Search USGS⌕ Search

Geology topics

C. Fuller

Publications and source records attributed to C. Fuller.

4 recordsLinked to original sources

Estimating selenium removal by sedimentation from the Great Salt Lake, Utah

The mass of Se deposited annually to sediment in the Great Salt Lake (GSL) was estimated to determine the significance of sedimentation as a permanent Se removal mechanism. Lake sediment cores were used to qualitatively delineate sedimentation regions (very high to very low), estimate mass accumulation rates (MARs) and determine sediment Se concentrations. Sedimentation regions were defined by comparison of isopach contours of Holocene sediment thicknesses to linear sedimentation rates determined via analysis of 210 Pb, 226 Ra, 7 Be and 137 Cs activity in 20 short cores (<5 cm), yielding quantifiable results in 13 cores. MARs were developed via analysis of the same radioisotopes in eight long cores (>10 cm). These MARs in the upper 1-2 cm of each long core ranged from 0.019 to 0.105 g sed /cm 2 /a. Surface sediment Se concentrations in the upper 1 or 2 cm of each long core ranged from 0.79 to 2.47 mg/kg. Representative MARs and Se concentrations were used to develop mean annual Se removal by sedimentation in the corresponding sedimentation region. The spatially integrated Se sedimentation rate was estimated to be 624 kg/a within a range of uncertainty between 285 and 960 kg/a. Comparison to annual Se loading and other potential removal processes suggests burial by sedimentation is not the primary removal process for Se from the GSL. ?? 2009 Elsevier Ltd.

Applied Geochemistry↗

Historical trends of metals in the sediments of San Francisco Bay, California

Concentrations of Ag, Al, Cr, Cu, Fe, Hg, Mn, Ni, Pb, V and Zn were determined in six sediment cores from San Francisco Bay (SFB) and one sediment core in Tomales Bay (TB), a reference estuary. SFB cores were collected from between the head of the estuary and its mouth (Grizzly Bay, GB; San Pablo Bay, SP; Central Bay, CB; Richardson Bay, RB, respectively) and ranged in length from 150 to 250 cm. Concentrations of Cr, V and Ni are greater than mean crustal content in SFB and TB sediments, and greater than found in many other coastal sediments. However, erosion of ultramafic rock formations in the watershed appears to be the predominant source. Baseline concentrations of other metals were determined from horizons deposited before sediments were influenced by human activities and by comparing concentrations to those in TB. Baseline concentrations of Cu co-varied with Al in the SFB sediments and ranged from 23.7±1.2 μg/g to 41.4±2.4 μg/g. Baseline concentrations of other metals were less variable: Ag, 0.09±0.02 μg/g; Pb, 5.2±0.7 μg/g; Hg, 0.06±0.01 μg/g; Zn, 78±7 μg/g. The earliest anthropogenic influence on metal concentrations appeared as Hg contamination (0.3–0.4 μg/g) in sediments deposited at SP between 1850 and 1880, apparently associated with debris from hydraulic gold mining. Maximum concentrations of Hg within the cores were 20 times baseline. Greater inventories of Hg at SP and GB than at RB verified the importance of mining in the watershed as a source. Enrichment of Ag, Pb, Cu and Zn first appeared after 1910 in the RB core, later than is observed in Europe or eastern North America. Maximum concentrations of Ag and Pb were 5–10 times baseline and Cu and Zn concentrations were less than three times baseline. Large inventories of Pb to the sediments in the GB and SP cores appeared to be the result of the proximity to a large Pb smelter. Inventories of Pb at RB are similar to those typical of atmospheric inputs, although influence from the Pb smelter is also suspected. Concentrations of Hg and Pb have decreased since the 1970s (to 0.30 μg/g and 25 μg/g, respectively) and were similar among all cores in 1990. Early Ag contamination was perhaps a byproduct of the Pb smelting process, but a modern source of Ag is also indicated, especially at RB and CB.

California↗

Benthic fluxes in San Francisco Bay

Measurements of benthic fluxes have been made on four occasions between February 1980 and February 1981 at a channel station and a shoal station in South San Francisco Bay, using in situ flux chambers. On each occasion replicate measurements of easily measured substances such as radon, oxygen, ammonia, and silica showed a variability (??1??) of 30% or more over distances of a few meters to tens of meters, presumably due to spatial heterogeneity in the benthic community. Fluxes of radon were greater at the shoal station than at the channel station because of greater macrofaunal irrigation at the former, but showed little seasonal variability at either station. At both stations fluxes of oxygen, carbon dioxide, ammonia, and silica were largest following the spring bloom. Fluxes measured during different seasons ranged over factors of 2-3, 3, 4-5, and 3-10 (respectively), due to variations in phytoplankton productivity and temperature. Fluxes of oxygen and carbon dioxide were greater at the shoal station than at the channel station because the net phytoplankton productivity is greater there and the organic matter produced must be rapidly incorporated in the sediment column. Fluxes of silica were greater at the shoal station, probably because of the greater irrigation rates there. N + N (nitrate + nitrite) fluxes were variable in magnitude and in sign. Phosphate fluxes were too small to measure accurately. Alkalinity fluxes were similar at the two stations and are attributed primarily to carbonate dissolution at the shoal station and to sulfate reduction at the channel station. The estimated average fluxes into South Bay, based on results from these two stations over the course of a year, are (in mmol m-2 d-1): O2 = -27 ?? 6; TCO2 = 23 ?? 6; Alkalinity = 9 ?? 2; N + N = -0.3 ?? 0.5; NH3 = 1.4 ?? 0.2; PO4 = 0.1 ?? 0.4; Si = 5.6 ?? 1.1. These fluxes are comparable in magnitude to those in other temperate estuaries with similar productivity, although the seasonal variability is smaller, probably because the annual temperature range in San Francisco Bay is smaller. Budgets constructed for South San Francisco Bay show that large fractions of the net annual productivity of carbon (about 90%) and silica (about 65%) are recycled by the benthos. Substantial rates of simultaneous nitrification and denitrification must occur in shoal areas, apparently resulting in conversion to N2 of 55% of the particulate nitrogen reaching the sediments. In shoal areas, benthic fluxes can replace the water column standing stocks of ammonia in 2-6 days and silica in 17-34 days, indicating the importance of benthic fluxes in the maintenance of productivity. Pore water profiles of nutrients and Rn-222 show that macrofaunal irrigation is extremely important in transport of silica, ammonia, and alkalinity. Calculations of benthic fluxes from these profiles are less accurate, but yield results consistent with chamber measurements and indicate that most of the NH3, SiO2, and alkalinity fluxes are sustained by reactions occurring throughout the upper 20-40 cm of the sediment column. In contrast, O2, CO2, and N + N fluxes must be dominated by reactions occurring within the upper one cm of the sediment-water interface. While most data support the statements made above, a few flux measurements are contradictory and demonstrate the complexity of benthic exchange. ?? 1985 Dr W. Junk Publishers.

California↗