Geology topics

Anne Meltzer

Publications and source records attributed to Anne Meltzer.

3 recordsLinked to original sources

USGS2020

Structural control on megathrust rupture and slip behavior: Insights from the 2016 Mw 7.8 Pedernales Ecuador earthquake

The heterogeneous seafloor topography of the Nazca Plate as it enters the Ecuador subduction zone provides an opportunity to document the influence of seafloor roughness on slip behavior and megathrust rupture. The 2016 Mw 7.8 Pedernales Ecuador earthquake was followed by a rich and active postseismic sequence. An internationally coordinated rapid response effort installed a temporary seismic network to densify coastal stations of the permanent Ecuadorian national seismic network. A combination of 82 onshore short and intermediate period and broadband seismic stations and six ocean bottom seismometers recorded the postseismic Pedernales sequence for over a year after the mainshock. A robust earthquake catalog combined with calibrated relocations for a subset of magnitude ≥4 earthquakes shows pronounced spatial and temporal clustering. A range of slip behavior accommodates postseismic deformation including earthquakes, slow slip events, and earthquake swarms. Models of plate coupling and the consistency of earthquake clustering and slip behavior through multiple seismic cycles reveal a segmented subduction zone primarily controlled by subducted seafloor topography, accreted terranes, and inherited structure. The 2016 Pedernales mainshock triggered moderate to strong earthquakes (5 ≤ M ≤ 7) and earthquake swarms north of the mainshock rupture close to the epicenter of the 1906 Mw 8.8 earthquake and in the segment of the subduction zone that ruptured in 1958 in a Mw 7.7 earthquake.

Journal of Geophysical Research: Earth Surface↗

USGS2018

Mw 4.2 Delaware Earthquake of 30 November 2017

The 30 November 2017 Delaware earthquake with magnitude MW 4.2 occurred beneath the northeastern tip of the Delmarva Peninsula near Dover, Delaware. The earthquake and its aftershocks provide an opportunity to evaluate seismicity in a passive margin setting using much improved coverage by high-quality permanent broadband seismometers at regional distance ranges in the central and eastern United States. This is the largest instrumentally recorded earthquake in Delaware and triggered a collaborative rapid-response effort by seismologists at five institutions along the mid-Atlantic. As a result of this effort, eighteen portable seismographs were deployed in the epicentral region within 24 hours of the mainshock. High-quality seismic recordings at over 380 permanent regional broadband seismographic stations in the eastern United States show a remarkably small decrease in amplitude with distance between 800-2000 km. The mainshock focal mechanism shows predominantly strike-slip motion with a significant thrust component. The orientation of the subhorizontal P-axis is consistent with that of earthquakes in the nearby Reading-Lancaster seismic zone in Pennsylvania, but are rotated counter-clockwise about 45º from that of the MW 5.8 Mineral, Virginia earthquake. We detected small aftershocks below the normal event detection threshold by using a waveform cross-correlation detection method. This demonstrated the effectiveness of this approach for earthquake studies and hazard evaluation in the eastern United States. Based on their waveform similarities, repeating earthquakes with magnitudes greater than 1.5 are detected in 2010, 2015, and 2017. While there is a large time interval between events, 5 years and 2.2 years respectively, the events occur within a spatially tight cluster located near the 2017 Dover DE earthquake mainshock.

Delaware↗

USGS2013

The Mw 5.8 Mineral, Virginia, earthquake of August 2011 and aftershock sequence: constraints on earthquake source parameters and fault geometry

The M w 5.8 earthquake of 23 August 2011 (17:51:04 UTC) (moment, M0 5.7×10 17 N·m) occurred near Mineral, Virginia, within the central Virginia seismic zone and was felt by more people than any other earthquake in United States history. The U.S. Geological Survey (USGS) received 148,638 felt reports from 31 states and 4 Canadian provinces. The USGS PAGER system estimates as many as 120,000 people were exposed to shaking intensity levels of IV and greater, with approximately 10,000 exposed to shaking as high as intensity VIII. Both regional and teleseismic moment tensor solutions characterize the earthquake as a northeast‐striking reverse fault that nucleated at a depth of approximately 7±2 km. The distribution of reported macroseismic intensities is roughly ten times the area of a similarly sized earthquake in the western United States (Horton and Williams, 2012). Near‐source and far‐field damage reports, which extend as far away as Washington, D.C., (135 km away) and Baltimore, Maryland, (200 km away) are consistent with an earthquake of this size and depth in the eastern United States (EUS). Within the first few days following the earthquake, several government and academic institutions installed 36 portable seismograph stations in the epicentral region, making this among the best‐recorded aftershock sequences in the EUS. Based on modeling of these data, we provide a detailed description of the source parameters of the mainshock and analysis of the subsequent aftershock sequence for defining the fault geometry, area of rupture, and observations of the aftershock sequence magnitude–frequency and temporal distribution. The observed slope of the magnitude–frequency curve or b‐value for the aftershock sequence is consistent with previous EUS studies (b=0.75), suggesting that most of the accumulated strain was released by the mainshock. The aftershocks define a rupture that extends between approximately 2–8 km in depth and 8–10 km along the strike of the fault plane. Best‐fit modeling of the geometry of the aftershock sequence defines a rupture plane that strikes N36°E and dips to the east‐southeast at 49.5°. Moment tensor solutions of the mainshock and larger aftershocks are consistent with the distribution of aftershock locations, both indicating reverse slip along a northeast–southwest striking southeast‐dipping fault plane.

Virginia↗