Search USGS⌕ Search

Geology topics

B. G. Campbell

Publications and source records attributed to B. G. Campbell.

10 recordsLinked to original sources

How processing digital elevation models can affect simulated water budgets

For regional models, the shallow water table surface is often used as a source/sink boundary condition, as model grid scale precludes simulation of the water table aquifer. This approach is appropriate when the water table surface is relatively stationary. Since water table surface maps are not readily available, the elevation of the water table used in model cells is estimated via a two-step process. First, a regression equation is developed using existing land and water table elevations from wells in the area. This equation is then used to predict the water table surface for each model cell using land surface elevation available from digital elevation models (DEM). Two methods of processing DEM for estimating the land surface for each cell are commonly used (value nearest the cell centroid or mean value in the cell). This article demonstrates how these two methods of DEM processing can affect the simulated water budget. For the example presented, approximately 20% more total flow through the aquifer system is simulated if the centroid value rather than the mean value is used. This is due to the one-third greater average ground water gradients associated with the centroid value than the mean value. The results will vary depending on the particular model area topography and cell size. The use of the mean DEM value in each model cell will result in a more conservative water budget and is more appropriate because the model cell water table value should be representative of the entire cell area, not the centroid of the model cell.

Ground Water↗

Bathymetry of Lake William C. Bowen and Municipal Reservoir #1, Spartanburg County, South Carolina, 2008

The increasing use and importance of lakes for water supply to communities enhance the need for an accurate methodology to determine lake bathymetry and storage capacity. A global positioning receiver and a fathometer were used to collect position data and water depth in February 2008 at Lake William C. Bowen and Municipal Reservoir #1, Spartanburg County, South Carolina. All collected data were imported into a geographic information system database. A bathymetric surface model, contour map, and stage-area and -volume relations were created from the geographic information database.

South Carolina↗

Solute changes during aquifer storage recovery testing in a limestone/clastic aquifer

Aquifer storage recovery (ASR) was tested in the Santee Limestone/Black Mingo Aquifer near Charleston, South Carolina, to assess the feasibility for subsurface storage of treated drinking water. Water quality data obtained during two representative ASR tests were interpreted to show three things: (1) recovery efficiency of ASR in this geological setting; (2) possible changes in physical characteristics of the aquifer during ASR testing; and (3) water quality changes and potability of recovered water during short (one- and six-day) storage durations in the predominantly carbonate aquifer. Recovery efficiency for both ASR tests reported here was 54%. Successive ASR tests increased aquifer permeability of the Santee Limestone/Black Mingo Aquifer. It is likely that aquifer permeability increased during short storage periods due to dissolution of carbonate minerals and amorphous silica in aquifer material by treated drinking water. Dissolution resulted in an estimated 0.3% increase in pore volume of the permeable zones. Ground water composition generally evolved from a sodium-calcium bicarbonate water to a sodium chloride water during storage and recovery. After short duration, stored water can exceed the U.S. Environmental Protection Agency maximum contaminant level (MCL) for chloride (250 mg/L). However, sulfate, fluoride, and tri-halomethane concentrations remained below MCLs during storage and recovery.

Groundwater↗

Documentation of model input and output values for the simulation of the ground-water flow system in the Cretaceous-age Coastal Plain aquifers of South Carolina

This report and the attached 3 1/2-inch diskette contain, in compressed format, the data sets for the model of ground-water flow in the Cretaceous-age Coastal Plain aquifers of South Carolina. The data sets can be uncompressed using a program provided with this report. The uncompressed files require approximately 3.7 megabytes of disk space on an IBM-compatible microcomputer1 using the MS-DOS operating system. All files are in American Standard Code for Information Interchange format.

South Carolina↗

Ground-water hydrology, historical water use, and simulated ground-water flow in Cretaceous-age Coastal Plain aquifers near Charleston and Florence, South Carolina

