Search USGS⌕ Search

Geology topics

B.A. Bekins

Publications and source records attributed to B.A. Bekins.

27 records · Page 2Linked to original sources
USGS2001

Smectite diagenesis, pore-water freshening, and fluid flow at the toe of the Nankai wedge

The presence of low-chloride fluids in the lowermost sediments drilled at Ocean Drilling Program Site 808, at the Nankai accretionary wedge, has been considered as prime evidence for long-distance, lateral fluid flow from depth. Here, we re-evaluate the potential role of in situ reaction of smectite (S) to illite (I) in the genesis of this low chloride anomaly. This reaction is known to be occurring at Site 808, with both the S content and S to I ratio in the mixed layer clays decreasing substantially with depth. We show that the bulk of the chloride anomaly can generate by in situ clay dehydration, particularly if pre-reaction smectite abundances (Ai) approach ?? 10-15% of the bulk sediment. The Ai values, however, are not well constrained. At Ai values < 10-15%, an additional source of low-Cl fluid centered close to the de??collement could be required. Thus, there remains the important possibility that the observed low-Cl anomaly is a compound effect of both lateral flow and in situ smectite dehydration. ?? 2001 Elsevier Science B.V. All rights reserved.

Earth and Planetary Science Letters↗
USGS2001

Progression of natural attenuation processes at a crude-oil spill site . I. Geochemical evolution of the plume

A 16-year study of a hydrocarbon plume shows that the extent of contaminant migration and compound-specific behavior have changed as redox reactions, most notably iron reduction, have progressed over time. Concentration changes at a small scale, determined from analysis of pore-water samples drained from aquifer cores, are compared with concentration changes at the plume scale, determined from analysis of water samples from an observation well network. The small-scale data show clearly that the hydrocarbon plume is growing slowly as sediment iron oxides are depleted. Contaminants, such as ortho -xylene that appeared not to be moving downgradient from the oil on the basis of observation well data, are migrating in thin layers as the aquifer evolves to methanogenic conditions. However, the plume-scale observation well data show that the downgradient extent of the Fe 2+ and BTEX plume did not change between 1992 and 1995. Instead, depletion of the unstable Fe (III) oxides near the subsurface crude-oil source has caused the maximum dissolved iron concentration zone within the plume to spread at a rate of approximately 3 m/year. The zone of maximum concentrations of benzene, toluene, ethylbenzene and xylene (BTEX) has also spread within the anoxic plume. In monitoring the remediation of hydrocarbon-contaminated ground water by natural attenuation, subtle concentration changes in observation well data from the anoxic zone may be diagnostic of depletion of the intrinsic electron-accepting capacity of the aquifer. Recognition of these subtle patterns may allow early prediction of growth of the hydrocarbon plume.

Journal of Contaminant Hydrology↗
USGS2001

Progression of natural attenuation processes at a crude oil spill site: II. Controls on spatial distribution of microbial populations

A multidisciplinary study of a crude-oil contaminated aquifer shows that the distribution of microbial physiologic types is strongly controlled by the aquifer properties and crude oil location. The microbial populations of four physiologic types were analyzed together with permeability, pore-water chemistry, nonaqueous oil content, and extractable sediment iron. Microbial data from three vertical profiles through the anaerobic portion of the contaminated aquifer clearly show areas that have progressed from iron-reduction to methanogenesis. These locations contain lower numbers of iron reducers, and increased numbers of fermenters with detectable methanogens. Methanogenic conditions exist both in the area contaminated by nonaqueous oil and also below the oil where high hydrocarbon concentrations correspond to local increases in aquifer permeability. The results indicate that high contaminant flux either from local dissolution or by advective transport plays a key role in determining which areas first become methanogenic. Other factors besides flux that are important include the sediment Fe(II) content and proximity to the water table. In locations near a seasonally oscillating water table, methanogenic conditions exist only below the lowest typical water table elevation. During 20 years since the oil spill occurred, a laterally continuous methanogenic zone has developed along a narrow horizon extending from the source area to 50–60 m downgradient. A companion paper [J. Contam. Hydrol. 53, 369–386] documents how the growth of the methanogenic zone results in expansion of the aquifer volume contaminated with the highest concentrations of benzene, toluene, ethylbenzene, and xylenes.

Journal of Contaminant Hydrology↗
USGS2000

Microbial populations in contaminant plumes

Efficient biodegradation of subsurface contaminants requires two elements: (1) microbial populations with the necessary degradative capabilities, and (2) favorable subsurface geochemical and hydrological conditions. Practical constraints on experimental design and interpretation in both the hydrogeological and microbiological sciences have resulted in limited knowledge of the interaction between hydrogeological and microbiological features of subsurface environments. These practical constraints include: (1) inconsistencies between the scales of investigation in the hydrogeological and microbiological sciences, and (2) practical limitations on the ability to accurately define microbial populations in environmental samples. However, advances in application of small-scale sampling methods and interdisciplinary approaches to site investigations are beginning to significantly improve understanding of hydrogeological and microbiological interactions. Likewise, culture-based and molecular analyses of microbial populations in subsurface contaminant plumes have revealed significant adaptation of microbial populations to plume environmental conditions. Results of recent studies suggest that variability in subsurface geochemical and hydrological conditions significantly influences subsurface microbial-community structure. Combined investigations of site conditions and microbial-community structure provide the knowledge needed to understand interactions between subsurface microbial populations, plume geochemistry, and contaminant biodegradation.

