches

Earthquake ground‐motion recordings are scarce in the central and eastern United States (CEUS) for large‐magnitude events and at close distances. We use two different simulation approaches, a deterministic physics‐based method and a site‐based stochastic method, to simulate ground motions over a wide range of magnitudes. Drawing on previous results for the modeling of recordings from the 2011 M w 5.8 Mineral, Virginia, earthquake and using the 2001 M w 7.6 Bhuj, India, earthquake as a tectonic analog for a large magnitude CEUS event, we are able to calibrate the two simulation methods over this magnitude range. Both models show a good fit to the Mineral and Bhuj observations from 0.1 to 10 Hz. Model parameters are then adjusted to obtain simulations for M w 6.5, 7.0, and 7.6 events in the CEUS. Our simulations are compared with the 2014 U.S. Geological Survey weighted combination of existing ground‐motion prediction equations in the CEUS. The physics‐based simulations show comparable response spectral amplitudes and a fairly similar attenuation with distance. The site‐based stochastic simulations suggest a slightly faster attenuation of the response spectral amplitudes with distance for larger magnitude events and, as a result, slightly lower amplitudes at distances greater than 200 km. Both models are plausible alternatives and, given the few available data points in the CEUS, can be used to represent the epistemic uncertainty in modeling of postulated CEUS large‐magnitude events.

Bulletin of the Seismological Society of America↗

USGS2013

Rupture model of the 2011 Mineral, Virginia, earthquake from teleseismic and regional waveforms

We independently invert teleseismic P waveforms and regional crustal phases to examine the finite fault slip model for the 2011 M w 5.8 Mineral, Virginia, earthquake. Theoretical and empirical Green's functions are used for the teleseismic and regional models, respectively. Both solutions show two distinct sources each about 2 km across and separated by 2.5 km. The source at the hypocenter is more localized in the regional model leading to a higher peak slip of 130 cm and higher average stress drop of 250 bars compared with 86 cm and 150 bars for the same source in the teleseismic model. Both sources are centered at approximately 8 km depth in the regional model, largely below the aftershock distribution. In the teleseismic model, the sources extend updip to approximately 6 km depth, into the depth range of the aftershocks. The rupture velocity is not well resolved but appears to be near 2.7 km/s.

Geophysical Research Letters↗

USGS2013

Rupture history of the 2008 M w 7.9 Wenchuan, China, earthquake: Evaluation of separate and joint inversions of geodetic, teleseismic, and strong-motion data

An extensive data set of teleseismic and strong-motion waveforms and geodetic offsets is used to study the rupture history of the 2008 Wenchuan, China, earthquake. A linear multiple-time-window approach is used to parameterize the rupture. Because of the complexity of the Wenchuan faulting, three separate planes are used to represent the rupturing surfaces. This earthquake clearly demonstrates the strengths and limitations of geodetic, teleseismic, and strong-motion data sets. Geodetic data (static offsets) are valuable for determining the distribution of shallower slip but are insensitive to deeper faulting and reveal nothing about the timing of slip. Teleseismic data in the distance range 30°–90° generally involve no modeling difficulties because of simple ray paths and can distinguish shallow from deep slip. Teleseismic data, however, cannot distinguish between different slip scenarios when multiple fault planes are involved because steep takeoff angles lead to ambiguity in timing. Local strong-motion data, on the other hand, are ideal for determining the direction of rupture from directivity but can easily be over modeled with inaccurate Green’s functions, leading to misinterpretation of the slip distribution. We show that all three data sets are required to give an accurate description of the Wenchuan rupture. The moment is estimated to be approximately 1.0 × 10 21 N · m with the slip characterized by multiple large patches with slips up to 10 m. Rupture initiates on the southern end of the Pengguan fault and proceeds unilaterally to the northeast. Upon reaching the cross-cutting Xiaoyudong fault, rupture of the adjacent Beichuan fault starts at this juncture and proceeds bilaterally to the northeast and southwest.