A quasi-three-dimensional, transient, digital, ground-water flow model representing the Coastal Plain aquifers of South Carolina, has been constructed to assist in defining the ground- water-flow system of Cretaceous aquifers near Charleston and Florence, S.C. Both cities are near the centers of large (greater than 150 feet) potentiometric declines in the Middendorf aquifer. In 1989, the diameter of the depressions was approximately 40 miles at Charleston and 15 miles at Florence. The potentiometric decline occurred between predevelopment (1926) and 1982 near Florence, and between predevelopment (1879) and 1989 near Charleston. The city of Charleston does not withdraw water from these aquifers; however, some of the small communities in the area use these aquifers for a potable water supply. The model simulates flow in and between four aquifer systems. The model has a variable-cell-size grid, and spans the Coastal Plain from the Savannah River in the southwest to the Cape Fear Arch in the northeast, and from the Fall Line in the northwest to approximately 30 miles offshore to the southeast. Model-grid cell size is 1 by 1 mile in a 48 by 48 mile area centered in Charleston, and in a 36 by 48 mile area centered in Florence. The model cell size gradually increases to a maximum of 4 by 4 miles outside the two study areas. The entire grid consists of 115 by 127 cells and covers an area of 39,936 square miles. The model was calibrated to historical water-level data. The calibration relied on three techniques: (1) matching simulated and observed potentiometric map surfaces, (2) statistical comparison of observed and simulated heads, and (3) comparison of observed and simulated well hydrographs. Systematic changes in model parameters showed that simulated heads are most sensitive to changes in aquifer transmissivity. Eight predictive ground-water-use scenarios were simulated for the Mount Pleasant area, which presently (1993) uses the Middendorf aquifer as a sole-source of potable water. These simulations use various combinations of spatial distribution, and injection of treated wastewater effluent for existing and future Middendorf aquifer wells.

South Carolina↗

Geology, hydrogeology, and potential of intrinsic bioremediation at the National Park Service Dockside II site and adjacent areas, Charleston, South Carolina, 1993-94

A long history of industrial and commercial use of the National Park Service property and adjacent properties located in downtown Charleston, South Carolina, has caused extensive contamination of the shallow subsurface soils and water-table aquifer. The National Park Service property is located adjacent to a former manufactured-gas plant site, which is the major source of the contamination. Contamination of this shallow water-table aquifer is of concern because shallow ground water discharges to the Cooper River and contains contaminants, which may affect adjacent wildlife or human populations. The geology of the National Park Service property above the Ashley Formation of the Cooper Group consists of two Quaternary lithostratigraphic marine units, the Wando Formation and Holocene deposits, overlain by artificial fill. The Wando Formation overlies the Ashley Formation, a sandy calcareous clay, and consists of soft, organic clay overlain by gray sand. The Holocene deposits are composed of clayey to silty sand and soft organic-rich clay. The artificial fill, which was placed at the site to create dry land where salt marsh existed previously, is composed of sand, silt, and various scrap materials. The shallow hydrogeology of the National Park Service property overlying the Ashley Formation can be subdivided into two sandy aquifers separated by a leaky, black, organic-rich clay. The unconfined upper surficial aquifer is primarily artificial fill. The lower surficial aquifer consists of the Wando sand unit and is confined by the leaky organic-rich clay. Aquifer tests performed on the wells screened in these aquifers resulted in hydraulic conductivities from 0.1 to 10 feet per day for the upper surficial aquifer, and 16 feet per day for the lower surficial aquifer. Vertical hydraulic gradients at the site are typically low. A downward gradient from the upper surficial aquifer to the lower surficial aquifer occurs throughout most of the year. A brick-lined storm-water-drainage archway located in the study area is a conduit for the overflow of seawater into the surficial aquifer during exceptionally high tides. The efficiency of intrinsic bioremediation to reduce contaminant migration in the upper surficial aquifer at the National Park Service site was assessed to determine if, and at what concentrations, contaminants are being transported to the Cooper River. This assessment required incorporating hydrologic, geochemical, microbiologic, and demographic information into a predictive solute-transport model to determine rates of contaminant transport to the Cooper River. The transport of toluene and naphthalene was modeled as a surrogate for the transport of aromatic and other hydrocarbon compounds at the study area. Laboratory estimates of the adsorption coefficients for sediments of the upper surficial aquifer suggest preferential adsorption of naphthalene over toluene. The adsorption coefficient of naphthalene is at least two orders of magnitude greater than that determined for toluene. Laboratory microbial-biodegradation experiments indicate that microorganisms present in the shallow aquifer have the potential to degrade toluene under anaerobic and aerobic conditions, and naphthalene primarily under aerobic conditions. Rates of microbial biodegradation are similar for both compounds under aerobic conditions. Flow-model calibration to the January 1994 water-table surface of the upper surficial aquifer was achieved by specifying appropriate hydrogeologic boundary conditions and using hydraulic conductivity values determined in the field. The brick-lined storm-water drainage archway located in the study area was modeled to account for ground-water discharge through this drain. An exploratory modeling approach was used to evaluate the range of possible solutions that approximate the transport of contaminants to the observed distributions. Approximate toluene solute-transport conditions for January 1994 were estimated using velocity dist

South Carolina↗