Hydrogeology Journal↗
USGS1999

Distribution of microbial physiologic types in an aquifer contaminated by crude oil

We conducted a plume-scale study of the microbial ecology in the anaerobic portion of an aquifer contaminated by crude-oil compounds. The data provide insight into the patterns of ecological succession, microbial nutrient demands, and the relative importance of free-living versus attached microbial populations. The most probable number (MPN) method was used to characterize the spatial distribution of six physiologic types: aerobes, denitrifiers, iron-reducers, heterotrophic fermenters, sulfate-reducers, and methanogens. Both free-living and attached numbers were determined over a broad cross-section of the aquifer extending horizontally from the source of the plume at a nonaqueous oil body to 66 m downgradient, and vertically from above the water table to the base of the plume below the water table. Point samples from widely spaced locations were combined with three closely spaced vertical profiles to create a map of physiologic zones for a cross-section of the plume. Although some estimates suggest that less than 1% of the subsurface microbial population can be grown in laboratory cultures, the MPN results presented here provide a comprehensive qualitative picture of the microbial ecology at the plume scale. Areas in the plume that are evolving from iron-reducing to methanogenic conditions are clearly delineated and generally occupy 25-50% of the plume thickness. Lower microbial numbers below the water table compared to the unsaturated zone suggest that nutrient limitations may be important in limiting growth in the saturated zone. Finally, the data indicate that an average of 15% of the total population is suspended.

Microbial Ecology↗
USGS1999

Fluid budgets at convergent plate margins: Implications for the extent and duration of fault-zone dilation

Faults at convergent plate boundaries are important conduits for fluid escape, and recent evidence suggests that fluid expulsion along them is both transient and heterogeneous. For the Nankai and Barbados convergent margins, we have used numerical models to investigate the long-term partitioning of expelled fluids between diffuse flow and flow along connected high-permeability fault conduits. For a simple case of spatial heterogeneity, we estimated the extent of high-permeability conduits necessary to maintain a balance between incoming and expelled fluids. For the case of transient expulsion, we constrained the duration of elevated permeability required to balance the fluid budgets. Comparison of modeled and observed geochemical profiles suggests that the initiation of connected flow conduits is delayed with respect to the time of accretion into each accretionary complex and may be related to burial below a critical depth, either where the overlying wedge is sufficiently thick to prevent fluid escape to the sea floor or where sediments behave brittlely.

Geology↗
USGS1998

Episodic fluid flow in the Nankai accretionary complex: Timescale, geochemistry, flow rates, and fluid budget

Down-hole geochemical anomalies encountered in active accretionary systems can be used to constrain the timing, rates, and localization of fluid flow. Here we combine a coupled flow and solute transport model with a kinetic model for smectite dehydration to better understand and quantify fluid flow in the Nankai accretionary complex offshore of Japan. Compaction of sediments and clay dehydration provide fluid sources which drive the model flow system. We explicitly include the consolidation rate of underthrust sediments in our calculations to evaluate the impact that variations in this unknown quantity have on pressure and chloride distribution. Sensitivity analysis of steady state pressure solutions constrains bulk and flow conduit permeabilities. Steady state simulations with 30% smectite in the incoming sedimentary sequence result in minimum chloride concentrations at site 808 of 550 m M , but measured chlorinity is as low as 447 m M . We simulate the transient effects of hydrofracture or a strain event by assuming an instantaneous permeability increase of 3–4 orders of magnitude along a flow conduit (in this case the décollement), using steady state results as initial conditions. Transient results with an increase in décollement permeability from 10 −16 m 2 to 10 −13 m 2 and 20% smectite reproduce the observed chloride profile at site 808 after 80–160 kyr. Modeled chloride concentrations are highly sensitive to the consolidation rate of underthrust sediments, such that rapid compaction of underthrust material leads to increased freshening. Pressures within the décollement during transient simulations rise rapidly to a significant fraction of lithostatic and remain high for at least 160 kyr, providing a mechanism for maintaining high permeability. Flow rates at the deformation front for transient simulations are in good agreement with direct measurements, but steady state flow rates are 2–3 orders of magnitude smaller than observed. Fluid budget calculations indicate that nearly 71% of the incoming water in the sediments leaves the accretionary wedge via diffuse flow out the seafloor, 0–5% escapes by focused flow along the décollement, and roughly 1% is subducted.

Journal of Geophysical Research B: Solid Earth↗
USGS1998

Ground water contamination by crude oil near Bemidji, Minnesota

Ground-water contamination by crude oil, and other petroleum-based liquids, is a widespread problem. An average of 83 crude-oil spills occurred per year during 1994-96 in the United States, each spilling about 50,000 barrels of crude oil (U.S. Office of Pipeline Safety, electronic commun., 1997). An understanding of the fate of organic contaminants (such as oil and gasoline) in the subsurface is needed to design innovative and cost-effective remedial solutions at contaminated sites.

Minnesota↗