Search USGS⌕ Search

Geology topics

Behnaz Hosseini

Publications and source records attributed to Behnaz Hosseini.

3 recordsLinked to original sources

Variable partitioning of lithium in rhyolitic melt during decompression and ascent

The partitioning behavior of Li in magmatic systems is increasingly being investigated due to the economic importance of Li in the transition to sustainable energy resources (e.g., batteries). However, at upper crustal pressures, it remains uncertain whether Li preferentially partitions into the vapor or liquid (brine) phase or remains in the silicate melt. This complicates our ability to determine where Li resides—silicate melt, minerals, or fluid phase—upon eruption, a crucial factor for understanding its postdepositional movement and concentration into a brine or volcano-sedimentary deposit. Here, we present a novel investigation into the behavior of Li within natural evolved melts during continuous magma decompression and ascent using melt embayments (open melt inclusions). Mineral-hosted melt embayments preserve records of the evolving composition of the exterior melt, including degassing pathways and ascent timescales, when paired with appropriate diffusion coefficients. Lithium concentration profiles were measured in quartz-hosted melt embayments from the rapidly quenched eruptive phases of five rhyolitic, caldera-forming eruptions to investigate the behavior of Li during magma decompression and ascent, where vapor partitioning and ascent dynamics were previously established by investigating H 2 O and CO 2 profiles. We find that in four systems, embayments contain lower interior Li concentrations than the coerupted melt inclusions; the fifth system contains the same Li concentrations in embayments and melt inclusions. However, many of these embayments contain gradients, with 84 % preserving Li enrichment near the melt-bubble interface, as compared to their interior concentration. We interpret these characteristics to represent two distinct stages of Li partitioning during magma decompression and ascent, in contrast to existing literature that proposes only one type of partitioning behavior. The first stage is interpreted as melt depletion of Li, likely driven by partitioning into an exsolved supercritical fluid phase, supported by the strong correlation between the extent of Li depletion and Cl concentration in the melt, as well as the decompression rate. This behavior then fundamentally shifts, where Li reenriches in the melt, postulated to be driven by the unmixing of the supercritical fluid phase at shallow pressures. For the one system that did not develop Li gradients through decompression, we attribute this to the lower values of Na and Cl in the melt, potentially inhibiting the partitioning of Li into a fluid phase. Importantly, the behavior of Li during decompression is not consistent within or between volcanic centers, highlighting the need for systematic experimental investigation in variable composition melts at pressures relevant to conduit dynamics. This knowledge would improve our ability to model Li profiles to understand magma decompression, and predict where Li resides (e.g., stored in volcanic glass, gas, or crystals) upon eruption prior to any later extraction.

Economic Geology↗

The structure and volume of large geysers in Yellowstone National Park, USA and the mineralogy and chemistry of their silica sinter deposits

Siliceous sinter is formed by biogenic and abiogenic opal deposition around hot springs and geysers. Using Structure-from-Motion photogrammetry we generated three-dimensional models of Giant and Castle Geysers from the Upper Geyser Basin of Yellowstone National Park. We use these models to calculate an approximate mass of sinter for each (~2 and ~ 5 kton, respectively) and estimate a range of plausible long-term deposition rates for Castle Geyser (470 to 940 kg·yr −1 ). We estimate ~2% of the silica discharged from Castle Geyser is deposited as sinter in the cone and proximal terraces. We collected 15 sinter samples following the stratigraphy of each geyser from an older terrace to a younger cone and examined them using a variety of analytical methods. We find that young opaline sinter with a water content of <12 wt% (from loss on ignition) contains higher concentrations of major and trace elements, notably As, Sb, Rb, Ga and Cs, relative to older dehydrated sinter. Rare earth element (REE) concentrations in sinter are 2–3 orders of magnitude higher than in the thermal water from which they are deposited. Sinter deposits are enriched in light REE, Gd and Yb when normalized to concentrations in thermal water and enriched in Eu, Tm, and Yb when normalized to the underlying rhyolite. Sinter samples with the highest REE concentrations are also enriched in organic material, implying either microbial uptake of REE, or that organic molecules are efficient ligands that form metal complexes.

Wyoming↗

Hydrothermal activity in the southwest Yellowstone Plateau Volcanic Field

In the past two decades, the U.S. Geological Survey and the National Park Service have studied hydrothermal activity across the Yellowstone Plateau Volcanic Field (YPVF) to improve the understanding of the magmatic-hydrothermal system and to provide a baseline for detecting future anomalous activity. In 2017 and 2018 we sampled water and gas over a large area in the southwest YPVF and used Landsat 8 thermal infrared data to estimate radiative heat flow. Most of the thermal activity in this region is in close proximity to the Yellowstone Caldera boundary. Springs and fumaroles discharge from a variety of lithologies including some of the youngest rhyolites in the YPVF. Gas compositions and helium isotope ratios of most samples resemble those in other parts of the YPVF. The waters have meteoric origins and tritium was detected in several samples. Thermal waters from some areas have compositions that plot along a line connecting thermal and non-thermal water endmember compositions. The thermal water endmember equilibrated at 160-170 °C, lower than waters in Yellowstone’s geyser basins. Heat discharged by springs and fumaroles originates from within the Yellowstone Caldera and is transported laterally by advection, mainly along the base of rhyolite flows that cover the inferred caldera boundaries.

Yellowstone National Park↗