Wenchuan↗

USGS2012

Reﬁnements to the method of epicentral location based on surface waves from ambient seismic noise: introducing Love waves

The purpose of this study is to develop and test a modiﬁcation to a previous method of regional seismic event location based on Empirical Green’s Functions (EGFs) produced from ambient seismic noise. Elastic EGFs between pairs of seismic stations are determined by cross-correlating long ambient noise time-series recorded at the two stations. The EGFs principally contain Rayleigh- and Love-wave energy on the vertical and transverse components, respectively, and we utilize these signals between about 5 and 12 s period. The previous method, based exclusively on Rayleigh waves, may yield biased epicentral locations for certain event types with hypocentral depths between 2 and 5 km. Here we present theoretical arguments that show how Love waves can be introduced to reduce or potentially eliminate the bias. We also present applications of Rayleigh- and Love-wave EGFs to locate 10 reference events in the western United States. The separate Rayleigh and Love epicentral locations and the joint locations using a combination of the two waves agree to within 1 km distance, on average, but conﬁdence ellipses are smallest when both types of waves are used.

Geophysical Journal International↗

USGS1996

The Loma Prieta, California, Earthquake of October 17, 1989: Main shock characteristics

The October 17, 1989, Loma Prieta, Calif., earthquake (0004:15.2 G.m.t. October 18; lat 37.036º N., long 121.883º W.; 19-km depth) had a local magnitude (M L ) of about 6.7, a surface-wave magnitude (M S ) of 7.1, a seismic moment of 2.2x10 19 N-m to 3.5x10 19 N-m, a source duration of 6 to 15 s, and an average stress drop of at least 50 bars. Slip occurred on a dipping fault surface about 35 km long and was largely confined to a depth of about 7 to 20 km. The slip vector had a large vertical component, and slip was distributed in two main regions situated northwest and southeast of the hypocenter. This slip distribution caused about half of the earthquake's energy to be focused toward the urbanized San Francisco Bay region, while the other half was focused toward the southeast. Had the rupture initiated at the southeast end of the aftershock zone, shaking in the bay region would have been both longer and stronger. These source parameters suggest that the earthquake was not a typical shallow San Andreas-type event but a deeper event on a different fault with a recurrence interval of many hundreds of years. Therefore, the potential for a damaging shallow event on the San Andreas fault in the Santa Cruz Mountains may still exist.

California↗

USGS1994

Wide-band analysis of the 3 March 1985 central Chile earthquake: Overall source process and rupture history

We apply a linear, finite-fault waveform inversion scheme to the near-source strong-motion records, the teleseismic body waves, and the long-period Rayleigh waves recorded for the 3 March 1985 Chile earthquake to recover the mainshock rupture history. The data contain periods between about 2 and 350 sec and are inverted by allowing a variable dislocation rise time at each point on the fault. The results indicate that the mainshock had a seismic moment of 1.5 × 10 28 dyne-cm ( M w 8.0) and ruptured mainly updip and to the south of the hypocenter for a distance of about 150 km along the Nazca-South America plate boundary. A smaller northward component of propagation is also evident, giving a total rupture length of about 200 km. The total source duration of the mainshock is 70 sec, with the majority of the slip occurring within the first 40 sec in a broad 100-km-wide zone in the northern half of the rupture area. Slip in this region extends from a depth of 55 km to within about 10 km of the surface and contains two areas of maximum slip (2.3 and 2.9 m) with rise times of approximately 14 sec. Slip in the southern portion of the fault reaches lower peak values (1.8 m) and extends downdip to depths no greater than 30 km. An independent variable rise-time inversion of the teleseismic body waves alone yields similar results, indicating that a significant component of slow fault motion is not required for this earthquake. The mainshock was preceded by several smaller precursors, the largest of which is an M w ∼ 6.6 thrust earthquake occurring at a depth of 22 km in the shallow 15° dipping portion of the plate interface.

Bulletin of the Seismological Society of America↗