Search USGSSearch

Geology topics

C. M. Christensen

Publications and source records attributed to C. M. Christensen.

2 recordsLinked to original sources

Investigation of the high-frequency attenuation parameter, κ (kappa), from aftershocks of the 2010 M w 8.8 Maule, Chile earthquake

The Bío Bío region of Chile experienced a vigorous aftershock sequence following the 2010 February 27 M w 8.8 Maule earthquake. The immediate aftershock sequence was captured by two temporary seismic deployments: the Quake Catcher Network Rapid Aftershock Mobilization Program (QCN RAMP) and the Incorporated Research Institutions for Seismology CHile Aftershock Mobilization Program (IRIS CHAMP). Here, we use moderate to large aftershocks ( M L ≥ 4.0) occurring between 2010 March 1 and June 30 recorded by QCN RAMP and IRIS CHAMP stations to determine the spectral decay parameter, kappa ( κ ). First, we compare waveforms and κ estimates from the lower-resolution QCN stations to the IRIS CHAMP stations to ensure the QCN data are of sufficient quality. We find that QCN stations provide reasonable estimates of κ in comparison to traditional seismic sensors and provide valuable additional observations of local ground motion variation. Using data from both deployments, we investigate the variation in κ for the region to determine if κ is influenced primarily by local geological structure, path attenuation, or source properties (e.g. magnitude, mechanism and depth). Estimates of κ for the Bío Bío region range from 0.0022 to 0.0704 s with a mean of 0.0295 s and are in good agreement with κ values previously reported for similar tectonic environments. κ correlates with epicentral distance and, to a lesser degree, with source magnitude. We find little to no correlation between the site kappa, κ 0 , and mapped geology, although we were only able to compare the data to a low-resolution map of surficial geology. These results support an increasing number of studies that suggest κ observations can be attributed to a combination of source, path and site properties; additionally, measured κ are often highly scattered making it difficult to separate the contribution from each of these factors. Thus, our results suggest that contributions from the site, path and source should be carefully considered when interpreting κ values.

Bío Bío Region

Rapid earthquake characterization using MEMS accelerometers and volunteer hosts following the M 7.2 Darfield, New Zealand, Earthquake

We test the feasibility of rapidly detecting and characterizing earthquakes with the Quake‐Catcher Network (QCN) that connects low‐cost microelectromechanical systems accelerometers to a network of volunteer‐owned, Internet‐connected computers. Following the 3 September 2010 M 7.2 Darfield, New Zealand, earthquake we installed over 180 QCN sensors in the Christchurch region to record the aftershock sequence. The sensors are monitored continuously by the host computer and send trigger reports to the central server. The central server correlates incoming triggers to detect when an earthquake has occurred. The location and magnitude are then rapidly estimated from a minimal set of received ground‐motion parameters. Full seismic time series are typically not retrieved for tens of minutes or even hours after an event. We benchmark the QCN real‐time detection performance against the GNS Science GeoNet earthquake catalog. Under normal network operations, QCN detects and characterizes earthquakes within 9.1 s of the earthquake rupture and determines the magnitude within 1 magnitude unit of that reported in the GNS catalog for 90% of the detections.

Darfield